Thank you good explanation

no se si arruine el connector

Hola Bullet Solano, talvez me ouedas ayudar. instale las luces y las direccionales. la de la izquierda esta fallando y desconecte el cable amarillo y reconecte el bombillo y ahora el bombillo de fabrica se queda encendido pero no parpadea cuando pones la direcional. las otras direcionales del mismo lado empienzan a parpadear mas rapido como si estuviera quemado un bombillo lo que me saca de onda es que el bombilla que estuve tocando todavia enciende. pero no parpadea

Aint hear nun u said

Is it safe to start a car that way?

So how did u do it?

Dude, that’s more work than I do while washing my entire truck. Looks good though, I guess it’s worth the extra effort.

I own a 2000 Honda Accord. Wife’s been driving it for 24 years, I drive it for 1 week and this happens … thank you for the tip! Seems to me that is just my luck and was about to be frustrated because I couldn’t figured it out at the beginning what the problem was. 👍🏼

Thanks 🎉

The instructions didn't tell you to sand like that.

The only problem is if you are driving and by mistake press the lock button 3 times open the tailgate. I have that problem now.

Thank you for the very easy to understand video. I have a 1999 Accord LX with a 4 cylinder F23A1 engine, so your video was very helpful. Great step-by-step instructions. Thanks again.

What was you dilution ratio?🔥👌🏼

W Rav4

Can you tell how did put them in the cars please

Thanks Man! That was exactly my problem. I appreciate it.. 😁👍

Looks so gay on rav4

Are you sure that's a 12-volt

So my fuel pump is new. starter is new. That relay is new it cranks but no start. Any thoughts. Sounds like it’s not getting fuel

В приоре 10 года уже было такое

Good 👍🏼

Love it info on were to buy it thanks

Those old clamps are much better than those new clamps.

Congratulations on your shit car

I love those old 3rd gen ls plus. 40W per bulb is great for low beams. And then 4th gen LS plus 65W for high beams is even better

How many volts is that drill that you used??

How do I use this on my wrx sti with push to start no key?

All cars do that. Hold the lock button they should go back up for ya.

omg so cool i definitely care

Thank you so much for your video! It looks time consuming but definitely doable! I do have one question, I got a little confused at the end, did you also install a button on the outside of the liftgate? I know you put one facing the inside of the trunk, but one point you also opened the liftgate from the outside but I didn’t see you installed anything. Thanks for your help in advance!

Where did you find the carbin fiber cover for where the drive stick ?

I see like double vision.. is that from the video or it's like that?

Hi How i can finde fusse for van ? Toyota rave 4 2018

😂😂😂 this ngga

Wow 😍😍😍😍😍 nobody gives a fk

Saludos mi hermano bendiciones….. how long did it take you to do the steering wheel… Im hesitant to order it because I feel like I wouldn’t be able to do a good job or mess it up 😢

Yo bro, are you setting all close the foam knob?

is your car coated?

Thank you for the review sir, it was clear, quick, and straight to the point. I purchased this polisher before watching the video and you helped a lot of my buyer's remorse. Haha. Take care, and I hope more people see you videos as you are honest and well spoken.

Nice!! Just got one and I’m definitely using it to dry off my rig! Should be way faster and easier than wiping it down with my absorber rags

hey i have changed my headlight bulb and it still doesn’t work only on passenger side i have chevy 2017 impala premium do you know any solutions?

If i do this and it still leaks, will the warranty be voided?

Have you tried 1.5?

Thank u its work with me ur steps is clear and simple

Hello bullet! Can i use 2 inch wheel spacers? Or 1.5 inch is good enough? Also whats the size of your tire did you use? Thanks brother! Planning to change my tire a lil bit meaty but stock wheels.

Thank you for a very descriptive@how to” video!

H

What bet you use

Thank you for being so detailed. I had to service the rear brakes on my 2019 RAV4 and looked at several videos about how to put the brakes in service mode. Seems everyone had a different method and perhaps missed some of the simple steps. Leaving the door open being one of them. Everything worked as you said it would (I forgot to reattach one of the connectors and tried to reset the system and that didn’t go well😅! Anyway,once I realized the error and corrected it, the brakes reset according to your instructions. As it happened, I paid for a dealer service a couple years ago and only had about 25Km on the odometer from that time. I suspected the brake pads were stuck which is why I wanted to check it out. I was correct - both sides were seized and I used a rubber mallet to hit them out. One of the slider pins was also dry and stuck. I replaced the brake pads, serviced the calipers, etc. working great now!

Greetings! Just had the A/C Tune Up done at shop for 20K RAV4 Prime. I purchased car used with 19K so I started with dealer to get things going but will use your videos in the future. Thank you!