What a great video and narrative. Your camera positioning was spot on. Thank you.
@FjeltThatBro2 ай бұрын
You the man Six T
@SoLCollectR2 ай бұрын
Im about to do this on my 2011 3.5 thank you for uploading, this is definitely gonna help me out.
@gositdown.38002 ай бұрын
Great video. But hey, you didn't include the dust cover in reassembley
@timbeckett65223 ай бұрын
Very informative and straightforward. I like the focus on the diagnostic part of it.
@robbyrey3 ай бұрын
Thank you!
@sixtauto3 ай бұрын
You welcome. I'm happy it helped! Please subscribe and share the video. Thanks
@robbyrey3 ай бұрын
Done!
@sixtauto3 ай бұрын
Thank you!!
@KPDExplorerPost5094 ай бұрын
soooooo helpful omg, dealer quoted $250 w/ parts & labor ... the part is $26 online lol
@sixtauto3 ай бұрын
Thank you! Please like and subscribe so i can reach and help more people!
@ClockFixer4 ай бұрын
Thanks for doing this video!
@sixtauto3 ай бұрын
Thank you for watching! Please like and subscribe so I can reach and help more people!
@ClockFixer4 ай бұрын
According to GM you are supposed to replace the CRANK Bolt everytime you do this repair
@ClockFixer4 ай бұрын
Wouldn't it have been easier to remove the Crank Bolt if you had left the belt on to give the pulley resistance?
@chadsheppard35764 ай бұрын
Just had mines replaced yesterday since the old one was leaking oil and had to get a new serpentine belt too
@karenpage25352 ай бұрын
How much did it cost for these repairs?
@danielmcgrane56985 ай бұрын
Thank you for this! At the 9:00 mark, you talk about how the transmission needs to be aligned exactly in the manner shown. Most of the other videos on this topic do not show this in detail.
@sixtauto3 ай бұрын
Thanks for watching. I try to do as detailed as possible without making the video as long as a movie lol. Please like and subscribe so I can reach and help more people.
@jorgejimenez48295 ай бұрын
Any torque specifications?
@nelsonlopez46956 ай бұрын
2010 Equinox, oil leak, I think oil around pulley area. I see not the case. It’s timing chain cover? Great video by the way. God bless thank you.
@sixtauto6 ай бұрын
If the oil is only around the pulley area then it's more than likely the crank seal that's in the timing cover. I changed the seal in the video starting at about the 8min mark. It will be a little bit of a different removal process if the timing cover is not removed first. Thank you for the comment and watching it!
@cgonz816 ай бұрын
Do you recommend adding gasket maker?
@sixtauto6 ай бұрын
No, I do not use gasket maker for this job. Just use a new hard gasket.
@husseinalashoor74726 ай бұрын
I just replaced this piece for Mkz 2016 I have 0 experiences but I did its not perfect but it’s working 😅
@chrisogilvie21857 ай бұрын
Thanks for the video 🙌🏻
@sixtauto6 ай бұрын
You bet!
@joyofwrenching7 ай бұрын
Subcribed! Good job man, and keep the Joy of Wrenching! Only tips I would give from someone a few more videos in is maybe invest in external microphone to pick up your valuable tips a little more and I really like the rechargeable lights with magnetic bases to put lots of light in those dark areas so it shows a little more clear on film. Even with those little things, you're doing great!
@balisticjello8 ай бұрын
Great detailed video thank you
@ThezNutzGarage9 ай бұрын
Just subscribed I have to do this job in a few weeks. I am going to post the link to this video in my video. Thanks.
@sixtauto9 ай бұрын
Thanks for subscribing and posting a link to the video. I hope the video helps you when you do it in a couple weeks.
@user-vl8sw7kg7y10 ай бұрын
A penny for your thoughts 💭
@aaronsmith543310 ай бұрын
Jeeps are trussed up lawnmowers 🛞
@rusco32110 ай бұрын
Covering up a misfire at idle or low oil pressure?
@xelercheddar802610 ай бұрын
Oh yea
@thoubias10 ай бұрын
"I fixed the problem and it only cost me a dime! Practically took just a piece of duct tape and all is well again! Didn't even have to use any zip-ties!"
@onolicious914711 ай бұрын
An explanation??
