Montero Ventures

Пікірлер

@Knucklesfaceup 22 сағат бұрын

Seems ideal, I will mock something similar, thanks for the inspiration. I wonder about any of the metal reacting against contact points with one another (mount - flange - rim) once it has moisture and some time. Any thoughts?

@MonteroVentures 15 сағат бұрын

I don’t see that as being an issue but Time will show. I have 4Rnner wheels so original wheels will require a different size flange.

@itsaboutfam 2 күн бұрын

The light output is plenty and a nice install!

@BattleshipSailorBB63 9 күн бұрын

Nice little addition. I like it.

@BrianLopez4 14 күн бұрын

This was super super detailed and incredibly helpful to me. I have been wanting to make a table but something prefabbed like this looks so incredibly good on your Montero.

@MonteroVentures 13 күн бұрын

@@BrianLopez4 That’s great. Glad it was helpful.

@robbiewhittle9762 18 күн бұрын

No one cares what speaker you bought… show how you took the paneling off

@dmconsultoria1 19 күн бұрын

Nice Setup! Im thinking on change the wheels of my Montero and lift it. What is the offset of your wheels? I think the offset of the original wheels is too inward…

@MonteroVentures 18 күн бұрын

@@dmconsultoria1 Thanks. Those are Toyota 4Runner wheels with +15 offset

@bernardopriolo8383 23 күн бұрын

Great video! Just a question. To let air pockets out I need turn heater at hot position. But the fun should be at max speed as well or need to be off but just heater on to hot position without blowing any air? Thanks

@MonteroVentures 18 күн бұрын

@@bernardopriolo8383 Use the radiator funnel. Turn the heater on to full blast. Rev the engine to 2500 RPM for about 10 seconds a few times. That should help the air bubbles escape.

@bernardopriolo8383 12 күн бұрын

❤

@KenshinAE82 Ай бұрын

How do u check if the fan clutch is bad? I have mine free spin longer after engine off. I have the gen 3 as well but the 3.8L it shoud be the same removal method

@MonteroVentures 29 күн бұрын

Yes, should be the same removal process . The free spin test didn’t really work for me as you saw in a bunch of videos. In my case it was a process of elimination. We made sure the thermostat was working fine (I replaced it with the OEM) in the pot of boiled water, made sure coolant levels were sufficient. Clutch was the next obvious thing left. I also didn’t hear it spinning before so it was probably just free spinning for a while almost causing an overheating incident. Good luck.

@cronologodul Ай бұрын

To which cable did you connect the white and blue cable, which is the turn-on? I have the same car and a Chinese radio with Android and I have no sound... I don't know where to connect the blue and white cable that comes from the adapter! :(( and how do I connect the rca?

@isvisvisv Ай бұрын

You’ll need to splice it with the corresponding wire on your stereo. All wires on my stereo were labeled so I matched them up to the harness. If your is not labeled, see if you can find a pdf manual online. Good luck.

@cronologodul Ай бұрын

@@isvisvisv By the stereo, do you mean the android radio that I am installing? because the blue and white cable is the one that comes from inside the car and I suppose that goes to the stereo... then the part of the white and blue cable that comes from the din adapter that you bought is left in the air because I don't know why. part of the radio goes or what cable it is connected to, I tried to connect it to the blue antenna cable and the speaker makes a super loud sound, I'm too lost

@BeeeHonest Ай бұрын

Wish you could have been more detailed as to how to remove those panels and trims, rather than just speed through the process.

@jg_l Ай бұрын

Hello, I appreciate your video, it is very useful but I have two questions left to resolve. Before removing the accumulator, do you also press the pedal 40 times to release the pressure? and the second question is if you know if this same procedure can be carried out to change the accumulator of the new OEM mitsubishi 4630a012 model, I thank you for your time, greetings from Spain

@isvisvisv Ай бұрын

Hello. Thanks. No need to pump before removing just make sure the ignition is off. It builds pressure when the ignition is on. I think the procedure is the same for the newer accumulator but you may want to confirm with another source. Hope that helps.

