I’m having issue with the black catch part popping out of the assembly the old latch had same problem so I replaced the latch and new latch has same problem

Any tips on replacing a palomino banshee 2010

What's that tape called

Where do you go to buy a cable ? One of mine have snapped

I am concerned about our cables. I can see that one corner is slower to lift than the other three. Is there a video on how to adjust the cable tension? or might this be to a different problem? How do I find the correct height of the lift arms? 2008 Avalon

Can you give me information on motor and how to add motor to a coleman camper 2008 destiny .Thank you Dana Swanson

Thanks! Cutting the bow support pole as/per the video worked like a charm - and now our 2003 Taos is ready for another 20 years (unless we get another blast of a windstorm unexpectedly that broke the original)

Good times...

Thanks for the video. Got a question about spraying diluted alcohol on the 3M adhesive. Won't this weaken the adhesiveness? tia

I can’t get my dome lights to work at all anyone have ideas? thanks!

Excellent sir.

how do you replace the bed deck

I have a 1991 Coleman Roanoke it raises about 8 inches. I’m sure this has been answered but what do I do to fix this system? The one I have appears to have cables. It gets really hard to crank after about 8 inches of lift. Any help would be greatly appreciated on parts or how to fix. Thank you in advance for the reply!

Great video! Quick question , i was raising my popup the other day and about half way up it got very hard to crank. I stopped and checked underneath. Found one of the corner cables had skipped the pully and got stuck really bad. After 3 hours and lots of bad words i was able to fix it. Can you tell me what would cause this? And how to prevent it? Thanks so much.

Took the plate off and found a mouse nest with 4 babies! Greased the whiffle and now it’s cranking up easier. Thank you for the tutorial!

Thank you this got my fridge working on lp again!!

Very interesting!!!

How much do them cost please

No whiffle tree on my 1995 Columbia but lubricant of other others very helpful.

How do I find out what part number I need . I need just the drive hub extension with the spring washers and nut.

Can a DIY person do this?

Good information but I just use a cam stove on a table I don't even use propane like that in a camper I don't trust it it can be dangerous

Hey, may I ask why you need to replace whole arm if the middle rivet broke? Can you not just replace that rivet, may I ask what I am missing? Thanks

Well shit, I thought I ordered the wrong one because it didn't come with that lower band and didn't expect to have to rivet it. . . Just took it back.

Very nice job with the video! I sincerely thank you. Your right, there is no need to pay someone to do this!

So my husband just put our pop up down on Wednesday, Thursday drove it to the lake and it won’t go up!! We are in over our heads and need help!! Where are you located??

One of the rails won't let the bed slide back in. Does this mean the rail is bad? Is there a way to slide the bed back in without tearing things apart?

We have a 2008 Fleetwood Avalon highlander. The ceiling, on the inside, is sort of bubbling or delaminating. It looks like the more decorative film is separating from the base. It does not look discolored/stained. The roof is not quite like any of the 3 above. There are no seams on top, but there are metal pieces that wrap around the upper side edges and corners. We don't have an air-conditioner nor a vent. There is nothing on the roof and I don't see any cracks. Should I suspect water is getting in under the metal covering the edges? Is there a video for this model?

Thank you soooo much!!!!

I hope I never need to reference this video, but have saved it in case I do.

Wish you still offered these, I need one badly!

where is the gallery????

Ask how to thread the cable through lift system on a 1987 Coleman sequoia popup camper

It didn't help a bit I wanted no how they was threaded like the video saye but it doesn't show how each cable go where they get to that part and they tell you put the cable on an go next step bs

great video and to the point ty.

I just rebuilt my 6311 crank assembly on my coleman pop up it will go up but wont come back down please help!!!

Thank you for the info and the link. I ordered both parts and after watching your video I feel confident!

Best of luck to who ever is trying to install this part without a video showing how to do it. Beyond frustrated. The worm shaft of the wiffle tree pulls the assembly too tight and the ratchet paw doesn't connect. Time to burn this tent trailer down.

My ‘99 StarCraft Starflyer uses little metal twist locks to tightly secure the screen door to the roof. I never realized other camper brands used straps & snaps to secure the door. Interesting choice.

How does this process compare with the system where you have the crank up higher with a chain drive for to the wiffle tree? Like on a 2002 Coleman Mesa

Why wouldn’t you tie one end to the cord your gonna pull out and pull both through at same time use tape like eletricians to cover the ends and feed it through

Thank you! Exactly the info I needed and incredible artistic skill!

Thank you for the informative video!

One of the cables that guide my screen door has snapped - can you do a video on how to fix??

I have a 2000 Jayco with a similar issue. Will this part work for my pop up too?

My Hi-Low camper will not go up.

You mentioned avoiding an impact driver. It doesn't seem that any of my drills have enough torque to actually life the roof. Why would you recommend avoiding an impact driver or impact wrench?

Thumbnail was not convincing, glad I clicked. Lots of what I'm looking for. Thanks for sharing!

Is it possible the clutch friction piece could be too oily & slippery and not provide enough friction to lower the top? My camper went up OK but now the crank doesn't seem to provide any resistance and does nothing.

After unbolting that assembly, didn't you have to punch out a roll pin to completely remove it?