6 ай бұрын
7 ай бұрын
7 ай бұрын
Жыл бұрын
Жыл бұрын
Жыл бұрын
Жыл бұрын
Жыл бұрын
Жыл бұрын
Жыл бұрын
Жыл бұрын
Пікірлер
@alwartLweiss 15 күн бұрын
Dindt you placed the o-ring gasket on the filter? I couldnt see u did?
@user-jv4qk6wo5l 18 күн бұрын
Salamat sa New idea ka ulojeck, marami na nman aki natutunan syo .
@KUYA-NATO_TOYZ4DBIGBOYZ 20 күн бұрын
nice bro.may idea na ako
@KUYA-NATO_TOYZ4DBIGBOYZ 20 күн бұрын
yun valvoline atf puede din ba yan sa 2012 model
@KUYA-NATO_TOYZ4DBIGBOYZ 20 күн бұрын
nice bro may mazda 5 din ako 2012 saan ka pala banda dito sa quebec
@GreenmanWood 2 ай бұрын
Maraming salamat!
@alexk7837 3 ай бұрын
This valve comes with gaskets. Don’t see you installing those (or removing)…
@youtupe80 3 ай бұрын
no how did you put the new stud why skipp that part?
@BrokeAgain 3 ай бұрын
ano un ulojeck? pero salamat sa video!
@hmsmedia2005 4 ай бұрын
Can you do it in English Panoy? Or redo the video with better videography please.
@hmsmedia2005 4 ай бұрын
Good try..
@jaimeaguilar924 4 ай бұрын
Se ve muy obscuro 😞
@christianlinan2420 6 ай бұрын
Paano mo inayos boss?
@michaeldarrow6021 7 ай бұрын
Didn't understand a single thing you said 😡 Wasted my time
@EverGone03 10 ай бұрын
what's the wide distance at the middle seats? (distance from sliding door to sliding door, lets say 12 in above floor)
@cadcamcreations 10 ай бұрын
I've got this problem, battery OK, Ignition switch OK, I have noticed the lead copper strip that connects to the fuse box has a lot of dirt accumulated on and that's my next thing to look at, the symptoms are so much like a bad earth but I've checked that.
@naskobilev8229 10 ай бұрын
👍👍👍👍👍
@naskobilev8229 10 ай бұрын
👍👍👍👍👍
@naskobilev8229 10 ай бұрын
There was also a small rubber ring in the filter set, what is it for ???
@naskobilev8229 10 ай бұрын
👍👍👍👍👍
@naskobilev8229 10 ай бұрын
👍👍👍👍👍
@user-jv4qk6wo5l 11 ай бұрын
Malaking tulong ang video mo marami kami natutunan
@ulojeckph 11 ай бұрын
Ayuss...Mabuhay ka ,....ka ulojeck
@user-jv4qk6wo5l 11 ай бұрын
Malaking tulong ang video mo marami kami natutunan
@user-jv4qk6wo5l 11 ай бұрын
Malaking tulong ang video mo marami kami natutunan
@ulojeckph 11 ай бұрын
Ayuss...Salamat at napansin mo ang mga video ko mabuhay ka kaulojeck..
@user-jv4qk6wo5l 11 ай бұрын
Salamat Boss ganyan din ang Car ko Mazda 2007 model .
@ulojeckph 11 ай бұрын
Salamat din at Kung meron trouble ka sa mazda watch kalang ng ulojeck channel ...same car din tayo ...cheer !!!
@user-jv4qk6wo5l 11 ай бұрын
Ka ulojeck chain drive ba o belt ang mazda 2007 model
@ulojeckph 11 ай бұрын
@@user-jv4qk6wo5l chain drive boss Hagod sa hatak ang lupet...
@aaronluces Жыл бұрын
Hello Boss! Mazda5 owner din po ako. Na experience nyo na po ba yung kumakabig sa kanan from full stop? Kakapalit ko lang ng preno. May idea po kaya kayo? Thank you!
