I agree. Sony HT-S20R is also pretty awesome. I have heard it in a store. However the wires in that system are quite a hassle. That is why I wouldn’t consider it.

@@skip2review Yess for sound department i mostly prefer only 2 brand Sony and JBL thats it. Sony S20R gives is very very balance and decent bass. Secondly wires and wires and mess everywhere. At a same time i herd SB190 that i found more live than S20 to over come that sony have S40 that was more clear loud and bass than SB190 but you need to shell out more for that, around 25k So i finally listed SB190, S20 and if you want to go beyond 20k SB40 is best

Do you mean the power bank that I reviewed in the other video?

It could be one of two things. You also need to connect the subwoofer to power and I guess you have already done that else the soundbar itself wouldn’t work. The more likely problem is that your subwoofer is dead. Reach out to the manufacturer using Flipkart support. I had purchased 3 of these and out of them the subwoofer died on 2 units. I got the unit replaced in both cases. In one of those two replacements, the subwoofer died again and then Flipkart took it back and refunded the money. So I believe this is a common issue with this product amd you should speak to Flipkart to get it replaced / repaired. P.S.: The third unit that I purchased has been working fine all this time.

Thank you for your comment but can you kindly translate this to English. I’m unable to translate it myself.

@@skip2review ok thanks... don't vorry I tell you... Soundbar to subwoofer how to connect? Any signal and light colour please tell me

@sureshnaidu4224 - When you power on the soundbar and the subwoofer, they will automatically pair. There is an LED light at the back side of the subwoofer, right next to the power cable input (I’ll show this in my next video), and on the soundbar itself. When the subwoofer is paired to the soundbar these LEDs will be solid amber colour. During pairing process they flash quickly in amber colour. When the subwoofer is in standby, the LEDs flash slowly in amber colour. Hope this helps you 🙂. P.S.: Also, there is a button right below the LED on the back side of the subwoofer, which you can press and hold to pair it to the soundbar in-case you find that it is unable to pair on its own.

@@skip2review tq sir

It was not mentioned in my user manual. I had to measure my wipers using a tape measure.

Thank you !

Yes they are pretty good ! Glad to know you like them too 😊

Thank you !

Thank you ☺️

Awesome…!!! 🙌

Thank you ☺️. Stay tuned for the detailed review of braun mini !

Aap ek to ek soft wet cloth se wiper blades ki jo silicone edge hai usko wipe kar sakte hain taaki agar koi dirt ho to wo nikal jaaye. Agar aapke paas WD40 spray hai to wipers par wo spray karke clean kijiye. This will help agar wipers me problem hai. Ek aur simple solution hai ki wiper k silicone blade ko windshield glass par perpendicular place karein that might fix it. Agar wiper blade glass surface par against the direction hai to vibration hoga. Mostly yehi problem hoti hai wipers me. Kabhi kabhi wiper arm ko thoda twist karna padta hai usey properly position karne k liye (this is risky and can result in breaking the arm so please don’t do it if you are not sure about it).

Thank you ☺️

INR 35,990

Yes sir, we need one 20 inch wiper (for driver side) and one 16 inch wiper (for passenger side). The real size of passenger side wiper is 15 inches but I could not find it in the kind of wipers I wanted (the ones in the video), so I went in for a 16 inches one.

size 8

It has been a couple of months and the rains are here now. Based on my experience these are 10 out of 10 as of today. I will post an update to this answers after the monsoons as-well.

no idea bro !

You can definitely change your rear wiper. But the process is slightly different and taking the rear wiper out can be a little bit tricky. I was trying to take mine out to clean it properly but ended up breaking it 😭. I could not find a rear wiper for Kiger on amazon so I had to go to the authorised service centre and was pleasntly surprised that it was not exhorbitantly priced. I dont’t remember the exact amount but it was either around 800 rupees or 400 rupees. All the best..!!! 👍

@@skip2review Thanks boss 👍

Max Printed Lounge SetsTEAL100%... www.amazon.in/dp/B09PMYM86C?ref=ppx_pop_mob_ap_share

Sorry for the late reply. The third step is a little more than 27 inches (a little less than 70 cm) from the ground. Also, the second step is at 18.5 inches (47 cm) and the lowest step is at 10 inches (25.5 cm) from the ground. Hope this helps.

Agreed. Here we were trying to hide cable clutter as much as possible that is why we kept it on the TV console top.

Glad it was helpful 😊

Dude walk me through wdym by lmf mode

That’s Apple for you 😕. No rhyme or reason. In the 2014 models, RAM was soldered on to the logic board.

It is upgradable of course. Does not matter if it is soldered or socketed or slotted. Just send it to a soldering specialist and he will upgrade your mac mini's ram to 16GB and even the cpu is also upgradable. But it'll cost something. Usually the soldering process cost around 80$ if you bring your own memory chips and 120-150$ if you not.

Max Printed Lounge SetsTEAL100%... www.amazon.in/dp/B09PMYM86C?ref=ppx_pop_mob_ap_share

200 sq ft

@@skip2review 200 mai 1 ton? Kaam karraha hai?

Room OK OK thanda kar deta hai ye ac. I am out of station right now, maybe ye room around 150 sq ft ho I am not sure I will confirm when I get back.

@@skip2review okay 👍

Amazon

Size 20 inch - Rs 408 Size 16 inch - Rs 311

I haven’t heard Zebronics in-person. However, I do know that the difference in these would not be night and day. Having said that, I can confirm that I have seen quality issues with Motorola. We bought 3 of these and 2 had to be replaced. So I would lean towards trying Zebronics because of this negative experience.

Glad you like it 😊

Thank you @deepikaaggarwal9477

Thank you ☺️

Thank you ☺️

Thank you ! 😊

I have already done this 🙂. I don’t think they have designed it to work this way, however, the hub seems to work OK upto 5 fans with this arrangement. The sixth fan however has issues. And when I say ‘the sixth fan’ what I mean by it is that on most system restarts, one of the 5 fans does not turn on. However, if I go into the MasterFan software and hit the reset button, all the fans turn back on. Now for me this is not a problem because I am OK with this fidgeting around in the software. Now there may be a way to avoid this, which is we plug 3 daisy-chained fans into one of the ports, then 2 daisy-chained fans into 1 port, and then 1 fan into the third port. I haven’t tried this approach and I am away from home for a few months on a business assignment. Once I am back I will be able to confirm this. By the way, are you looking for the ‘1 hub only’ approach because you have only a limited number of usb headers on you motherboard..? If yes, then I would advise you that you can get an NZXT Internal USB Hub which would solve your problem and convert 1 USB header into 3.

Link in description! Hope this helps

Thanks ✌