Wieder eine Vorrichtung die nutzlos ist. Bohrer hat keinen Freiwinkel. Wer nicht weiß, was gemeint ist, sollte keine Bohrer anschleifen, und erst recht keine Vorrichtung basteln.
@user-yc8fb7of5q6 күн бұрын
Не делайте так, как показывает этот ч.рт. Он понятия не имеет, как точить сверла.
@luantrinh76199 күн бұрын
Nhìn bai bản quá anh zai
@mckutzy14 күн бұрын
You need to keep the guard on... especially working on heavy steel.. Thin discs explode pretty easilly.. But hey... eye replacements are cheap these days... 😂
@Hai-no114 күн бұрын
Thank you very much: I have been in this profession for 20 years.
@jvmiller199516 күн бұрын
It is a compound angle you need a 59 degree angle to the blade but you also need about 12 degrees to relive the cutting face of the bit. Cut off wheels are not made to take a side load like that. Sharpening freehand on a bitch grinder is not hard.
@Dextroniann19 күн бұрын
Thats Cool
@Hai-no119 күн бұрын
Thank you very much.
@z900dusan5Ай бұрын
Thank you
@Hai-no1Ай бұрын
Thank you for watching the video. Please subscribe to my channel to support me.
@z900dusan5Ай бұрын
@@Hai-no1 ok I subscribe your channel I wait for videos