I found this video incredibly helpful after discovering a wiring nightmare in my dash on my 90 gsx

GREAT SEATS BUT IN A VW JUNKER .I FEEL BAD FOR THE SEATS .I PUT A PAIR IN A 1980 VANCHARGER FULL TIME 4 WHEEL DRIVE 300VAN RV.THE SEATS ARE VERY HAPPY

does they always get PLUS pressure or vacuum pressure? or is it not important for the testing

its been 4 years any update?

Stupid, you don't need a relay with led's

How can i connect plye 4ch hydra bluetooth amp, APIELE 22mm Latching Push Button Switch 12V Angel Eye Ring Light LED Waterproof Stainless Steel Round Metal Self-Locking 7/8'' 1NO 1NC 1 Pack (Blue)5amp, Tegg 5pcs DC-099A DC Female Panel Mount Charging Wire Threaded Socket Jact Connector with Dustproof Plug IP67 68 Water-Proof Large Current Power Adapter 5.5x2.1mm, 12v Talentcell 6000mAH rechargeable battery using 10pcs Conductor Compact Connectors Lever Wire Nut Electrical Connectors with Fixed Base for 3 Circuit Inline Splices 28-12 AWG?

Did you pass wind @9:22??😅 and say “ I farted”?

Great tutorial! My ‘68 Bug had the same issue. I scooped up the tap/die set and it worked as advertised. Although my car is simplistic at its best, this saved me a lot of time as opposed to a shaft replacement… Thx again!

... how about the fuelling for the extra boost?

Thanks man, really thorough and helpful video, it's exactly what I needed.

Ok it’s been 4 years. I think we all deserve an update! Ha! Cmon just ONE episode for old times sake. 😅

Still haven't replaced the heater core since my last comment 2 years ago. Instead, I did the bypass and gave the interior a good cleaning where the coolant had leaked out which caused film to form on the glass due to evaporation. May attempt the core replacement when the weather is warmer but will watch this video several times and take notes prior to doing this job. Many thanks for posting this helpful tutorial! 🙂

Can you paint it any color?

I did the heater core on my 1g eclipse probably close to 15 years ago. What a pain in the butt lol. Man, I wish this video existed then, it would have a huge help! Amazing videos, subscribed and im glad i stumbled across your channel!

My 96 has 191xxx. Man, i really want to start a club for the saturn owners that own the DOHC engines.

I wouldn't see foam. just any car.... It can clean some passageways and give you a really rough idle....

will trade stock 5 speed mini truck for saturn wagon......

It is much easier to cut out the firewall and move it forward. Then you have created a space to put the radiator (with two pull thru fans).

Top hole not used ? Or called off ?

Liels paldies!

What adapter did you use?

That's dope af.i bought the purple ring led i cant wait to replace my factory ones

Those are some gay seats

You fucking that car up

Cool little car

I have a 1978 Chevy motorhome

I want to know when you start the engine, in which position the westgate goes, open or closed

I want to know when you start the engine, in which position the westgate goes, open or closed

good day, you are so dead wrong. check in BARZIL FOR A USED 5 SPEED VW BUG TRSANSMISION. CAME BOLTED TO A 2.0L FI. LOOK IN EUROPE JUNKYARDS. WOULD WORK BETTER AND A LOT CHEAPER THEN WHAT YOU THINK. NEED HELP? LET ME KNOW.

Are y’all still around

Why no intake tube and air filter?? Even a bellmouth inlet would work better than nothing.

Came across this video by accident. I'm currently looking for some fogs to install on my 97. Was actually thinking of doing something similar to this but I want to use some lights from auxbeam or something. Was thinking 4" but it's going to be too big. Nice vid!

if you prepared the motorhome for racing quarter mile. setting timing advance, advance recurve, setting the quadrajet carb for racing. when you tried to do a burnout and stalled it, you should have backed out of the starting line and taken about an hour to retune the engine. base timing is 4-6 degrees btdc. total advance timing is 36-38 degrees at 3500rpms. you can stretch the springs about 1/8 inch to achieve a better torque curve and quicker throttle response. If it hesitates or sputters or stalls on a burnout attempt, fatten the idle mixture slightly. for the 4 barrel to be optimimized for top acceleration, check the throttle bracket at the carb and you might have to add a half inch spacer to get wide open throttle. some motorhomes have a restricted throttle bracket at the carburetor to prevent the 4 barrel from fully opening the secondaries. you can also fatten the secondary fuel by thinning the tips of the secondary fuel rods like toothpicks or sewing needles to achieve a fatter mixture at top throttle. making those slight mods shouldn't cost a cent. you have no idea how much power and torque that powertrain is capable of making. run only dry weight. empty all the water tanks and only run the main fuel tank. if you had picked up a leak damaged motorhome partially gutted out will almost keep up to a corvette. I've used motorhomes in little high speed chases and I can keep up if I'm following someone in street traffic. highway speeds not so much. I typically top out within 80mph maybe 90mph if the gear ratio and engine isn't already at redline. if you can get a fast 60ft launch within 2 seconds, you'll make a mind blowing 1/8 mile or 1/4 mile run for the size of the motorhome. They're not meant for racing. But the 454 chevelle SS said otherwise.

What brand was the rack you got from RockAuto?

30/60

Does "I'm going to go ahead and swap out the wastegate actuator real quick" translate to "I'll replace the wastegate actuator."

Part 2?

You good, bro?

Proper video , thanks

When will you come back

Great stuff!

Same gas and timming 😂😂💀💀📱

My 97 Talon TSI FWD manual 82k miles gets 30+ mpg on hwy. It is 100% factory stock. It had been parked for 12 years before I started replacing all maintenance items.

That turbo is way too bog for your small engine. Hx25 will perform better

28.5

Out of curiosity is this still true for current 2020+ model tial wastegate (if there’s a change in model since)

Dad says 20 seconds. I say 16! Go!

nice, got the same rv recently.. just needs quite a bit more work done to it :D cool to see what it actually looks like

22.9 et 69 mph

1:35 - 1:44 But they went too slow…