@madduck478 Ай бұрын

That's a great idea! We don't sell them in Russia. I'll have to make one myself.

@aegismule13 2 ай бұрын

nice job

@biok2006 2 ай бұрын

Good video! I did that work last week with the same belt.. is the best belt for this car. Btw you dont need to remove the fan to change the belt. But is ok for the viewers 👍

@ibarraparadas2793 2 ай бұрын

hello, do you have spacers on your front wheels?

@MonteroVentures 2 ай бұрын

I do not

@polar_nomad 2 ай бұрын

Thank you for the video!

@cameronbettis9629 2 ай бұрын

That looks really good, what lift and tires are you running? I have an 05

@MonteroVentures 2 ай бұрын

Thanks. 2” lift , Koni shocks and Lovell springs. Tires 33” 285/70/17

@christopherkarnopp4110 3 ай бұрын

What year is your rig?

@MonteroVentures 2 ай бұрын

2002

@christopherkarnopp4110 3 ай бұрын

what happened?

@MonteroVentures 3 ай бұрын

Overheated

@christopherkarnopp4110 3 ай бұрын

Have you considered trimming or removing the rear bumper? The clearance is so bad back there. I am about to buy a 2006 from a family member, 40k miles, barely driven, never off-road. I am looking for inspiration for modifications. I like your front bumper, wheels and tires.

@MonteroVentures 3 ай бұрын

I haven’t. Hasn’t been an issue for me yet. Thanks.

@kwatts90 3 ай бұрын

Thanks for the review I am looking at these lights. Is that other cover solid black (not transparent)? My state requires off-road lights to be covered up

@MonteroVentures 3 ай бұрын

Correct, 2nd set of covers are solid black.

@randykunjbehari4815 3 ай бұрын

Great job and thanks for the video.

@FronkG 3 ай бұрын

Thanks for sharing!

@itsaboutfam 4 ай бұрын

Camp next to a river ... perfect!

@scottkey6187 4 ай бұрын

What year Montero was this?

@MonteroVentures 4 ай бұрын

2002

@lesleybashaw5643 4 ай бұрын

Ohhhh my goodness. I’m going to hell for laughing my a*s off

@Arctaer 4 ай бұрын

So how did you screw it in at the end? The circular design I have can’t screw in like the square Mitsubishi one in the four corners.

@MonteroVentures 4 ай бұрын

I think I used some longer self tapping screws and went it straight into the body.

@user-js9hh2ri7i 4 ай бұрын

Thanks so much for this video. I experience this issue. This will be helpful Curios if you experience intermittent central locking on both passenger and driver side? Locking via remote key doesn’t fully lock the dock, like the latches are stuck of something.

@MonteroVentures 4 ай бұрын

Thanks. No, I haven’t had that issue with the driver or the passenger side. Does that happen when you lock with a key or a lock button?

@user-js9hh2ri7i 4 ай бұрын

@@MonteroVentures it’s intermittent, but usually lock with key. lock with button works all the time

@edenbul6140 5 ай бұрын

Very helpful video. Thank you for sharing. My Pajero’s has same problem. Sometimes handle stucks. Hard to open it. I want to change it, I am wondering why didn’t you buy new one? Should I buy new one or good second hand?

@MonteroVentures 5 ай бұрын

Thanks. I was buying a few things from someone who was parting one out. If you can get your hands on the new one it would be definitely better. Used one will be just fine but will most likely need good amount of cleaning as those get pretty dirty and get stuck. That may be all you need is some cleaning.

@TheNightShirt 5 ай бұрын

Do you really need to keep the backseats?

@MonteroVentures 5 ай бұрын

In my case yes. Just had to remove the platform and deploy the 3rd row yesterday.

@luckysohi6819 5 ай бұрын

Hi what is the vacuum pipes diameter ?

@huntersmith8586 6 ай бұрын

Would you buy those lights again?

@MonteroVentures 6 ай бұрын

Yes I would

@cocinanortenayalgomas1722 6 ай бұрын

Good afternoon, I have a 2016 Montero and the center of the 4*4 turns on when I go faster than 50Km, do you know the part number in this video, for a 2016 Montero or Pajero.

