I know this video was from 5 years ago but I was hoping to see a picture or a video of the pumpkin patch when it was full grown..

My chain won’t tighten despite turning the knob to tighten the chain just stays loose

Thx from Russian driver)

What air pressure do you run in the tractor

Police game Mein working

❤❤❤❤❤

Eddie Riley

Music ruined it

Where did you get the lights

If you fill the fuel filter before installing it then turn your key on for 1 minute you’ll have no issues when you start your tractor. Hope this helps.

Junk...drain leaks badly and you can't fix it

If you think 40 volts is good try the - 80-volt - 5-ah battery - 10" Bar - 6 ft / 8ft foot Kobalt Pole Saw. No cable. I’m using an Oregon Bar and Chain. I have been using it for more than 3 years now and love it. It works great on my southeast Louisiana farm clearing property that a hurricane went through and trashed all the trees in the woods of our 20-acre farm. I carry it all over our woods and the battery lasts a long time. Today I'll be cutting a 6-inch limb off of a tree out front. I also have (2) 80-volt 5-ah batteries 18" chain saws they are awesome.

Hello, Are you interested in testing our products? We would like to invite you to test the Heavy Duty Rear Windshield for your Polaris Ranger 900XP( if your car year is 2013-2019

Worked for me! Excellent instructions. Thank you, sir.

Since you’ve had them a while, do you still like them? We are about to make an order

Exact same problem, broken bed shock killed speed sensor. Thank you for sharing!!!

How long is your trailer?

Is the trailer 8 ft wide or is deck 8ft wide?

These kits look perfect for my application, a retrofit of an exist my building. Thanks for sharing!

Simply amazing guys! Love it! Y’all are doing an awesome job!

Nice work Ray! The Dutch bucket and those clips are slick! Can’t wait to come see them!

Thanks for the video. I like this set up.

What frontier model disc is that?

Where is the longer video actually replacing the sensor. I can take that belt breather hose off but still cant turn a wrench on it or get my hand in there??

i have the exact tractor only issue i have with this video is you should not be running it with the idle down all they way but other then that great video

Where did you say the store was located, and thank for sharing this video, I found it very incouraging,,, I have a draft horse and it is almost impossible to find a good wagonette for one horse. Thanks for listening

Hello, Happy New Year. I'm glad yall are safe

So thankful that you didn’t have any worse damage. Hope y’all had a wonderful Christmas and look forward to a great New Year!

What aftermarket brand is this sensor ?

Had side by side running like 30 mins outside was like 205 degrees then went for a ride went down to 196 degrees. Then these lights came on I pulled in garage went to diagnostic these 2 codes came up 3-110 16-110 But it's not hot as soon as you turn the key the fan runs non stop even a hour later I went out to check if lights went off . But they hadn't but when I go to diagnostic they don't show up now but lights on and still in limp mode and fan runs non stop even though engines cold and engine doesn't show a temp. I'm assuming it's a sensor . I watched a couple tube videos I tried seeing I could see anything but no such luck . I removed the entire box to get good look . Not wanting put bed back on it the issue is temp sensor or something. . If you happen to have any advice I'd appreciate it . The coolant level in reservoir is fine . I seen where temp sensor is on motor wire look hooked up . Is there a way to try reset code?

Where is the store located? Such an amazing resource. Thanks for the video

Great film Guys!! The store with all that wagons You"he visited is amazing!! Where is it? Keep going what You"re doing!! Greetings from Poland!!

Is this the reason it’s running funny

cancel that nasty music!!!

Any idea where I could find a video for replacing a main hydraulic pump on a 5075E? Thank you!

Hydroponic gardening has been a game changer for us. Have you ever tried it?

Thank you for making this video. $10 sensor just turned off my Ck Eng light. I appreciate the help!

I don't have instructions for the saw, so it would have been nice to get instructions on how to remove one or two of the extensions for doing low to the ground cuts.

Would you be able to show where you placed the chaiks on the rear axle?

Thank you for the awesome video. My property has a gravel area for parking cars, measuring 160 square meters. I've been looking for a way to mechanically remove weeds from this area. This is one machine I've been considering for the task. My idea is to turn the soil over, so the weeds get buried and die. What do you think about this? Thanks for your help!

So good to see y’all! Farm looks so beautiful! Y’all have done an awesome job!

I watched a different video that claims that is a oil pressure sensor. I assume you are correct I ordered a new sensor just didn’t wanna get into it a be the oil sensor

Hello, Are you interested in testing products? We would like to invite you to test the A-Arm Bushing Kit for your 2018 Polaris Ranger 900XP Crew.

I own an older one, my only complaint-they should of put a emergency brake on the thing!! Otherwise, she’s a good tractor.

"PromoSM"

I've had nothing but problems with mine starting ever since I got it .tore out apart cleaned carb Replaced fuel line new fuel right gas oil mixture Nothing it sucks

What about cleaning the screens?

I just used the DR900. That one looks nice though and alot stronger

Good video man, worked perfectly for my 2019 Ranger 900 XP that had the exact same thing happen. Instead of purchasing the official OEM Polaris part for over $100, I bought an off brand model for $25 which worked perfectly.

Do you rent them out? Long time ago, I saw a show, and someone was using goats to clear overgrown yards as a business.😊