can a stuck crank pulley make it seem like the engine is seized?

Great video. Got a video for the front? Thanks

Im guessing you've driven around for some time now, how are the connections holding up?

i did the same thing to my 2014, replaced the 125amp sand fuse with a bussman 150 while i wait for another sand filled fuse to be shipped. couldnt find the correct one locally.

thx for the good vid. hope it will work the same way as my Sebring 2.7 from 2003. maybe you know? greetz

Thanks for posting this.

Another option is holding the base of the bolt with some small pliers/needle necks, getting it in through the pickup tube hole and then supporting it with a 90 degree pick while you thread it in with the pliers using them as a wrench. Took me a hour to figure out after extensively fucking w the oil pump, but it worked for me

Thanks so much bro this just helped me out a lot I was doing all this research shoulda went to KZfaq first what was I thinking reading lol

What’s the size of the hose you bought?

it the pigtails that go to the injectors there old and cracked from audi running everything at 220

What was wrong with the pump??

GREAT

Finally the tutorial we’ve been waiting for: how to change the light on your rickshaw. Thank you

Hola saludos muy bien video , tengo un Mercedes e320 una pregunta la batería auxiliar debería recibir cargar si la mido con un multímetro con el vehículo encendido debería dsr 14.20

All that work just to put in a car quest alternator

Great video guy

Bro the knock is the piston 👀👀

How much is the labor this job.

It's cool!!! How long it will working?

thank you i need to do this for my sisters jeep next week. not looking forward to it lol i wish they would just put it at the top of the engine bay

Replaced three times on my 96 ram.

I've replaced several on ford's that sounded awful...but the..n I saw this one was on a jeep . But was it a jeep they constantly thru salt water??

Thank you for the video. I will not be buying this car.

Too bad you didnt show how you got the broken piece out. Cause that’s where I’m at 😔

The suspension didn't raise if the door is open brother! I will try to disassembly my compressor, thanks.

Thanks mate

I try to do this today i could get bottom bolt back on or take off the pigtail im like wtf is going on i gave up call someone smh

I would did a compression test on all cylinders if 2 and 4 were misfiring

Can you pull the pickup tube out once the pump is off?

How much does it cost if i replace it at the mechanic shop ...?

Take the intake off, guaranteed the intake valves are caked with buildup.

Yeah man swap out the fuel inj and see what happens!

Good luck

Help can't get the alternator out like you did

Can't get out of it's position

Great video! Thank you. I also have the P0128 code on my 2017 XT5. The steering wheel assistance is reduced, the engine fan is on full blast, the auto-stop function is lost, the water gauge is at the bottom, and there's no AC. My question is, how did you determine that only the coolant sensor needed to be changed? Why didn't you change the thermostat housing as well?

I was told to keep fuel tank near full it keeps the pump cool if you run tank to low it can over heat the pump 😮

Make sure to run it up to about sixty psi...

Where are you located maybe I can pay you to do it for me lol

I am trying to find a correct rad cap Most std ones reach down 16 mm but this Sorento needs to reach down 20mm + to pressure seal Kia dealer has special orded one - We will see tomorrow

Thanks bro this vid help me out

those trucks aint nothing but a head ace best to get rid of it.

No, I'm out....out of my comfort zone. Thank you for the video though

And I used a snap on impact socket on it with my air compressed

I found out today it you just heat the boat in will spin right out

Did you evac all the freon before removing the compressor ?

A Dewalt 1/2" battery powered impact with 1000 pounds of torque will take that bolt off with no problem. Don't forget to use the weighted socket that is made for that bolt, or you'll never get off.

Thanks man

Tienes que cerrar la puerta para que suba la suspensión

I never knew they made that but thanks for posting this you might have just saved my ass