Thank you very much! You saved me a lot time, and gave me confidence to remove it myself for tow bar install! Big respect! 👍👏
@lowenergydevicesptyltd22542 күн бұрын
Very good shows you so clearly. I would keep an eye on his videos
@BumperdoorDIY2 күн бұрын
Thank you
@rja97843 күн бұрын
Can you bumboclot in your next video?
@BumperdoorDIY2 күн бұрын
😂😂😂😂I tried to keep it clean for the KZfaq algaredim
@Flav_cars3 күн бұрын
I have question can we swap front bumper Mercedes gl 2007 to gl 2012 ?
@BumperdoorDIY2 күн бұрын
No it won’t fit
@steveberkstresser70793 күн бұрын
Is this the same process for the lincoln aviator?
@BumperdoorDIY2 күн бұрын
I don’t know exactly
@Chrissy10113 күн бұрын
Great video! Could you please show us how to remove the front fenders? Do we need to remove the front bumper to change the fenders? Thanks
@BumperdoorDIY3 күн бұрын
Yes sir you have to remove the bumper and headlight in order to move the fender and I do not have a video on how to remove the fender
@s3ptmbr3 күн бұрын
Does anyone know if you need to remove the whole bumper to remove The silver trim pieces on the side or can they unclip without doing this ?
@BumperdoorDIY3 күн бұрын
You have to remove the hole bumper because that silver piece is screw down in the back
@s3ptmbr3 күн бұрын
@@BumperdoorDIY thanks bro
@perezjorgie4 күн бұрын
Can you do a vid on replacement of passenger side mirror assembly pls 2020 mazda 3 sedan can't find it anywhere
@BumperdoorDIY3 күн бұрын
Whenever one comes in
@SammStrom4 күн бұрын
Are the painted side panels attached to the black plastic part of the bumper? I only have damage to plastic piece and want to make sure I order the correct part.
@BumperdoorDIY3 күн бұрын
Yes it comes apart
@danhenninger14 күн бұрын
Now do one putting the clips back in
@BumperdoorDIY3 күн бұрын
Just reverse the process
@887117884 күн бұрын
you have to take this off to get to the air ambient sensor also the only way to unplug it is in the back, You need a little screwdriver to unclip the sensor .
@BumperdoorDIY4 күн бұрын
Yes sir
@konradhodyra95405 күн бұрын
Great material. Thank you very much for your great job.
@BumperdoorDIY4 күн бұрын
Glad you enjoyed it!
@konradhodyra95405 күн бұрын
Well done. Everything explained thoroughly.
@BumperdoorDIY4 күн бұрын
Thank you
@dewaynemurray33835 күн бұрын
YOW Bassy, respect yute caa mi flash this out way faster than mi expect. I can see that you know what you doing. Yu ting tall yute, may Jesus bless you for the work you put in.
@BumperdoorDIY4 күн бұрын
Yeah man nuff respect me general bless up 🙏🏾
@chrissalgado62595 күн бұрын
Questions y just stat to learning body work, my questions is how do you repair BMW when is aluminum, I can fix the normals but not aluminum
@BumperdoorDIY5 күн бұрын
repair aluminum is on a different level and you have to take classes to learn about the metal
@chrissalgado62595 күн бұрын
@@BumperdoorDIY now y just im learning practicing
@carlosaugustosanchezperez44565 күн бұрын
I have a 2020 GT Line and I want to know if I can put the 2022 front on it?
@BumperdoorDIY5 күн бұрын
I honestly cannot tell you because I never tried it
@elvinvazquez40575 күн бұрын
How to put a front plate on Hyundai
@shakenbakedrake6 күн бұрын
Oh my God i think i love u. Got stick on the taillights. If banfing them works+ ill let u know... Fingers crossed 🤞
@BumperdoorDIY5 күн бұрын
😂😂you got this
@fransb85436 күн бұрын
Once again, just what I needed to see. Thanks so much dude, you're really providing a great service here.
@BumperdoorDIY5 күн бұрын
Glad I could help men you’re welcome
@Lion_Rey6 күн бұрын
First time seeing one with the filter at the bottom
@BumperdoorDIY6 күн бұрын
Yeah they out there
@yoelescobar90726 күн бұрын
Saved my life and my family’s life thanks man
@BumperdoorDIY6 күн бұрын
You welcome big man and nuff respect yo zeme 🙏🏾
@bkc97086 күн бұрын
Thank you Sir. Subscribed.. question. I am planning replace entire damaged right rear passenger door myself.How easy is it to move all parts from damaged door to new door shell?. I have a 2024 Honda crv ex-l. Thanks
@BumperdoorDIY6 күн бұрын
Well nothing is really easy until you do it couple of times, just take your time until the job is finished, if you could sit down and watch a 3 hour Netflix movie am sure you could take 3 hours and take that door apart right. Just take your time
@MrCodyroscoe7 күн бұрын
Would a 2022 z71 front clip fit a 2022 premier? It’s a suburban
@BumperdoorDIY6 күн бұрын
I actually can’t answer that question because I never tried it and I never seen anyone who have done it before
@Flav_cars7 күн бұрын
hello I have a question I want to know if I can put the mercedes gl 2012 phase 2 rear bumper on a gl 2007 phase 1 ?
