21 күн бұрын
2 ай бұрын
2 ай бұрын
4 ай бұрын
4 ай бұрын
5 ай бұрын
7 ай бұрын
8 ай бұрын
8 ай бұрын
9 ай бұрын
10 ай бұрын
11 ай бұрын
11 ай бұрын
Жыл бұрын
Жыл бұрын
Жыл бұрын
Жыл бұрын
Жыл бұрын
Пікірлер
@mitchbanner4094 21 күн бұрын
Hey, you utilize what you got to its potential. Damn straight! Mitch Banner Linville NC
@indee105 22 күн бұрын
Brilliant
@mikeklinger1712 22 күн бұрын
I've seen a full sized camper on a flatbed gooseneck trailer before! The guy had his whole business (welder & generator) on with it! He even had room for the toys (grill & ATV)!
@paulcook7888 22 күн бұрын
Nice set up 👍
@joeblow8206 19 күн бұрын
Without the popup
@XxdannyXxable 24 күн бұрын
Can I run a basic on and off switch with one wire and another wire to just interrupt the starter wire without having a relay ?
@ThatllDoEngineering 24 күн бұрын
Yep
@jdff3954 24 күн бұрын
That plate work the grid is the intake air heater-- if it fails, you may see white smoke.
@seigiornimarchello1609 26 күн бұрын
I have wires running to mine. What are they? 1998 Cheyenne
@MarioGarcia-js7bb 28 күн бұрын
How did you get the small coolant line off the one next under the intake elbow and the y bridge
@ThatllDoEngineering 28 күн бұрын
Take a look at this video I did on cleaning the egr. Maybe I show what you’re looking for on there. LBZ Duramax egr removal and cleaning kzfaq.info/get/bejne/gbmUp6SBtsnLnZs.html
@Geesum44 28 күн бұрын
Label your chemicals if not in the original container . Most important
@JaredHickson-lt8zq Ай бұрын
Was this the ultimate fix for the coolant loss? I have a similar slow loss but soft upper rad hose but soot and pressure out the reservoir but only sometimes. Thanks for the video
@ThatllDoEngineering Ай бұрын
It was the fix for me. From what I understand it was either a leaky egr cooler or head gaskets. This was the cheaper fix, glad it wasn’t head gaskets.
@leicmyucous9073 Ай бұрын
i have an old ford i use it as a planter it does not have this either - but i respect good technology that still runs
@bestever602 Ай бұрын
So pin 87 and 86 need to be wired to ground or just left unconnected?
@ThatllDoEngineering Ай бұрын
Both need to be grounded
@bestever602 Ай бұрын
Do you need to buy a relay to add to get the horn to come one or just splice into the horn wire??
@ThatllDoEngineering Ай бұрын
You need the relay because you need to turn the 12v from the the starter wires to a ground signal to the horn.
@LetsGoBrandon_ Ай бұрын
Most appreciated good sir.
@philipthomas5091 Ай бұрын
Anywhere I can find the torque specs for putting the valve back on?
@BruceDavidson-bg5su Ай бұрын
Thanks
@bloodgt3 Ай бұрын
Dude I'm at a impass I've tried ever damn tool I have and I can't get the passenger side front inner bolt, I get a ratchet on it and can't move the damn thing , driving Me nuts !!!!
@ThatllDoEngineering Ай бұрын
Yep, that one sucks to get to. If I remember right, the a/c compressor is in the way of getting to it from the front of the engine. Maybe you could cut/drill a hole in the inner fender to get a straight shot at it?
@satanas1313 2 ай бұрын
Nice video man thank you My truck is the second run green sh#@t box
@unclesnakebite7811 2 ай бұрын
good job!
@filitamayo 2 ай бұрын
Thanks for sharing. Great video. I believe I have to do this to mine . I already changed out both sensors 😢
@user-ki5jt7wf8s 2 ай бұрын
Awesome video!!! Thanks for sharing it
@PeeWeeHenson 2 ай бұрын
HOW BAD DOES IT HAVE TO GET FOR THE CHECK ENGINE LIGHT COMES ON?
