Very clear instructions.it work perfectly for Toyota Corolla 2010. Thanks a lot.

4 saat uğraştım 216 ya paswort hesaplayamadı

28rte680

I did't today on yares 2011 it workd perfect 🎉🎉🎉🎉🎉🎉🎉

Does it only turn on when it is plugged in?

This worked for my 2009 Toyota Corolla. I just had to do it a few times before it worked completely.

Would this work on a 2021 corllla with no master key.

This is a crazy design. So overcomplicated.

Worked on my 2010 Toyota Corolla! Thank you!

Can you give us this information without this bad and distrub music

Is it suitable for Fiat car Ducato 2023

Will this work for a 2014 Corolla S?

At first I thought this was a troll video but when I tried it it works. Thank you so very much

Thanks Man!!!

Australian 2015 yarris. Passenger door. Put key in. Unlock-lock about 8 times. That's all. It worked. I almost gave up. Cheers.

Holy fuck, it actually worked on my 2015 Corolla.

Can these work also on Vios 2019?

@Zed-FULL - I've used this video twice in the last year thank you. I have a 2010 Corolla and it appears that the Receiver module loses the keycodes when the battery dies. The first time I replaced the receiver module - which I threw it out and it was probably good as I learned later. Then I used this and it worked (see notes below.. some problems), then the battery died and I replaced it, and the door locks no longer worked.. So I saw @yyzbogdan2680s note (it is the first comment) not sure if they would stick if I rewrote.. but they are working now so I'm not going to try it. **MY BIG COMMENT IS WATCH WHAT HE DOES, DON'T FOLLOW THE STEPS AT THE BOTTOM** of the Video. Here is a proper written procedure you can print out that will work to ADD a key (which you will lose when the battery dies). Car validated on: 2010 TOYOTA COROLLA REMOVE RECEIVER PROGRAMMING NOTE: This video has a couple of errors, *WATCH* what he does, not the words at the bottom of the screen. In the video the corrections to the written instructions are as follows if you can't use your phone to view the video as doing this: -Step 4&6 should also say "remove key" at the end. -Step 8 should have said, "repeat twice" at the end. -Step 10 (Zed's step 12) have said "Open and Shut".) kzfaq.info/get/bejne/oMCRZpR4x6vXp4k.html 1. Open driver’s side door. Leave all other doors closed. 2. Insert key in the ignition (don’t turn) and remove. Do this 2 times. 3. Shut the driver’s side door, then open, shut again and open, leave it open. 4. Insert Key in ignition (don’t turn ), remove key. 5. Shut the driver’s side door, then open, shut again and open, leave it open. 6. Insert Key in ignition (don’t turn ), remove key. 7. Shut the driver’s side door (leave it closed). 8. To add a new remote, turn the ignition back to the on position (don’t start), then turn back to the off position and remove the key. Repeat this step again. ---- DOOR LOCKS WILL NOW CYCLE ONCE TO INDICATE IT IS IN PROGRAMMING MODE --- 9. Press the lock and unlock buttons of the remote together for 3 seconds, then release, then press the lock button once. ---- IF PROGRAMMED SUCCESSFULLY DOOR LOCKS WILL CYCLE, IF NOT REPEAT STEP 9 ---- 10. To end the procedure, open and shut the driver’s side door. 11. Test the remote

Thank you!!!

The insertion of the obd connector is described in great detail. I didn't know.

Thanks. It did work on my toyota anus.

Thanks worked!

Questions i keep see in videos like this but all the cars always got power windows now havent actually tried yet but im just concern because my car is not power windows is manual windows so does that matter for pogramming the key or a controller / universal key fob

Last step and locks do not cycle ??????

It dont work on 2011 camry tried for a month i give up

What these guys don’t tell you, is that you need a Autel or Toyota Laptop to program to add a key fob. So cases, 4 times out of 5, you have to erase all the fobs and then program them all to the vehicle for the fob to work!

I wish I could like this vid a million times

I don’t understand why all of these videos do not say if you’re putting the master key or the new key and when you’re doing that switch around!!!! Very simple. If you can’t make clear instructions, stop running us around on a wild goose chase.

On my '13 Corolla I had to turn on/off twice for the programming to work.

Thanks , after 5 attempts it works in my 2010 corolla. Thank you.

Didn’t work on 2016 Corolla

This worked an absolute treat!!!

This worked with my Toyota vitz ksp 130.Thanks a lot. It saved my money and time for searching a place for key programs.

Crikey, £50 in credits to delete the keys and add a key. Key tool plus costs nothing to do the same.

Добрый день , где можно купить такой аппарат?

Doing this was like the hardest mortal kombat combo

Didn't work on my 2014 Corolla LE...

I have a 2016 Toyota Corolla S and I can’t find a place to put the car in in to do what you show here. Can you help? Thank you

Do you have instruction for Toyota Sequoia 2008

Should you leave service mode when finished or just unplug and reinstall the cluster?

What good news but unfortunately i Zed Full, 5 months ago that does not turn on after updating the software. I have tried, change PCs, but the problem continues

Bonjour dit moi comment fait avec une Piaggio X9

Why don't they update their videos or delete them when these functions stop working?

got the same issue. not responding from zf

I have corolla 2012 xli.And i have only normal remote with chip.There is no button.Can i upgrade it?

bonjour, savez vous comment programmer la clé perdue de Mercedes w210 avec xhorse key tool max pro. ou quelle donnée demander au concessionnaire Mercedes pour pouvoir ensuite programmer avec cette appareil.

Magnetti Marelly ACI 601 ZedFull reed and make transponder is successful.

Super

Do you know how to program 2014 Corolla?

Пробовал на бмв ф10 прописать ключь, несмог, обрывалось всё на моменте считывания родного ключа.