BMW 320 Rear Brake Pads & Discs E90
31:03
Drag racing with Maverick Diagnostics
26:02
One Auto's Home Garage Build
6:19
3 жыл бұрын
Flat Rate Master London Meet Up
10:49
ToolFreak Giveaway Winners
3:10
6 жыл бұрын
I GOT BROKEN INTO!!
4:45
6 жыл бұрын
Nissan Micra Wipers Not Working
21:35
Nissan Note Airbag Light Flashing
25:22
Пікірлер
@betod3113
@betod3113 18 сағат бұрын
Nice review def going to get one 😊
@brendan5954
@brendan5954 Күн бұрын
Thank you couldn't have done it without you. Never tried before . Had no tool for wiper one came off handy other not so. But sprayed WD 40 left overnight. Tip leave nut loose don't take off completely and put wiper position as if changing. Then wiggle while pulling. Worked.. also when clipping new rod to arm I cracked one plastic bit ( but still fine ) maybe use cloth or something when pressing. Also just check u have clipped on as I didn't do one right si fell off when put in car. But just took all out again clipped on heard snap ,put all back again Happy days. I when putting wipers back no harm putting towel or something on windscreen in case wiper snaps down again wiper on then nut loose then lay on windscreen . Thanks again ..
@theredfrost
@theredfrost 2 күн бұрын
Would an old fuel filter make my engine malfunctioning warning come on when I accelerated ?
@trickyfandango
@trickyfandango 2 күн бұрын
Good video & very informative. Gets straight to the point on what to do & not too much KZfaq waffle like some do
@sipper69
@sipper69 5 күн бұрын
You are a hero
@1gazzarobbo
@1gazzarobbo 5 күн бұрын
can i just say this one of the best helpfull videos on youtube ,after much speculation with my daughters corsa mechanics telling me it was top mounts or play in the rack ,10 mins this morning and car is sorted ,thank you so much sir happy days
@aamir4x
@aamir4x 6 күн бұрын
Hello sir I have got Corsa e 1.3 cdti and on turning ac on the rattling noise comes out what should I change ac pulley or all pulley thanks
@MJs-85
@MJs-85 7 күн бұрын
Is there a way to clean condenser without taking off the front bumper?
@99ron30
@99ron30 8 күн бұрын
Is it exactly the same procedure on the 1.8 petrol version?.
@OneAuto
@OneAuto 6 күн бұрын
Yes
@patmaher9435
@patmaher9435 8 күн бұрын
Thanks so much for this, recently inherited my Dad's old E-Class after he passed away, want to keep it on the road as long as I can without paying main dealer prices, videos like yours help keep the car community going.
@Patriot2452
@Patriot2452 9 күн бұрын
What is the typical PSI required to start a car? I guess it would depend on the car? Mine is a ford focus 2007
@bd8512
@bd8512 11 күн бұрын
Thank you very much for this!
@lattangTV
@lattangTV 14 күн бұрын
The rear brake caliper of cr-v mk3(2007~2011) is sold in two types."excluding japan", "fit japan" I wonder what the difference between the two products is. I searched and found that the bolt specification of the caliper mount bracket is different, is the caliper part the same? I asked several places, but none of the sellers gave me a clear answer. What's the difference?
@oliveuk
@oliveuk 16 күн бұрын
Thanks a lot, very informative additional informations as well.
@specialse
@specialse 17 күн бұрын
my Corsa D SXi heater motor works but hardly any heat comes out 🤔
@waficibrahim7888
@waficibrahim7888 18 күн бұрын
I will never buy ford car again, I drive now s max 2012,
@MsRashidm
@MsRashidm 19 күн бұрын
Perfect 👌👌
@MadMickeyMouse
@MadMickeyMouse 20 күн бұрын
Thanks alot for helping out!!! I was helping my friend replacing his left rear handbrake-cable. He has Haynes manual, but there was no mention of how to release the cable with the umbrella-lock under the mid-console. We owe you alot!! <3
@7Supersport7
@7Supersport7 21 күн бұрын
Two points from my experience of doing this. One, there are three similar but different parts available. Two, be careful when fitting the indicator stalk, there is something which works the self cancelling. I missed it and now have do my own cancelling as I can't be bothered to strip it down again.
@davidryan5892
@davidryan5892 22 күн бұрын
As a recent Picasso buyer with a countdown in progress, this has been very helpful indeed. No idea what possessed whoever signed off on that particular design, but at least I know what I’m up against now! Thank you.
@andrzejradek9279
@andrzejradek9279 23 күн бұрын
Ty vm sir😁
@-robster-robster-
@-robster-robster- 23 күн бұрын
Im at mine having a nightmare . Got the tool and it slips up off position under strain. Dont think its ever been done . Going to borrow one of those filter straps from a friend tomorrow. If that fails remove the whole housing to the bench vice to try other methods
@antsmooney869
@antsmooney869 25 күн бұрын
Just had a window regulator ( wire rope ) fail today on my sons 66 plt corsa Sri and came across this video 👌👍 great help I managed to get window out and wedged in for now and I’ll look at replacing regulator later now I’ve seen this video great stuff 💪
@andyjones1601
@andyjones1601 25 күн бұрын
Spot on. Thanks for taking the time to make the video. Super useful when replacing the handbrake release cable.
