TOP5TopBest

Пікірлер

@kerrybryant5880 Ай бұрын

Im pretty sure the sensor the red arrow is pointing at in the last 15 secs is actually an O2 sensor...

@Theboss894 Ай бұрын

Oh, so close! The part is just beside the O2 sensor, but you're right on target. 🙂

@franknam1 Ай бұрын

that is not an Audi a4.... wtf

@Theboss894 Ай бұрын

Hey @franknam1, thanks for pointing that out! While it might not be an Audi A4, it's from the same manufacturer and related to the car we were discussing. We appreciate your attention to detail. Thanks for watching and engaging with our content!

@JackM-zm3fs 2 ай бұрын

Totally unexpected, I just realized that Mario updated his favorite way to tackle ED and it's crazy! Although what he previously talked about was pretty decent, it was difficult to follow, I just go'ogled the latest in Mario's Thunderous Erections, it's so much simpler and potent now!

@jio8520 3 ай бұрын

Hello, im pretty handy on most car's. Do much on my pristine 06 300 limited. I took over my mom's 2000 Camry with the 2.2. Great engine. Still only 79000. Been getting to know the engine. My question is most map sensors can be cleaned unless you have crazy mileage on them. I upgraded to a k&n air filter. I figured clean the sensor while I was at it. Did the throttle butterfly to keep the carbon out. But i noticed this map sensor seems closed up. No wire to spray with the map cleaner. Am i missing something? Car idles perfect so no reason to change the part with low mileage. Just wondering if it can be sprayed. Thanks! Lol I'm doing an edit. Looking more into it. The spray goes into the hole where the vacuum hose goes. Most map sensors I saw pop into the manifold for a twist pull out. Then spray in or just replace. The vacuum hose threw me off. Have to say best four cylinder ever made! Nice video 👍

@Theboss894 3 ай бұрын

Id clean it with contact cleaner, and follow up with dielectric grease to seal where the pins are. ( Not intake manifold hose)

@jio8520 3 ай бұрын

@@Theboss894 yes thanks. I do have the CRC map sensor cleaner on hand. That should do the trick as far as the hole part on the sensor where carbon can build. Yes also have electronic spray. But no issues with the connection. But won't hurt lol. Thanks!