@ulojeckph Жыл бұрын
Hi kmusta po kayo?... Check mo yun passenger side sa harapan kung may tagas o basa ng oil yun strut shock mo. Or pwede din uneven ang rotor mo sa harap palitan mo ng bago kasabay ng new brake pad ..sana nakatulong syo Salamat.
@nickygarcia9674 Жыл бұрын
Boss, napapansin mo ba matakw sa langis ang mazda 5 kahit walang tagas?
@ulojeckph Жыл бұрын
Hindi naman kaibigan basta laging tama sa sukat ng langis mo sa Mazda. Matagal na sa akin ang sasakyan ko 15 years hindi naman sya kumakain ng langis. Basta alaga mo lang sa pag check every month saka normal naman na nababawasan ang oil sa engine kasi nga mainit ang makina. Good luck
@nickygarcia9674 10 ай бұрын
@@ulojeckph wala namang ako makitang tagas ng langis o white smoke pero pag nag check ako ng dipstick ang baba lagi kahit kak top up ko lang. ok ba maglagay ng engine additive? salamat boss, saUK nga pala ako at mazda5 sport series 2.0 un akin 2009 model
@DangMlay Жыл бұрын
Mazda 5 CR19 year 2007 its rear suspension is a disaster, I have a problem of clicking and creaking, I changed the 3 suspension arms, the ball joints, the shock absorber, the shock absorber support, the pad and the shock absorber ring, only the spring that I did not change, but there is still the cloccloc and the squeaking, do not buy Mazda 5
@ulojeckph Жыл бұрын
My friend, check the spring holder. That may cause clicking sounds. I experienced the same problem on my Mazda 5, and I changed shock absorber and still make sounds. Then I figured out the noise is coming from the spring holder. Good luck
@pattdcruz8917 Жыл бұрын
What Year Is your car?? GEN 1 OR GEN 2??
@ulojeckph Жыл бұрын
Mazda 5 2008
@wsciekyspawacz6215 Жыл бұрын
Widzę że macie u was w markecie doskonały wybór narzędzi w całkiem przyzwoitych cenach.Pozdrawiam z Polski.
@ale_man757 Жыл бұрын
Very good explained video!
@ale_man757 Жыл бұрын
Did you change the brake fluid after this?
@ulojeckph Жыл бұрын
Yes of course after I installed the caliper completely
@Thatdavemarsh Ай бұрын
Thanks!
@gregwharton1289 Жыл бұрын
I can't understand him. I speak English
@ulojeckph Жыл бұрын
Hindi ko siya maintindihan. Nagsasalita ako ng Tagalog
@duplo. Жыл бұрын
In the filter middle is a screw. Unscrew first to let the oil out then remove the cartridge. Well done bro
@terrycopeland1804 Жыл бұрын
We have a 2009 Mazda 5 and it has the same problem. They put the lock actuator right under the slide groove for the rear doors and all the water from outside goes right into the lock causing it to freeze. If this happens you need to take a hair dryer and blow the hot air into the groove at the door edge going to the lock actuator for 5 or 10 minutes to thaw it and then it will start working again. When I go to the car wash I take 2 shop towels or rags and push them into the groove, leaving enough to pull them back out after washing the car to avoid freezing locks. 2-(6x6 or 8x8 rags), these definitely are not a good cold climate car.
@ulojeckph Жыл бұрын
For my Mazda 5, extreme cold was the issue and not ice. That's why I used a bungee to temporarily close it until I reached home. I used a hot blower and it worked! Thank for your comment :)
@ryanmaratas9087 Жыл бұрын
pinahirapan mo yung sarili mo pwede mo naman tanggalin yung caliper para madali mo matanggal yung hose maibalik
@stanleymakausi5201 Жыл бұрын
How did the bolt get there
@qcherry5026 Жыл бұрын
This is for diesel?
@ulojeckph 11 ай бұрын
Gas type bro..
