Saving a 2012 Lexus ES350 Part 4
24:32
Saving a 2012 Lexus ES350 Part 3
25:33
Saving a 2012 Lexus ES350 Part 2
8:20
Can We Save This 2012 Lexus ES350?
31:55
2017 Ram 3500 Battery Replacement
16:55
Пікірлер
@garywarner827
@garywarner827 10 сағат бұрын
Should of just use plastic bad on intake throat. @ put little hose on any vacuum on intake. Much easier...lol. good job though. I gotta get a smoker
@zabonghaakatujugete8856
@zabonghaakatujugete8856 Күн бұрын
Great video thanks for your helps
@chandrawallace745
@chandrawallace745 2 күн бұрын
I was yelling “driver driver” before your buddy did. I could see what was about to happen!! She’s a beast !! Glad you’ve seen what she’s capable of --& that ain’t nothing !! She’s got a lot more in her.
@DumbDadDuties
@DumbDadDuties 2 күн бұрын
Very similar situations…had a 5500/8500 generator for years. Upgraded to a 12k / 15k about 2 years ago. The new generator runs our 6 ton and our 2 ton heat pumps simultaneously. Installed soft starts on both. Can now run everything in the house. Can’t run the electric dryer and the pool pumps / hot tub all at the same time but often see it pulling 52 amps at 240v. I backfeed the panel and use my main breaker to isolate from the grid. Thx for the video
@perryrose8843
@perryrose8843 3 күн бұрын
Just as the Jeep tipped down into the hole I saw Elvis and Amelia Earhart. Great fun.
@Manuel-i8b4j
@Manuel-i8b4j 5 күн бұрын
Gringo 😂 chicle esta sucio .amigo
@adriandrenalin6716
@adriandrenalin6716 6 күн бұрын
Almost the same thing is happening to me but Im changing the entire strip due to the end latch frame has developed cracks in the plastic cover so if someone pulls hard enogh, the latch frame will break causing the latch to fail.
@workisfun...2438
@workisfun...2438 6 күн бұрын
Have you noticed any difference after the Bank's upgrades? Then after thr recall? Thank you!
@aaronsrose
@aaronsrose 3 күн бұрын
Nothing too significant on either part. Engine has been fine with the banks upgrade. Main reason I did it was to get rid of the grid heater stuff that can break so that's the big benefit to me. And nothing noticable from the recall either other than I think the def gauge was recalibrated. Thanks!
@scotthayes5738
@scotthayes5738 9 күн бұрын
So what is making that tire have more load than the other tires
@Forward10000
@Forward10000 10 күн бұрын
Great video. I like how you give the values for the components. Mine ended up just being the blower was full of lint.I had to do a master reset when I was done.
@scavuman
@scavuman 12 күн бұрын
A persons vehicle going into "Limp Mode" for the reason of low "Emissions Fluid" says how much "They" are trying to "Control" us.
@anastacioaldaco9934
@anastacioaldaco9934 13 күн бұрын
I just installed this intake now I have the code P0299 (turbo underboost) has anyone else experienced this? And if so what was the fix?
@tensixtythreecomics
@tensixtythreecomics 13 күн бұрын
I have the same issue on my 20 tundra. Mine has not fallen off and I think they switched the rivets for plastic screws. I will try the tomorrow
@joekirchner2374
@joekirchner2374 14 күн бұрын
Slick injector tool!! Could it be as simple as a bad shock? Especially if the previous owner was a gutter driver!
@steverose2405
@steverose2405 14 күн бұрын
You might want to roll that back window up and disconnect the motor. If it stopped working, it will stop working again, and probably it will rain shortly. 692 is plenty of miles; don't run your tank dry unless you want to clog your fuel filter.
@Reddog1255
@Reddog1255 14 күн бұрын
I bit the bullet and took it to the dealership for the 30k fluid change and the mechanic said everything fine don’t worry about it so ok I guess i waited until 40k and went to another dealership had all difs fluid and trans changed they charged a huge amount and just sucked the fluid out of the rear diff, nobody seems to know anything
@diane75able
@diane75able 15 күн бұрын
Corporate greed and capitalism.
@joellamoureux7914
@joellamoureux7914 15 күн бұрын
This video really doesnt get you any info about lean code. I does tell ya how to check out a pressire regulator
@oalmikee1234
@oalmikee1234 16 күн бұрын
Thanks again for all your help 😊
@RobynGraham-j5g
@RobynGraham-j5g 17 күн бұрын
Great video! disconnected all hoses and electrical from pump. Cant twist pump or move it in any direction, any advice?
@paulnguyen6120
@paulnguyen6120 17 күн бұрын
What year is your Ram?
@pallie1000
@pallie1000 18 күн бұрын
So if my glow plug glows. And i have propane out of the nozzle. Shouldn’t the manifold warm up before it kicks into limp mode?
@14sgs
@14sgs 18 күн бұрын
Since I only two about 8000 lb trailer...Looks like it might be time to switch to a gasser.
@chandrawallace745
@chandrawallace745 18 күн бұрын
Heck yeah. It also has sway bar disconnects in it. You can disconnect those and have more flex !
@cb253
@cb253 19 күн бұрын
I completely sealed my cab by deleting the one way outflow valves on the back of the cab I am putting equipment back there and cannot afford it to leak. Does AlfaOBD allow you to remove the fresh air option and only use recirculate? Thanks!