@BumperdoorDIY7 күн бұрын
No it won’t fit
@tigerlilly90387 күн бұрын
Thank you
@BumperdoorDIY7 күн бұрын
You're welcome
@gregrobbin8 күн бұрын
Thank you for the instructions!
@BumperdoorDIY7 күн бұрын
You're welcome!
@lpat4018 күн бұрын
does the upper front bumper on the top part (black moulding) comes apart or is it one piece??????
@BumperdoorDIY7 күн бұрын
The silver piece in the middle comes apart
@coofe12349 күн бұрын
Video cuts out before you take the front fender/wing off. I need to remove only the fender, do you have the video available? Will I need to take the bumper off to remove this?
@BumperdoorDIY9 күн бұрын
Morning that video on how to take the fender off I do not have and yes you must take the bumper off in order to take the fender off
@Richardcaro4019 күн бұрын
Can u do a video on how to remove the fender from the same vehicle ?
@BumperdoorDIY9 күн бұрын
Whenever they assign another one to me
@olumideadebayo65769 күн бұрын
hi, any chance you can show how to take the handle off? I need to replace mine -front passenger door handle :)
@BumperdoorDIY9 күн бұрын
Am sorry buddy I just went over this video and realized that I leave out the part where am talking the handle out my apologies
@sircmillion5369 күн бұрын
This is basically my job. I love doing it. Thanks man. Big ups.
@BumperdoorDIY9 күн бұрын
You welcome big man nuff respect 🙏🏾
@sircmillion5369 күн бұрын
This is basically my job. I love doing it. Thanks man. Big ups.
@DuanePinkston10 күн бұрын
Appreciate the video! Is there a part number for the rivet??
@BumperdoorDIY9 күн бұрын
That’s a good question because I never seen a part number on them
@manuelramos36610 күн бұрын
Great video just wanted to know what specific tools did you use
@BumperdoorDIY9 күн бұрын
You could used a regular hand ratchet with a number a 8 socket and a number 25or30 6point star tip tool and a clip remover the small one along with a extension
@verroch1234510 күн бұрын
Hats off for the effort to make the video, respect
@BumperdoorDIY9 күн бұрын
Yeah man respect 🙏🏾
@akvirus210 күн бұрын
💪🏽💪🏽💪🏽💪🏽💪🏽
@timherman471210 күн бұрын
Great Video, can you get the emblem off without taking off the bumper ?
@BumperdoorDIY10 күн бұрын
Am sorry I don’t remember
@jackelinnelima693110 күн бұрын
Hello, I'm Brazilian, I work in a mechanic shop and I have a 2023 Audi Q5, the customer went to do a bumper service, when we removed the bumper and put it back on, the windows, roof, horn, headlights none of them worked, only the rear ones. Could it be you?
@BumperdoorDIY10 күн бұрын
You have to get the vehicle recalibrated
@74drat12 күн бұрын
Thanks man. Stripping passenger door for blend. Already replaced both coolant rads and AC condenser plus core support and then hood and passenger fender. Needing to blend passenger door so yeah this came in handy.
@BumperdoorDIY11 күн бұрын
You welcome men 🔥
@lefthanddrummerable13 күн бұрын
Workin Wayne's the man 👍🏼🤘💪
@BumperdoorDIY13 күн бұрын
Appreciate you 🤛🏾
@whittneyfarrington980714 күн бұрын
Is there way to show how to reconnect the wires to connect the light back
@BumperdoorDIY13 күн бұрын
The same way you take them off
@isiahslater2114 күн бұрын
For the last part at 20:36, that little black piece. How do I put that back in?
@iraqiking2414 күн бұрын
Dose it come without a shutter
@BumperdoorDIY13 күн бұрын
It’s s depends on which model you have because some do and some don’t
@Jeff-p9j14 күн бұрын
Thanks, not as involved as I thought it would be.
@BumperdoorDIY13 күн бұрын
You welcome
@greenearthblueskies855614 күн бұрын
Thanks
@rcasturi5514 күн бұрын
What size sockets you use . Thanks for the great video