@ThatllDoEngineering 2 ай бұрын
Pretty bad I guess, I did the same thing to a friend’s truck because he had an egr code. His didn’t seem much worse than dad’s truck, but it must have been to throw a code.
@StarknightMT_official 2 ай бұрын
Hello, Are you interested in testing our products? We would like to invite you to test the Scratch-resistant Windshield for your 2012 Kawasaki Teryx4 750
@ThatllDoEngineering 2 ай бұрын
I’m interested, I’ve been using a half windshield for a while but interested to see the difference a full windshield makes.
@StarknightMT_official 2 ай бұрын
@@ThatllDoEngineering Hii, thank you. please share your con tact way
@ThatllDoEngineering 2 ай бұрын
@randysullivan5723 2 ай бұрын
If your egr is clogged up your intake ports are just as bad . Pull the heads for good cleaning studs and fresh gaskets along with egr delete .
@novicenova 3 ай бұрын
Could I just use one of the Sea Foam upper intake cleaner cans with straws work? I know it does miracles for gas engines.
@ThatllDoEngineering 3 ай бұрын
I don’t know that it will work as well as a thorough cleaning but I would think it would help clean out some of the mess
@tocagomez1 3 ай бұрын
Do you know if teryx wheels will fit in my can am maverick x3?
@ThatllDoEngineering 3 ай бұрын
The Teryx wheels are 12mm lugs where some of the Can-Ams are 10mm lugs. Other than that the only difference might be back spacing.
@tocagomez1 3 ай бұрын
@ThatllDoEngineering the reason I'm trying to figure out is because my can am don't fit in my toy hauler so I'm trying to buy some cheap wheels I think it can fit
@ThatllDoEngineering 3 ай бұрын
I’ve seen people use golf cart wheels just to get their machine in and out of a trailer, but you might have to drill new holes because they are usually 4x4 bolt pattern where yours is 4 x 137
@KevinMackie-vh7yj 3 ай бұрын
Did the camshaft sensor cured your intermittent starting problems
@ThatllDoEngineering 3 ай бұрын
Yes
@brucesheehe6305 3 ай бұрын
Magic Fingers! Magic Result. I have an LBZ and it is emissions exempt in PA.
@gabrielbz. 3 ай бұрын
were you having pressure in your coolant tank along with the low coolant level? those seem to be the symptoms my truck is having but no noticeable leak
@ThatllDoEngineering 3 ай бұрын
I believe there was a bit of pressure in the tank, but I didn’t think it was more than there should be in a pressurized cooling system
@fabianlechuga4584 3 ай бұрын
I have the same 1999 4.7 Jeep Grand Cherokee SUV and it has the same fault. Did you only change the camshaft sensor or did you also change the crankshaft sensor?
@ThatllDoEngineering 3 ай бұрын
Only the cam sensor, haven’t done the crank sensor but from what I’ve see it’s more difficult to get to.
@empirestateconstructionllc2336 3 ай бұрын
Hi .new subscriber . My 2005 duramax keeps failing emissions in CT. Always passed .im so close to passing acored a 48 and 40nis max allowable ...ive owned the truck fornjust acouple of years..passed twice .i cleaned k&n air filter .changed oil .changee fiel filters .ran a chemical fule system cleaner ... im not much of a diesel guy ..my diesel mechanic buddy said maybe my pcv or egr are dirty ..truck has an MBPR exhaust and a cold air intake i forget the brand... and i realized i havent touchee pcv or egr in 5 years and im a contractor so truck gets worked ...any suggestions and help are GREATLY APPRECIATED THANKYOU Frank .
@ThatllDoEngineering 3 ай бұрын
As you saw in the video the intakes on this truck get pretty clogged with oil and soot. Probably worth your time to clean it. If the veins in your turbo were stuck like mine were it would throw a code. I’ve been using Hot Shots every day treatment in my fuel for a while.