@mktransport5801
@mktransport5801 19 күн бұрын
So i've had the same problem, what i've found out after i washed underneath my truck. The next morning it had a service 4x4 light. The problem is that the plastic cover isn't sealed good enough and water gets inside and causes problems. Just reseal the cover with silicone on a new unit. Should last way longer.
@douglasgordon654
@douglasgordon654 19 күн бұрын
Fixed my 97 5.8 by cleaning the K&N air filter and MAF
@joekirchner2374
@joekirchner2374 19 күн бұрын
Cool system
@joekirchner2374
@joekirchner2374 20 күн бұрын
It’ll be interesting to see what you find in the front end!
@aaronsrose
@aaronsrose 19 күн бұрын
Thanks! I'm thinking that the lift changed the caster angle just enough to make it a little unstable. Only way I can imagine to adjust so far is a slightly longer lower arm on the 4 link.
@Snceday1
@Snceday1 20 күн бұрын
Reset pcm after everything
@chandrawallace745
@chandrawallace745 21 күн бұрын
Yep. That would be me. I was the one that put that mount in backwards !! Ha whoops Great job !!!
@helinutz14
@helinutz14 21 күн бұрын
Had the 67A done after having the Nox sensor #2 replaced. I was very concerned it would be a dog after the recall. I was pleasantly surprised on how smooth my 2015 3500 ran. Pulling my 14,000 lb fifth wheel I noticed no change in DEF consumption or less fuel mileage. Nothing negative so far.
@aaronsrose
@aaronsrose 20 күн бұрын
Same experience with me. No discernible changes. Thanks!
@joekirchner2374
@joekirchner2374 21 күн бұрын
Nice work!👍🏻 Glad you survived your trip to hair gel Newsom’s zoo!!
@holden3315
@holden3315 21 күн бұрын
That’s the only belt I’ve ever seen come off that easy..
@TheAplhabeta
@TheAplhabeta 22 күн бұрын
Dodge has one of the smaller egr/emissions reduction systems of the big three so I’m sure it’s something to do with more egr and more fuel/after treatment to get the engine hot
@jonbowles508
@jonbowles508 22 күн бұрын
That was awesome I have the exact same dryer and I'm about to tear apart with confidence😊 thank you😊
@alturaaltura1650
@alturaaltura1650 23 күн бұрын
Hi I like your video.Can you provide me with link to where you got the headlights from Amazon.Thanks
@patrickzawislak2284
@patrickzawislak2284 23 күн бұрын
Where do you find the right blue plastic adapter to fit snug on the valve?
@user-kz1tk7sj9p
@user-kz1tk7sj9p 25 күн бұрын
Over my dead body sick of the tyranny
@javihia21
@javihia21 26 күн бұрын
What was the final quantity you used? I know you started with 6 but the engine was loud and I couldn't hear what you added after.
@darrell6642
@darrell6642 27 күн бұрын
I replaced the entire manifold with the new updated plastic manifold. No problems yet.
@gwillie25
@gwillie25 28 күн бұрын
Awesome thorough video! My father-in-law went through two of these and the second stopped working. This was the fix! Best yet, it was an easy fix with no parts and no expense. Thanks for troubleshooting for all of us!
@genesauter4755
@genesauter4755 29 күн бұрын
Did my 2018 ram 3500 it took over 8 hrs due to the reply hot ass day on the 4th of July 😊😊😊😊😊😊😊
@user-de3tx6po5f
@user-de3tx6po5f 29 күн бұрын
Thank you! Just fixed my Maytag Neptune 2005 dryer with a $27 part from Amazon by myself!! Part on Amazon-Azdele Store- Samsung Dryer Heating Element DC47-00019A. Reviews say the replacement parts go bad annually but this was second time for us and the first replacement last 3 years. Well worth the money. Dryer is super hot again. THANK YOU!!
@BeastModeRZR
@BeastModeRZR 29 күн бұрын
If it ain’t broken why fix it? My 16 runs just fine. No need for me to listen to these Emission Narcissist. Anything that has to do with Emission recalls 💯 Means restrict something more on this engine for The EMISSION People aka tree huggers.
@DaehyukJohnKang
@DaehyukJohnKang Ай бұрын
As far as I know as a native South Korean and a former(and current) Nexen tire user, Nexen tire company only manufactures for PCR tires, which mean only for passenger car tires, not for heavy bus truck ones. So if you want to budget-friendly car and SUV tires, Nexen will be a very nice choise for your buck. I, personally, am using SUV tires(N'Fera Supereme) for my RAV4 and happy about that. Back then I used their N7000 and Roadian tires on my former Tucson SUV. So far no issues at all.
@martys4814
@martys4814 Ай бұрын
Funny how nobody shows the driver side….because they have no clue….wasted time watching the easy side..
@Jeff_Crittendon
@Jeff_Crittendon Ай бұрын
I had replaced rear shoes and drums but had soft pedal, bled them still same. Watched your video, readjusted them and normal pedal now. Thank you so much!
@JR-ht2vy
@JR-ht2vy Ай бұрын
Can you please give me the part number and where you got it? Thanks
@erikgustavo2588
@erikgustavo2588 Ай бұрын
thanks. This video helps me a lot