Hi, can this exact hub be converted to thru axle? Thanks
@juanvinavarro9146Ай бұрын
Por favor, serías tan amable de indicarme, ¿Donde poder comprar, esta pieza que fija el Eje para poder desatornillar la otra parte del buje???? Por favor
@juanvinavarro9146Ай бұрын
VIVA TÚ!!!!!! Acabas de darme la solución. Muchísimas gracias
Excellent instructional video. All images are clear and easy to grasp the steps. What tool is used to pull the free hub bearings?
@Cykelmyggen722 ай бұрын
Is there two versions of this Shim t47-ib tool? It’s because I have 16 teeth on the bottom bracket shell? Does this 12 teeth work with it?
@user-jt4iq6sm3j2 ай бұрын
สุดยอดครับ
@user-jt4iq6sm3j2 ай бұрын
ขอบคุณครับ ได้ความรู้มากครับ
@MrJwmurph2 ай бұрын
Is it good to put the wheel on the bike (with closed QR) before adjusting the preload and tightening the locking screw?
@craiggreen4388Ай бұрын
I would do it off the bike, the tension caused by a tight qr skewer may cause extra stress on the fine threads/soft aluminium. What is more important is that you recheck the bearing adjustment after a few hours riding. I've had lots of Fulcrum wheels, the hub bearings always seem to loosen off after a rebuild, if not adjusted the bearings & hub will suffer.
@kaewsena35572 ай бұрын
ถ้าจิตสับจานด้านในเป็นเพราะอะไรครับ
@JL-od4wg2 ай бұрын
This look complicated seem like required lot special tools.
You can use a quick-release skewer, tighten by hand. Or buy a skewer that can be tightened with a 5mm Allen key. Or just be an animal and use a hammer!
@nash10723 ай бұрын
☝️ Promo_SM
@JohnWick-pw1jt3 ай бұрын
ไม่ต้องตั้ง H L ใช่ใหมครับ
@Gledii3 ай бұрын
your video might have just saved my wheel :P. after removing the bearing i thought that it was already in place but the axle was loose and i couldnt figure it out why...just needed a little push :) BTW, i just got a new wheel and its engaging a little while coasting. should be this normal with new hubs?it seems that tighter it is on the frame, stronger it holds the cassette on freewheel...cheers
@LhDiy3 ай бұрын
Nice assembly, thanks ! Do you have video's of Mavic Crossmax I and Crossmax II also ? I did not find. Or similar road rear hub type.
@adsali033 ай бұрын
What grease did you use? Aren't you meant to use dt swiss special grease ?