Good video thanks

Mine only alerts me for a very short amount of time ONLY after the vehicle starts back up after engaging in automatic shutoff. when I release the break go start moving again, the message appears and the alarm sounds very briefly- half a second-then goes off.

Well, not having your tire sensors activated cause your check engine light to stay on in an equinox 2011

i got a 2018 homda accord 1.5 my mechanic changed the 4 spark plugs, 4 ignition coils, and air filter and still goin into limp mode what do i do?

My toyota corolla 2002 shuts off when you not accelerating especially when engine cools down or early morning start.

I replaced the fuel rail pressure sensor on a 2019 silverado 2500 4WD HD and tried to clear the code and it didn't clear and didn't start either.

Thanks for describing the symptoms in such detail . Very helpful . Cheers.

Nice ….. next video and not only on roto like other video

Where's my switch on my 2019 Chevy Impala at

I have a 08 dodge avenger and I can't find my ac pressure switch 4:13

Great video the host is great!

Y

Where is the PCV valve on a 2020 Acura TLX 2.4 Base model?

So much yapping just get to it

Youre amazing ! You saved us a lot of money and taught us how to fix my car ! Thank you for posting this video with so much detail and also teaching us about the ac / heater unit in it's whole. We are so thankful for you !

I have a 200 Chrysler 2013 2.4L where would it be

Could a defective brake switch cause limp mode and immobilise a car?

Best and simple way to avoid all this is Just buy a petrol car problem solved . Modern Diesel engines are pure shite and Ur not saving money by buying a diesel car .diesel cars are shite .please read this twice till it's inside Ur brain ok.

Or you could always go to your local garage and they will happily test your battery

Good video. I am having a problem finding the oil sensor on my BMW520 diesel 2014 engine. Any video showing where it could be located.

I don't think a chevy hhr has one. Can;t find it.

i like this guy explains pros and cons very well in all his videos 👍

hey i really need your help how can i contact you i have a video of the issue happening with me please help me out sir

Low pressure side is the large tubing, high pressure is small tubing

Could you please provide advice on how to hook up the scanner? I would like to know if I can acquire a scanner so that my car will at least tell me what's wrong. After weeks of not being able to use my car because it wouldn't go and waiting for the service center to fit it in for a diagnostic (they were quite busy since the scanner at their other center wasn't working and they were doing the work of two centers), and the car finally getting fit in and being in there overnight, the actual problem ended up being blown brake light globes and a faulty light switch, costing me only $8.00 to have fixed. I spent weeks stressing about how bad the damage would turn out being and having no car to drive.

Nothing

Did anyone else see the giant spider crawl through the video

Who gives a shit about his hand. Listen to what you can learn from him

great video! you guys rock!

*My friend, many of us need video on repair of ELECTRONIC PARKING BRAKE FAULTY UNITS and how to diagnostic and repair 😊 renault car are the big problem*

I have a chevy cruze. That stability track was blinking and it stays on. If I go over 2 on rpm. My car say engine power reduced. I have taken it to dealership several times. I have to pull over let it sit then crank again. Please help. God bless everyone ❤

Super helpful for me to know to not change the sensor.

Thank u sir!!Good video✌️✌️✌️

Hands pissed me off. Couldn't finish the vid

so i did get the p0335 code and my car has been stalking or stopping on me and even check engine comes and go . so they say it’s the crankshaft sensor. u guess my question is how do you know if it’s the front or back crankshaft sensor . i have a 2014 hyundai sonata @mechanicbase

I have the same issue the code but my car takes long to crank but I have no other light the dash is clear but it just takes to turn on like 3-4 seconds and runs normal until I try to turn it on again

I need help locating the AC pressure Switch on a 2011 GMC terrain 4 cylinder. Any help would be greatly appreciated. Thank you

thank you 😊

Loved this. Tried battery method. Great tips

Very helpful.Thank you!

location of CSPS 09-11 buick lucern cxl 3.9

Hi, please help In a hard stop, my car wont go forward till I press the gas pedal to the floor, in other senario from a parking, I shift it to drive with no pressing the gas pedal, it forwards but when I shift it to drive with pressing the the gas normally like 10% to 20% it stops till I press it a 100% again then it forwards [Automatic car] Changed/Replaced: -Transmission oil -Engine oil -Oil Filter -Air Filter -PCV -IACV -MAF -TPS -O2s -Spark plugs -Battery Cleaned: -Catalytic -Exaust -Throttle body What else I'll do, I have still the delay acceleration from hard stop. . .Hope this comment will be notice :) :) :)

Can you help me locate the PCV valve for Toyota Vitz

You talk too much.

Hard to shift first gear and reverse, what seems to be the problem?

HI THE TRUCK 80% BLOW HOT AIR SO I REPLACE THE AC COMPRESSOR EXPNSEN VALVE AND ALSO THE PRESSORE SENSER , VACUM THE SYSTME AND RECHARGE THE FREON , BUT THA AC COMPRESSOR KEEP ON AND OFF FOR A MINUTE , DO YOU KNOW WHAT IS GOING ONG WITH SHIS AC SYSTEM

i have e36 320i engine cutting out when slow down top stop

Thank you boss, ur symptoms are same as mine, I think the sensor is broken. Engine switches itself off once warmed up

The problem in my car is that the compressor stops working altogether when the temperature outside is over 80° F, and it comes on sporadically if the temperature is under that but even then it mostly doesn't work in sunlight! This baffles me! I'm not sure how the outside temperature affects when the AC compressor is working? But when I looked at the pulley, every time the compressor turns off, the pulley completely stops! It doesn't idle with the clutch disengaged it just completely stops when the compressor is not working! Is the clutch still the problem? Is it stuck in one position so that if the compressor is turned off, it doesn't spin but if there's enough friction on the belt, it will start spinning the clutch and the compressor? My AC might be a little more complicated because when it's working, it still works when the car is Auto stop feature comes on and the engine isn't running?

I have oil pressure warning on BMW E93 when oil temperature goes to 96 Celsius .Every time is like that ,No warning until it gets to 96,engine is 2.0i