Better grease that grapple or buying a new pin in a couple of years.

Did you ever figure this out? I am in the same boat trying to decide on the 3025E and 3032E

Cutter has been awesome! Would recommend it to anyone. Highway departments around here use a lot of them and beat the fire out of them. They’re tough. Tractor pulls it great. Most of the stuff we bush hog we can run about 4-5mph. We only bush hog these fields once a year so they get pretty hairy

@@rockinrranch1431 great to hear. I pick up my new Kubota M4D-071 next week and I have been looking at 12’ cutters pretty hard for my business. Bush whacker seems to be a tough unit to beat.

It’s skid steer quick attach.

@@rockinrranch1431 yes that. Thanks. Couldn’t tell from the video. I was like, I swear the come standard on the m7060

www.ebay.com/itm/Remote-Hydraulic-Kit-John-Deere-2-3-4-Series-Tractors-Simple-15-min-install/143499025625?hash=item2169355cd9:g:jPYAAOSwYfdda~AR

That tractor does have heated air intake, it's obvious to me his fuel is solid, and battery is weak.

@@supporterofeverythingyouli6255 sorry, it does not. Go search the parts manual and you will not find a listing for an intake heater. Usually the small tractors came with either a heated intake or glow plugs but not both. Bigger ones do offer both.

Actually a John Deere 25 horse now in the 3025d, I believe in the 3025e too

@@Farmer-zx5in ok typical Deere then never had any problems with my kubota no matter even in polar vortex with -12f with -25 windchill maybe they should reingineer for more battery almost sounds like engine is stopping at TDC compression

And left a hole where the root ball was.

@@John-lu2bp depending on where it is I often do.

L2501 is 16% heavier at 2622 lbs over the 3025E's 2222 lbs but only the wheelbase of the L2501 is only 3.3 inches longer. However, the L2501 does have a longer loader on it which may be why it lifts less weight than the 3025E. And the R4 tire sizes are the exact same on the two. You may have been comparing the 2025R to come up with a 25% small physical size because it definitely wasn't this tractor. Hate that you had a bad price experience. I compare these two because the L2501 is supposedly Kubota's economy tractor. I needed an economy tractor. The treadle pedal is just a personal preference things. Do you have a review video of your tractor? I'd love to check it out.

@@rockinrranch1431 I think weight difference in part has to do with JD aluminum rear end. Some people don't care but weight is so important in tractors. I think why I see so many videos of the 3025e trying to add weight to the rear.. No it was the 3025E I looked at. I think you have to put them side by side to see the size difference . I came up with that 25% just an observations not in spec anywhere just my estimate. I think prices vary so much from area to area. It's small preferences. If I had to.complain about one thing on the Kubota it would be the Pto selector vs the JD which is better. But overall glad I went with it. I don't have a review messicks did. Not same HP but same frames. You can see size difference irrespective of tire similarities Watch "**TUG OF WAR** John Deere 3032E VS. Kubota L3301" on KZfaq kzfaq.info/get/bejne/kJx-pNZpsJywl4U.html

Yea but where JD has all other manufacturers beat on is the smoothies hydraulic system on the market because they pump more fluid threw the pumps than any other tractor. So the end result is smoother operation and more powerful while operating equipment. When you start using equipment there is a notice in power because the JD pull and use equipment a lot better.

I really like it so far! Its a great little tractor!

I love this tractor! The lifting capacity has not been much of an issue except when i have bigger logs at the end of the forks. What have you done to increase the capacity?

I adjusted the psi..it made a huge difference. ..

But when doing that it comes with a certain amount of personal liability. ..basically tractor lifts alot more becomes more tippy u will need more counter lbs..and it probably voids the warranty. .

@@victorgillen2439 How do you increase the PSI?

@@coltknight3945 do you have a 3025E if so what year?

You can call your local Deere dealer and they would be happy to price a package like this for you. I prefer not to post financial info on the internet.

@@rockinrranch1431 .... Letting people know the cost you paid helps everyone while dealing with dealers . All consumers need to stick together and help each other with what they paid so we can get a good deal also. The dealers are laughing at us not sticking together.

Sure thing! What kind of content would you like to see more of?