Kindly like,share and also subscribe.thank you

Hydraulic oil #68

Sundan nyo lang Yong opposite n butas ng lagayan ng blade.makikita nyo po yan kong ilagay n ninyo Yong blade.karamihan apat-apat.

Thanks 👍

Manual po ba or Matic Yong tractor nyo?

Manual po b Yan or automatic.kpg matic,check nyo wiring.

Simplex Caloocan 5th ave.

,25

Kindly share and like

Baklasin mo sir baka my damage na ang gear.

Kindly share and like.thank you

Palit k ng o ring sa palaka sir

Pasinaya sir hindi na matandaan .per sample ko lang pinabili

@@tractorsmarinemechanic salamat po sa pag reply idol.

Kindly share ,like and subscribe.thank you for watching

Palitan mo feed pump

There are lot of model and its easy for me to bleed.,..thank you for your comments and watching

#90

Yes air

Buksan mo Ang valve Dyan may tapat ng upuan mo kc sarado cguro

Part#AQ7747E.sa shoppe meron Yan sir kpg nag order k.

Ok boss salamat

Boss anong size po Yong cross join ng 2402

Kahit po vedio boss alam kuna rin mag kalas ng mga Axel kahit wala akung experience sa mikaneko salamat boss

Boss Yong size po ng cross join ng 2402

Yes sir... possible

What kind of tractors or engines do you have?if your injection pump is like this...the fuel is coming from the feed pump or if does not have a feed pump.ypur pump housing is need to replaced a new one.

@@tractorsmarinemechanic its a Shibaura S753 engine. The pump out for repairs and as yet I don't know that its leaking down the sleeves or not I just wanted to ask the question. The shut off rail was seized on full, showed signs of minute rust but I now have that working again. I am fitting new O rings tomorrow to the outlet fittings the old ones are stuffed. I did have it working for several manual pushes on each plunger but then it stopped pumping again and thats when I noticed the air coming from the O rings. As a passing point it wouldn't start, at all, but after coaxing it I did get it going but then it wouldn't shut off, I had to choke the engine at the intake, you couldn't see the yard for blue and white smoke. One injector was running at full noise it had become disconnected from the shut off rail and was jammed on full. They were miles out of singing from the same song sheet.

I think plunger was not properly installed

Dismantle your pump and installed again the plunger in the right position

@@tractorsmarinemechanic it was doing that when I bought it not after I took it to bits, its still apart for a few more days as I have other work to do.

None

I'm sorry...this channel is only to show for those who wanted to see or learn about some mechanical works. I'm not obliged someone or anyone to learn from it.thank you for your time, watching and for your very good comment.

@@tractorsmarinemechanic all good chief, I am just working on one for an S753 Shibaura engine. Looks like it needs new O rings at the top of the pump. No website mentioned to replace them. I found they leaked after putting a reverse flow of air through them.

@treegrower1 kzfaq.infoDlAKByqmaHg?feature=share

@@tractorsmarinemechanic thats exactly where we are now, can't get new O rings until tomorrow.

None