👍

My bad I meant to say always put two zip ties on the timing chain To prevent for falling in the motor

You flirting with disaster Always put as soon as you see the timing chain, in case it drops in the motor. Which will definitely not happen if you use the zip ties

How to put programm mode on 2012 Lexus is250 push start?

awesome video brother

6:13 "in this one its gonna be from 10 to 14 (kohms)... Measures 2k and says its good? Wat?

I had to subscribe. You are doing a good job. Keep it up and don't quit

The issue my neighbor is having is his 2018 chevy traverse has the right real turn signal flashing with no key in the switch and the turn signal switch is off. There is a clicking sound in the fuse box under the hood. I can't figure out which relay is clicking. None of them seem to control the turn signals and I'm stumped and I'm terrible at wiring problems.

Gas,and battery??!!!!!this does not belong in the repair section this belongs in the quad repair for dummies 101 Department because I'm a dummy and I even know to check the gas and Battery thanks for reading and not reversing the charges

Instructions clear im calling a mehanic

That spacer is that needed

And what about the lower gasket...😂 No oil on the piston and rings.... Naughty...😂

Joey, so it was just a bad battery n no gas. The scooter vid on no spark was a bit more informative.

I am troubleshooting my 4 wheeler and this was very informative.

Do you still need to use collant or dose the stop leak Safice????

This guy is no mechanic… 1st those are clearly Case Bolts… 2Nd NEVER USE ANY TYPE OF CORDLESS GUN ON A OIL PLUG…

It seems like you don’t answer questions, but I'll try anyway. When I turn the key, the relay clicks, but no crank. I've changed the starter, and battery. I'm getting ready to try this change now. Did your relay click?

Can this gear oil be used in place of the 85w90 synthetic that xpro told me to use for my Bali 150cc? I can't find 85w90 synthetic oil anywhere not sure they even make it

Likely just need to free up the float and NOT replace the whole mechanism. Common issue.

It’s xylene, toluene, and acetone mostly so be careful. Old engines should be completely fine, but anything with plastic or nylon could be porblematic

Great video! Thank you.

Lid sealed to vacuum?

You flush the same SUV engine with Liqui Moly and Motor Medic at the same day?

My brother broke the turning signal completely off after he put W.D .40 on it to loosen up to make it work. Help. NOW WHAT? please !

It would be great to get into a more complex blinker issue, such as the blinker working fine on the left side REAR, but nothing at the front, and the blinking is in RAPID mode, meaning the system has detected that one of the blinkers on the left is not working.

I use the bottle version instead of the pressurized can ... I do all types of hvac work and I like to add a stop leak to any system even if it doesn't have a leak so it has that added level of protection if something were to go wrong or the valve core at the fill port loses it's ability to seal properly This is a great product that can be used in refrigerators and walk-in coolers as well as long as they use r134a With r22 and r410a systems I use a different brand of stop leak to give that added level of protection Some people view a stop leak as a temporary or inadequate method of repair and I for the most part agree ... but it works

You are the MAN

The problem was that that brakes got stuck all the way open, I think. Perhaps due to dried fluid or debris behind it. Once you broke it so they could move again, they could automatically adjust again. Another symptom is probably that the brakes would always be on when hot before this happened. A faster way to fix would be to just move the pads with a screwdriver while they caliper is still on, if my theory is correct. Thanks for sharing.

great video..

Best explains, thank finally repair our scooter 🛵😃🙏🏻❤️😎thanks my friend 🙏🏻❤️✌🏻😃

Thanks not 20 secs in I figured it out lol wire pulled out of the connector 🎉 thanks mate

On a 2003 expedition, replaced 2 flashers and the 4way started to work but the blinkers worked for a while and then stopped. Can't figure out what to check next, fuse is good. Could touching tye wires burn something else

My cylinder leeked when i checked rubber. Drum brake. Pedal hits the floor. No stopping power now.

I've never tried the Trans-Tune! But I'm a FIRM BELIEVER in SEAFOAM ! My car old 98 f-150 4.6 had 214,000.9 on it and it had a light ticking in the engine, when 1st started in the mornings, it would tick for just a little bit and go-away! I read somewhere, to add 1 ( 1 CAP FULL , PER QUART) of Seafoam to the crank case ( OIL ) I ADDED YOU 6 CAPS AND I NEVER HEARD THAT TICKING AGAIN! ( ALSO ) I 'ALWAYS' USE 1 CAN PER MONTH IN THE GAS TANK AND IT JUST ALWAYS RAN GOOD, NO THROTTLE HESITATIONS OR THROTTLE RESPONSE SLUGGISH-NESS EITHER! WHEN I 1ST TRIED IT, THE ENGINE WOULD STALL @ Stop light, and would just puke-out on you, when you laid your foot into it, for fast excellerations, to pass a vehicle or getting the jump on a Chevy at a "Stop-light" AutoZone coded it up and their diagnostic opinion was, it needed a $35 idle control sensor, I didn't have $35, so I purchased a can of Seafoam, poured it in the tank and NEVER - EVER Had to buy a idle control of sensor! THANK-U, SEAFOAM PEOPLE!

Oh so don't use a garden hose and start the scooter spray all the electric and carburetor and last open the gas cap shove the hose in.and go to lunch. Come back and you have a nice clean scooter inside and out 👍.gotta go the big yellow bus is here pick me up. Yay crayon day my favorite is orange they taste just like a fresh orange. Bye bye .beep,beep

How can I open a round lock made Torin

It's a petroleum distillate, of course it runs on it.

Just to let you guys know I bought a fuel sending unit from eBay, and the wires were reversed. I had to switch them on the connector.

Hi Joey , thank you so much ! I don't have the money right now or do I even know what to do ! You helped me as much ! I wish they had taught vehicle maintenance in school. I'm 67 , and don't really have anyone who could help. Keep up the good work. God bless you !

Bro thank you for this video fr

Did you ever have another meltdown with your relay? Like it actually deeper issue? Like maybe the rectifier?

7 years later, you’re the man for that website shout out. Thank you so much!!!✊🏽

I so much appreciate 👍😘

jOEY, JOEY, JOEY, THIS WAS NOT A REVIEW. It did tell me how to screw on the antenna and that is about all. How about programming, etc.

can you send me a link to video that talks about all the wire and pins on cy units?

I had 2 tires doing that and discount tire said the tpms is reading but they dont know why they cant get them to relearn

You look like Mihouse.

XS650 I’m going to try it on mine thanks

The other guys video i didnt learn a thing. You had that camera in a great spot so i could understand whats going on.. And put ya a 18 inch windshield on it. I did on mine and its a no brainer. Especially in the cold air.. Best thing i ever put on mine 👍👍

Hey Joey. What if the turn signals work but do not make any noise? Can you help?