@davelosonczy1537 3 ай бұрын
Good job
@61066clocks 4 ай бұрын
What a mess....this a perfect example as to why it needs to be deleted..I understand some states tie Your hands on it tho..
@GLMracing 4 ай бұрын
I have a 09 LMM and thinkin of just deleting the EGR as long as I get someone to re-program the computer then I'll get better flow without all the gunk buildup in the egr, also I know I'll have to get another intake tube from my K&N filter to the turbo
@ThatllDoEngineering 4 ай бұрын
I’d love to do that but need it for smog
@DM-mm7rs 4 ай бұрын
Awesome video. I have a 2001 Silverado 5.3 and I seen you spliced the yellow cable from the ignition switch. All this was done before it getting to the crank fuse correct?
@ThatllDoEngineering 4 ай бұрын
I’d have to double check if that’s before the crank fuse, but I believe it is.
@jasonburress8201 4 ай бұрын
Thank you so much I have taken mine off cleaned it everything moves smoothly! Then I'll put it back in and drove it for 70 miles then the code came back on😢 is there a way to test to see if the veins have locked up again without removing the turbo.
@ThatllDoEngineering 4 ай бұрын
If you look back at the 9:30 mark in the video you where I pulled the plunger an operated the veins, you can do that with the turbo on the truck. Oil will come out of the turbo so throw a rag under it.
@robertargento5101 5 ай бұрын
Are there any gaskets need to do this?
@ThatllDoEngineering 5 ай бұрын
I didn’t replace any, that’s up to you if your gaskets look bad.
@jimbertsch442 5 ай бұрын
Did it fix the problem???
@ThatllDoEngineering 5 ай бұрын
Yep
@StephenSchlie 5 ай бұрын
Nice thanks for sharing, was just looking for some videos of this place trying to decide where to go to do some wheeling (also in a Teryx) and was surprised to see a video posted today!
@Nelsonelik 5 ай бұрын
👍🥰
@bobbyk6761 5 ай бұрын
mine broke off flush. Ended up having to heat the shaft with propane torch, it softened up and then came out.
@tricksterjt 6 ай бұрын
What dimensions was that camper ? I have a 7x18 car trailer I put my sxs on and I want to do this same setup. But most pop ups I find are way too long.
@ThatllDoEngineering 6 ай бұрын
Trailer is 7’x16”, camper is 8’ long by 6’ wide. Turned sideways it’s barely under the legal limit.
@scottnicholson463 6 ай бұрын
Can you show the inside of the airbox lid? Did you just JB weld the elbow?
@ThatllDoEngineering 6 ай бұрын
Yes I used jb weld on the plastic elbow. I forget what all I used to seal off the tube to under the dash, I believe some aluminum tape was used.
@LvDirtJunky 6 ай бұрын
Turtle wax sanding pad … I’ll be doing this on my 04 in the morning
@natep1661 7 ай бұрын
Not sure where you live, but just delete it. More power, better mpg, engine will last longer. Dang, it's been so long since my engine bay looked like that I almost forgot what it used to look like. If you live in a less free state, purchase a large ultra sonic cleaner. It'll pay for itself.
@user-rp8ls1ow7j 7 ай бұрын
Thank you very much helpful
@slowb4lls1 7 ай бұрын
I had one of those yunk reels laying around but i cudnt for the life of me remember how it’s gotta be routed to all the inside hose piece to spin, so good call on the video man now I don’t gotta go buy another reel for my air line just yet
@recreacionaltelpochapa6122 7 ай бұрын
STANDAR part # ????
@ThatllDoEngineering 7 ай бұрын
PC244
@robp3071 7 ай бұрын
Part number ?
@ThatllDoEngineering 7 ай бұрын
Standard ignition products #PC244
@WorkEstablishment 8 ай бұрын
Make a video of the process! 🙏🏼 i have a 06 chevy
@WorkEstablishment 8 ай бұрын
Where do i put the relay
@ThatllDoEngineering 7 ай бұрын
Under the dash preferably in a place that’s not easily accessible to a person trying to steal your truck