@mohamedsaleh1543 Жыл бұрын
😂😂😂
@mendelsimpauco1304 Жыл бұрын
May gusto ako bilin na mazda5. Matubay ba? Sirain ba? Mahirap ba parts ? Taga dto po ako sa calgary
@ulojeckph Жыл бұрын
Hi kmusta ka dyan fren,,,I could say yes matibay at maraming parts na avail sa online like RockAuto.Com at AutoShack at meron din sa Canadian Tire at sa autoparts near you ..hindi sya sirain kung laging on time ang pag change fresh engine oil mo in every 5 k to maintaining the engine in good smooth running condition ..at take note meron ka narin Video guide sa repair ng Mazda 5 if in case na nagka problema ka ...ehheheh thanks sa Good Comment.
@mendelsimpauco1304 Жыл бұрын
@@ulojeckph thanks boss. Your the best.
@mendelsimpauco1304 Жыл бұрын
Boss nice videos. Pwede ba mag tanong?
@mikes.582 Жыл бұрын
Kapag hindi putol madali ba matanggal ?
@ulojeckph Жыл бұрын
Hello... Mike S kmusta thanks for watching my KZfaq Channel...oo nman madaling matanggal kahit di putol ang stud..basta gamitan mo lang ng martilyo at tapos dukutin mo nalang sa likod ng wheel hub ..Ang pagbalik nman ng stud ilusot mo sa butas kailangan mo ng mga big washer and nut na maluwag sa stud at tapos ilagay mo un original na turnilyo ng stud para humigpit hanggang lumapat ang head ng stud sa wheel hub pero dapat naka handbreak ka para di ikot ng ikot ang wheel hub...thanks ka ulojeck sana naging useful tong video ito syo..
@carlegleason1383 Жыл бұрын
Fantastic and quick thank you
@elisabethsanchez6420 Жыл бұрын
Hope y’all can give me some helpful information. I know it’s not NB Miata but it’s almost the same car? 🫡. I’m having trouble with my 2006 Miata with 113k miles on it and the car turns on but won’t stay on, turns off 3-4 seconds later. I’ve done a couple things to the car as far as changing the spark plugs, oil change, all fluid changes, coolant reservoir tank change. The car has no leaks and the drives were always good with no struggles and no odd noises. I also checked the fuel pump and its fine as well and cleaned the throttle body and it keeps doing the same thing. The car doesn’t throw me a code either. Please give me suggestions if any, Thank You! 🙏🏼
@ulojeckph Жыл бұрын
Hello, kindly check the battery terminals; it might have been loosened or corroded. Then, try checking the wiring ground; maybe it's rusted and there is no contact to the body. And check all vacuum lines individually. Hope this helps :)
@lenmamaid9959 Жыл бұрын
You did not show how you were able to release and lossened that hidden bolt on the EGR? Your video only shows it was already loose and you’re removing it very easily with your hand! magic?
@chrisbradley1192 7 ай бұрын
At 4:50 he's loosening it. First removing the solenoid (4 screws) from the EGR valve gives access from above with a socket.
@Septy7777 Жыл бұрын
if the title of your video is in english you should speack in english otherwise you create a huge confusion.
@jadenmatt560 Жыл бұрын
It’s really frustrating 🤦🏾♂️
@paigeb1318 Жыл бұрын
(cue music...) What's up, everybody? It's Tyler here from Zeducation...🤣
@kuyagatong5793 Жыл бұрын
Boss baka pwede naman yung H7 replacement salamat
@ulojeckph Жыл бұрын
Hi kumusta kaulojeck, Depende kung magmamatch yun haba at butas ...subukan mo pero kailangan mo ng dawala sa likod para balance ang galaw at walang kabig sa kaliwa o kanan....i think mas ok yun parts na recommended ....para di masyasdong magastos kaulojeck thanks for comment.
@sanBastian123 Жыл бұрын
can you do the same procedure on front wheels?
@ulojeckph Жыл бұрын
Yes...why not. u can slide the stud at the back of wheel hub as long as u find space and put it on easily...
@ulojeckph Жыл бұрын
🥶🥶🥶GGGGRRRRRHHHH LAAAMIG