Boss alin dyan sa fuel pump?

Awit

Saan Ang sa hazard po sir?

Do you have to take the valve cover off to replace the timing belt and water pump

Is this the same location on a 2001 CRV?

How do I dismantle this type of a fuse box I need to check cables inside

Hi. Lock tyre set as straight, before change?

Brother please i need help with my distributor wiring i wanna send you photos so you can help its urgent plz

👌👌👌

Very good❤❤❤

Good❤❤❤

sir lahat ba ng suzuki every wagon DA64W pare-pareho ang water pump type?kasi baka maka order sa Lazada then hindi umobra sa multicab ko.salamat po

Hell, a fucking monkey can make it fix if you break one of the prongs.

sir san po naka connect yung malaking hose nayan sa carburator po kasi jan po nalabas yung coolant ko di ko alam kung san po kakabit sa baba

Eeiiii wow

Good or bad

Ilang kilometers po ba bago mg alarm sa dashboard para palitan ang timing chain ng innova 2.8?

Can a 1SZ-FE 1.0 be swapped with a 2SZ_FE 1.3 without major changes?

What a spanner..

My problem is that the car starts fine but while im driving it starts losing power and soon after check engine light comes on. At that point the car goes limp mode but doesnt cut off immediately. I still get a few minutes to pull aside. I changed a number of sensors related to issue (knock, throttle body and the pedL position sensor). The problem only goes away for a few miles. Comes back as if nothing changed. My mechanic did change the pedal sensor but I dont think that green thing was present. Ill check myself and try the repair. I really hopes this works. Thanks

Nmax non abs 2022 dengan aerox non abs 2022 apakah sama untuk ECU nya...??

Honda Accord mag kano po kaya magagastos 97 model

Sir ano ung sukat ng pulley bolt ng 4jb1 ung sa crankshaft niya

Hi what is the size of crankshaft pulley bolt thanks

Usually done when you car jerks when shifting from low speed to high speed

Sir hingi po sana ko ng tulong yun pong trooper w/ 4jx1 ay may rough idle , up & down ang menor ano po kaya problema nito . Salamat po !

El mejor video q vi soy de argentina estoy x restaurar un toyota celica 1.6 mismo motor q el vídeo

Is this a non-interference engine?

Good❤ very helpful 🎉

Nagpalit napo new modem pero nag blinking parin

pareho lang po ba ito ng 4g33? ano po mga kailangan palitan kapag nagpalit ng timing belt? pwede niyo po ba enumerate? maraming salamat po

Magkano nagastos nyo sir pagpalit ng bagong spiral cable?

Wat is the part code number of the orig timing belt?

Isuzu bighorn now used km 200000over for what can engine oil 15w/40

Ini 1.3 cc ya

Pag May check engine error po ba spark plug ang cause

Good day bro,I have a wiring connection problem running to the Distributor from the main power connection.I have two wires with different colours like green with black stripe and green with red stripe.By the way,where will I connect them to the Distributor connection.Distributor has only red,blue,yellow and white .So how can I connect these wires onto each other to start the engine.

Master Pwede Po testiran Yan ng multi tester or testbulb Tanong lang Po?

Did u change the relay or can just take it out and put it back only?

It sounds like Oil is not getting where it should as fast as it could. It would be recommended to use Liqui-Moly Oil Additive to protect these parts on cold Starts, Also, Even thought most oils protect during cold starts, the truth is that, if your oil pump mesh is clogged, It will not be able to provide a constant oil flux and so, it may result on premature wear in lifters, camshafts and crankshaft, just to mention a few parts, besides cilinder walls and rings.

Asi roto lo monto yo😂

Bos magandang Gabi powedi mag Tanong Kong bakit maingay Yan at sa akin ay pomotol Ng balve gaid so bakit bos tolongan mo Ako Kong bkit 1':3 pomotol

Hi po .. i have Pajero 1991 diesel engine 4d56 ..can you please let me the genuine P/N of the timing belt, timing belt tensioner, balancer belt and balancer belt tensioner...thank you

How many miles did your engine have? Thank's for the video and your answer ❤

🎉

Salamat

❤

Ilang mm po Yung tools na gumamit mo pang baklas idol

That’s a spun connecting rod bearing. Aka rod knock. If it was valvetrain. The noise would be half speed to engine rpm. Thst noise is 1:1 with rpm…..

Vendo filtro varato