@MonteroVentures 6 ай бұрын

Sorry I don’t

@thecyclegarage8145 6 ай бұрын

Recently bought a montero sport 2011 and noticed 4L going down a hill pops out, any idea what happens?

@MonteroVentures 6 ай бұрын

Not sure, sorry. Check out this video may be helpful: kzfaq.info/get/bejne/d9mBq5acya3Rn3k.htmlsi=RdBNbzIu5jHprIsY More in depth analysis: kzfaq.info/get/bejne/Z7-kmNGUzdO7YYk.htmlsi=m1i67C8aTQfVAZKd

@itsaboutfam 6 ай бұрын

Looks great!!

@itsaboutfam 6 ай бұрын

Those are some beautiful views!!

@dm1273 6 ай бұрын

Bed дуже погане виконання

@nalong55 6 ай бұрын

These videos are helpful! where are you located? I'm over here in Renton

@robbiecryer 7 ай бұрын

Thanks for sharing 👍😎

@nathansmith9332 7 ай бұрын

No more flashing diff light?

@MonteroVentures 7 ай бұрын

No more

@MOATAZ_IBRAHIM 7 ай бұрын

i have vibration while idling changed gear and engine mounts suspension, oils, filters, all the pushes , spark, etc and still have the same issue any suggestions ?

@rogertiamzon7718 7 ай бұрын

Hello guys what size your tires n rim thank you

@MonteroVentures 7 ай бұрын

285/70/17

@rezosful2072 6 ай бұрын

Can pajero fit it without lift? Thanks

@MonteroVentures 6 ай бұрын

@@rezosful2072 it can with some modifications shown in the video.

@harwoods11 8 ай бұрын

Nice tip to turn the 4 way fitting round 😀

@kouch4n 8 ай бұрын

👍️👍️👍️

@louischoi2883 8 ай бұрын

Can I have the dimensions of the plywood?

@MonteroVentures 8 ай бұрын

Size chart: Main leaf: 30 1/4” x 46” Fold outs: x2 : 17 1/2” x 46 Supports: 11 1/2”

@biok2006 8 ай бұрын

I like it But I don't have the balls to cut that!😬, for now with mastercraft 265/75/16 I'm fine! good job. 👍 I have the same car! It is the best truck I ever owned and I am not going to sell it.

@MonteroVentures 8 ай бұрын

Thanks.

@biok2006 8 ай бұрын

@@MonteroVenturesOne question! Do you have the speed wheels display function? It is the one that shows the 4 wheels with bars and indicates the speed of each wheel. I have it but it has never worked. You know what I mean? greetings

@MonteroVentures 8 ай бұрын

@@biok2006 no , I don’t have such function

@mitcrex 8 ай бұрын

Lol it says red liner on the bottle

@piensoyexisto 9 ай бұрын

Excelent I Will copy is exactly what I want.

@MonteroVentures 8 ай бұрын

Size chart: Main leaf: 30 1/4” x 46” Fold outs: x2 : 17 1/2” x 46 Supports: 11 1/2”

@rmv2234 9 ай бұрын

can u tell us the exact tire size for your 33's

@MonteroVentures 9 ай бұрын

Sure: 285/70/17

@pnoylv3680 9 ай бұрын

Beautiful Montero! Where did you buy the bumper and what lift you are using?

@bc4198 9 ай бұрын

It's an ARB Bull Bar, which are widely available. The channel has an install video, but I didn't catch it they say specifically where they got it.

@MonteroVentures 9 ай бұрын

Thanks. Bumper was a facebook market deal. I heard ARB stopped making those for this model so they are becoming harder to find. Lift: Lovells springs 2” lift with Koni shocks.

@henrymarroquin3176 9 ай бұрын

Hello friend, does the subwoofer work with that radio?

@MonteroVentures 9 ай бұрын

Yes, It does. I have another video replacing the blown subwoofer.

Ең жақсы KZfaq

Пікірлер