If it says "DONE" in the display then your all good. No problems.

Thats a good truck you have. Mine lasted 134000 or abouts and the thermostat got stuck closed causing the engine to over heat. The cylinder heads yes, both of them warped because of the over heat and totally destroyed my engine. I had to rebuild it and it was not cheap. rebuilt heads went in and to say this I am scared to drive my truck because I have no trust in it. I learned that the heads are made of poor quality aluminum which could not withstand the temps. I also learned that it happened to thousands of trucks that had the 4.7. There are a few that happened to the 3.7 engine but mainly the 4.7. I love my truck but I have no faith in it.

@@litleElmo mine has the 5.9...I've replaced the computer and front control module.water pump twice and power steering twice other than that runs like a champ

@@361outlaw5 You are so lucky to have the 5.9. Hardly anything goes wrong with those engines. Just routine maintenance and your all set. My dad has a 5.9 and needed water pump, spark plugs, wires and coil after 100000 miles. Oil has to be changed alot now lol. Trans fluid also. Still drives at 400000 plus miles. Take care of your truck. You got a deal on it.

👍👍👍👍👍

Nice adea and keep sharing for everyone to learn to help themselves and others. Thanks

Thats a bummer

@@litleElmo WAIT I thought you didn't upload

@@SODMG. I only upload if I find more tricks to help people. I been off for a while on my account when KZfaq and the web knocked me off and didn't accept my password for a long time. Finally fix that lol. Politics everywhere

​@@litleElmo anyway do you still have that truck?

@@SODMG. Yes. I still have my truck.

Yes, The fuel pump should supply fuel to the engine while cranking. If no fuel then check fuel pump relay, Pump fuse, check fuel filter, fuel pump, fuel pressure regulator, accident momentum switch.

@@litleElmo 👍 awesome thank you

Dead battery

Just a minor glitch It'll be fine it's resetting itself

I have worse lol

Did you fix the problem? My lamp out warnings went on but mine was a passenger rear so I just replaced the bulb. Not hard to do.

@@litleElmo haven’t been able to work on the light I will try to replace light bulb and see how it goes

OK. To find out which one is out, just turn on all your lights including the emergency flashers. Just makes it faster. More than likely it will be a smaller bulb instead the headlight.

I have the 2.0L. You should check your starter relay, fuse, cables to your starter. You might even have a bad solenoid and or starter.

@@litleElmo I can tell you with 100% confidence that it’s definitely not the starter/solenoid. I was able to by pass it, using a standard push button, and as long as I have the key/turned to the run position, it starts right up, and I can also hear the relay click every time I try to use the key, but I’m no electrician, idk if the relay can still be bad or not.

Check your plug connections under your instrument panel and connection at the pcm under hood passenger side firewall. Make sure they are clean and dry or it will not work.

Also, check your fuses.

I don't know what that means

There are dodge truck forums that have wiring diagrams and they can help you there.

what truck model do you have and year?

@@litleElmo it starts now my original issue is still there

@@tinovo375 Have you checked for the code number? Do the process like on my other video and look up the code. You have to use the ignition switch to get the code. After you get the code then look it up on the internet and replace the bad sensor and erase the code.

I have a 2002 ram 1500 4.7l

Truck has no engine codes just acts like its in limp mode

Happy to help

The only thing is if there's an issue, it's gonna keep throwing codes. Eventually it's not going to just clear it for good.

Exactly what I saw in the fuse schematics, thanks for the update, I am having the same issue with my 2002 focus.

@@JGGarcia-kh8uq mine turned out to be a faulty starter. I would take it to get tested and it would pass wonderfully. After I replaced everything else, I decided to replace the starter, haven't had issues since.

What issues are you having with the car? Have you checked my other vids?

Also make sure the battery is good. Needs a little more than 12 volts for the electronics to start working in the car. If its less than 12 volts, give it a jump start and see if that works.