Cuando se frena se siente en el deadpedal cierto movimiento.

if you decided to add a second mic, will it work with both of them ?

Somebody told me if i have the 7 inch screen and swap to 8.4 i need to install also antenna for nav and remote start app wont work ? True? Thanks

But The orange to be connected to the turn light no?😂

What size bolt did you use for your fairlead? I picked up a knockoff and it didn't come with any bolts. Great video!

What size are the origi sl screws that hold the jk OEM tranny skid plate

8:32 !!! You made a subscriber out of me!!!

WEELLL nobody has seen this deal in action?

A cordless impact gun & ratchet makes this job so much faster & easier. It was killing me watching you work with hand tools

Is it possible to remove the metal ring on the front of the rope?

What a waste of time. How can you do a video about antennas and not test out the reception?

Why did you say made in China? RR told me made in georgia

Is it just plug and play? And is there a security code or anything when installing?

Do you know if you can use this mic if you are recording on a phone?

Thanks for the video homie! Maybe you can help me out? I’m going to mount the head unit for my Kenwood ham radio with one of the 67 Designs or Bulletpoint dash mount systems. I’m placing the head unit so the top of it is flush with the dash. I want to see if I can pop off the bezel, cut out a tiny half circle so the radio cord can fit through and then I want to run the cord down through the dash to the control unit. It looks like there is enough space (with the bezel popped off) to where I can run a cord to the left or top of the screen? Thanks! - Geoff

I just received mine and will use your video for guidance. Do you have the off-road pages as well? Thanks for the video!

Liked and subscribed

What percentage of tint did you go with?

Hey man I have a question if you have the time . I have these but mine only came with one harness. Can I still wire them up or it needs the harness to make the drl and turn signal work. The actual fogs work fine but I don't know exactly how I can make the turn and drl lights work without the harness. I'm not a wiring master so if this question sounds stupid I'm sorry. Lololol

good video link to buy one

Lovely review Thinking of getting this after watching this I would

Well done!

I’ve been researching lights and wondered if you happen to have some pictures or a short video of just the Auxbeam 3” a pillar lights on at night to show the light pattern and how far they light up down the trail? The only videos that show the lights on of yours I have found is the ones with them pointed at the garage door and also the video of the bumper light install. Would you still buy these lights again? TY!!!

Can you give a 6 month update on the Carchy? Would you spend the money and purchase it?

struggling with the $1000.00 not sure i will get the value to make pencil for me thanks for the video!!!

Congrats. I do have a question and if you have time to answer thanks. The Amazon factor 55 knockoff. Is it any good? How has it been holding up? I hate to save money and not get the factor 55, but you sounded like me, when you said family and new truck and need to save on some parts.

Thanks for video from İstanbul.

Congratulations

Great video bro

Ordered December 29th - still on backorder as of today, estimated ship last week of February.... 😑😑

Great video, Thank you. I can’t get my lose with a deep 13mm socket and an impact driver. It’s actually stripping the nut. Any ideas?

Can you link 2 mics to the receiver

Such a great review, thank you so much for making this. Extremely authentic and real!

What year jeep was in video? I have a 2011 Jeep Sport (2-door) which only has one retention clip on each front side. I believe later years had two floor hooks, so concerned about compatibility.

You mean like spending the $1000 to visit your bud in BC bitch?!

I bet you like it bigger. 😂

Shut up! 😜

Wat does it matter, Corona or influenza? Bith can kill ya, but dat 'rona tis much weaker!😅 😅 0:29

My dealer just told me this was not possible on my 2023 JL, but your dash and screen look identical to mine. Any idea if this is applicable to my Jeep?

Dd you disconnect battery?

How did these end up working out? Would you buy again?

Awesome video sir! New subscriber. I've been working on getting gear to start my own channel, and this definitely cemented my decision for which microphone to buy!

Awesome video will the back up camera still be as clear?

Great unboxing and good review. What canon is that?

Crazy about the (poor) powder quality on those KC brackets. They’re going to rust, and fast. Wonder if it’s worth bedlining them right away?! No point buying brand name brackets, thats for sure. I will say that KC light warranty is excellent, though. I’ve used it a few times.

Soooo…. Did you guess the right adjustment holes? I’m 6’2” ish as well, and wondering if I just go with the same ones or change it up a bit…..

Great idea, how long is it? I would like to cut one.

Also where did you get the license plate bracket?

Hi great video. Did you use a 1/2 impact gun or 3/8? Thank you!