@jacobwarren449010 ай бұрын
A place to store spare change just in case
@SkylineTwinSpoolysnail10 ай бұрын
He likely took it too some backyard mechanic who “fixed” a misfiring issue or a low oil pressure issue by raising the idle with the duck tape and quarter trick. He put it in there so it would idle higher and cover up the misfire/low oil pressure. When the idle is higher it’s harder to hear the misfire and it raises the oil pressure the higher the rpm goes
@onolicious914710 ай бұрын
@@SkylineTwinSpoolysnail ahhhhh, I see. Thanks.
@salvargetto58111 ай бұрын
My question is is how to get the side panel off next to the consult
@williecooper6022 Жыл бұрын
This video does not show the bearing removal
@bargainhunter8950 Жыл бұрын
I have a 2016 that has the lower airbag how do I get to it or how do I remove
@erikrodas1746 Жыл бұрын
Didn’t help at all
@moccasinmarine Жыл бұрын
Is there any way to replace the bearing without pulling that housing out. The other side pops out with the circlip intact. Why can’t this side?
@bossladyrose2 жыл бұрын
Will the A/C run properly intermittently if the actuator is going bad? Have hot air drivers side, cool on passenger side... but then all of a sudden it works properly??
@Thomas63322 жыл бұрын
I had this problem, so after watching these kinds of videos, I changed my actuator. May I suggest that you try to press the defrost button and power button at the same time first. Hold them down for several seconds. This just might reset the electronics and save you the trouble.
@All-about-everything2 жыл бұрын
which power button
@Thomas63322 жыл бұрын
@@All-about-everything I'm sorry that I haven't seen this earlier. There is a power button just under the fan insignia to right of the defrost button. It goes defrost, rear window, auto, power button. Press them with the car running and hold them down until the ambient lighting goes through a couple cycles of changing colors. Anyway that is what I did and the air actuator started to work again.
@aaryiasworld51832 жыл бұрын
I did this just now and it worked! Not sure if its a temporary fix, but boy am I glad i seen your comment!
@Dstrbrdgrnd Жыл бұрын
@@Thomas6332I have this problem with my ‘07 town car. Will your suggestion work on it?
@Thomas6332 Жыл бұрын
@@Dstrbrdgrnd It's a very simple try. Just press these buttons at the same time and wait for several seconds. I watched the ambient lighting go through all the colors, for example. Then my problem was resolved. It costs nothing to try. Good luck.
@minormobley51062 жыл бұрын
Mine is blowing hot air on the passenger side are there two of them accusatory just one
@Dstrbrdgrnd Жыл бұрын
On my ‘07 town car there are 5 of them. One on each side, have no clue where the others are, gotta remove entire dash board and drop steering wheel😳😳😳
@minormobley51062 жыл бұрын
Ha is there one on the passenger side
@Dstrbrdgrnd Жыл бұрын
Yep, gotta take out glove box and air bag to get to it.
@rogeliogarcia14392 жыл бұрын
Both of my pins broke on my passenger side linkage. Whats the next step? Take the whole dashboard out?
@Mrdubomb3 жыл бұрын
I got the same zip gun, what an awesome tool, cant get it in canada though.
@franciscochavez79594 жыл бұрын
Brett, how did you take out the linkage?
@thechosenone59244 жыл бұрын
i replaced however it still isnt working do i need to clear the codes
@derekculver389010 ай бұрын
I’m having the same issue. Did you figure out how to fix it? 😂
@waylonmark18574 жыл бұрын
I thought it was a great video seems like an easy fix
@mrdev4 жыл бұрын
Terrible, you didn't do crap in this. Nothing really how to about this. Didn't show the removal of ANYTHING ..the panel or connectors behind it or the actuator part. Just a video with words and pictures or where stuff is located. BTW part is not likely to just fall out be real. Thumbs Down #2
@michaelsullivan52134 жыл бұрын
If you can do better, Video it. The author is spending HIS time to HELP show how he did it, perhaps you need to rethink your remarks. Rude is rude.
@gronkgronk43963 жыл бұрын
🤣😂why would he take it off if it works smarty. At least he showed where it’s at and how to put it on.
@Noahplayzz14 жыл бұрын
How did you know this is what it was? Mine is blowing out cool air on the passenger side, but the driver's side is blowing out hot air