@woerlaertim9852
@woerlaertim9852 25 күн бұрын
Thanks a lot for this video. I have the 2014 4-th gen. CR-V and it has the same engine like your 3-rd gen. here. I was misleaded by other videos showing the fuel filter under the rear seat... but then I watched your video and I realized it also fits to 2012 - 2014 2.2 i-dtec. And what a great engine it is! After changing the fuel filter runns again smooth like it used to run years ago...
@alexanderschwarz6084
@alexanderschwarz6084 27 күн бұрын
Danke
@kwongyiuyim1486
@kwongyiuyim1486 27 күн бұрын
Daer sir thanks !
@NOROS
@NOROS 28 күн бұрын
You saved my life
@agee7777
@agee7777 Ай бұрын
Where is the fuse for the blowers? Thanks
@ox9218
@ox9218 Ай бұрын
Is this the same for a 2010?
@OneAuto
@OneAuto 29 күн бұрын
Yes
@tomthompson7400
@tomthompson7400 Ай бұрын
how long does this job take from roll in to driving out ,,, roughly of course .
@OneAuto
@OneAuto 29 күн бұрын
3 to 4 hours
@gilladams8895
@gilladams8895 Ай бұрын
Great video. I am about to do it now I know what to do!
@danielpawowski729
@danielpawowski729 Ай бұрын
Great job👍👍
@ianmatterson5632
@ianmatterson5632 Ай бұрын
when using mine i often get promted to connect the vci with a usb cable, i'll see this prompt when doing various job's, for instance when i try to enter into the CAS module.Have you come across this, and if so were you able to gain that access, i attempted to many time with different usb ports on the otofix but always failed to 'get in', can you shed any light on this issue?
@StarRosieStar
@StarRosieStar Ай бұрын
I used this tutorial for a Ford StreetKA (2004) but used RCA instead of AUX - slightly different way of getting to the CD player and a couple other differences i will list below for anyone interested: unplug the lights and power cable when removing radio unit take off the case on the other side (where the white plastic thingy sticks out, that side) few extra screws to get out the CD player as you’re coming from the other side but easy enough to figure out fed cable out the side next to the lamp plug because i’d already put the CD player back in but that last one was on me 😂 i used a RCA to aux cable instead of aux to aux, it was so fiddly soldering two grounds as i had to use the ground right between the L and R audio, used electrical tape to form a barrier between solders once cool so they didn’t bump about,
@frederiklansu270
@frederiklansu270 Ай бұрын
Thanks 👍🏻
@robbopl
@robbopl Ай бұрын
what was the problem with the AC here? How did you diagnose it was the condenser failing?
@petersoakell6950
@petersoakell6950 Ай бұрын
subbed. thanks for knowledge.)))
@robinwells8879
@robinwells8879 Ай бұрын
Thanks for this. Very useful. ❤
@ashtonwright2038
@ashtonwright2038 Ай бұрын
How much should I put in??
@manoelhoffmann
@manoelhoffmann Ай бұрын
Yes. This works! Greetings from Germany. Thank you very much
@ivaylogeorgiev4229
@ivaylogeorgiev4229 Ай бұрын
Thank you :) One of The limit switch was to unsoldered and bendy ! And the hump can not push it
@lukenguyen-killeen7803
@lukenguyen-killeen7803 Ай бұрын
Great video thanks! You talking about putting the logo over Jack’s face reminded me of Monster Inc. where Mike gets the logo over his face on the TV but is still ecstatic he’s on TV.
@Amazingfeet
@Amazingfeet Ай бұрын
Hi just ordered a condenser for ds3 do I need to find specific o rings for the condenser pipes or would o rings from my large selection box work.? Also what is the oil called is it pag.? Thanks
@davidpardy
@davidpardy Ай бұрын
Thanks!
@mrrana6368
@mrrana6368 Ай бұрын
Hello how are you? Actually I did top up my able water but still show me worming light to top up a blue now show me 1300miles then 1did anther one so now 2 5lt bag I did top up but still show me to top up adblue 1300ml . Please tell me what I can do now thanks
@OneAuto
@OneAuto Ай бұрын
Get it to a garage. It has a problem that needs to be diagnosed
@Denis-fn5pw
@Denis-fn5pw Ай бұрын
Дякую, спробую зробити.
@JacquesOozy
@JacquesOozy Ай бұрын
Could it just happen on very hot days too? I've had a weird issue with my A/C not working when the sun is insanely hot, but it works okay on colder days.
@OneAuto
@OneAuto Ай бұрын
Try tapping the relay on a hot day
@4sk3w
@4sk3w Ай бұрын
lifesaver! just got back from my garage saying they needed to do additional investigation work on my Civic to fix my A/C issue. They spoke about the clutch not spinning, this corresponded with your video, went out gave the relay a tap. FIXED! 6 years later you've just saved me hours of time and money
@OneAuto
@OneAuto Ай бұрын
Excellent 👍
@xxdeexx8342
@xxdeexx8342 Ай бұрын
How do you drain the ad blu tank on c4 picasso grande?