What size large bolt did you use?

absolute garbage

Thank you for the good presentation.

I even buy calculator and watch other videos and still didn’t get it but with this video is easy 😊

Sorry..waste of time. But great for the 1970s

Good job

I just rather run emt and run connection into my sub panel dedicated 15amp breaker, but good job 👏 bro

🎉 good teacher

Great video . Thank you

watched this at 2x speed

Take a shot every time he says JOIST. You will have a good time

Thank you so much!! This is what I was looking for. You answered my question about using 2" pipe and a shop vacuum!! Cheers 🍻

When clearing a jam, that funny shaped piece fell out. I'm in Kingston NY and no one would work on a nail gun. The manual was no help but your video helped me put the trigger mechanism back in place in 15 minutes. Thanks, dude.

This is spot on. I went from scared to remove the plastic tip to back working. Thank you.

You're not sure why they have a channel 3 on a Lc7i??????? Its for the sub amp

Made it really confuses when you started subtracting the thicknesses of the ridge board

How do you protect the corner? Thanks.

This is one of the most complete and detailed dust collection setups I've ever seen. Well done!

Damn, I didn't realize how difficult putting hinges on a box could be.

A good teacher makes easy

Thanks for the help

That's a really pretty color of pale blue.

The bottom line on these is that they are a poor design. You will get well practiced at un-jamming them as they do it all the time! Tools that perform two functions are not necessarily a good idea. There is compromise somewhere!

19:46

Craftsmen vacs are made by Shop-Vac. Shop-Vac makes like 75% of the other brands out there..

Great work, thank you!

Don’t you have to account for the ridge board width in the calculations

Does this mean the shop vac system didnt keep up?

Gracias a se me subió el muerto, di con tu canal, muy entretenido. Gracias Flakita. 👍

Do you have a problem with your blast gates, the groves getting saw dust in it and not being able to close it properly?

Does there need to be a good seal on the trash can? I thought if it had a bad seal it would affect the suction.

Dude…you’re a life saver. Turned this into a 5 minute problem for me. Thanks for posting this.

This was very well explained. Do you have a cut list?

❤❤❤

Can you help me?

Im going to put an alarm on my horn 😂ty sir

Thank you G.

Great job very concise you save me some time

a joy to watch and has given me an idea for my grandson's bed for when visiting. A Merry Christmas to you all

show de bola.

Nice setup. I have a very small shop and I have been looking at how to make a similar one for my lathe. Thank you for sharing this.

Cool vid and a very polite/friendly/genuine comments section. Good job guys, a very rare thing in what is usually a toxic swamp

Very good job man!! thnxs!!

❤❤❤❤

This guy is amazing!! Never really see step by step instructions broke down like this GREAT JOB

Need advice on ceiling fans

If a outdoor fan is exposed to power washing water would this harm fan.

Unable to get arbor bolt all the way out to change blade

I don’t have my gun with me but it would just expel air when I pulled the trigger. Does that mean it’s jammed or something else? Thx

Ur an awesome teacher bro. Thank you for making it easy.