I always look forward to 'its Friday, it's Barkspeed'.... Run VT Erol! 😁
@alanbyrne28783 ай бұрын
Hi Keith, it's AL here from Bexley Village , first time viewer - Great Video ...I'm all subscribed now too , so will enjoy the rest of the journey with The 'BLUE' Mini !! 💙 AL
@barkspeed71353 ай бұрын
Welcome aboard!
@philhuggett47764 ай бұрын
Brilliant stuff.! 1293 with all the mods will be lovely 👍
@rolandsmith21414 ай бұрын
I’ve run the “green pipe” for 2 years in a workshop heating situation ie lots of hours, nothing wrong with it. There is no resistance at the burner so why you pipe is flexing I can’t imagine
@malcolmlatham-bennett9314 ай бұрын
Great job, what type of paint are you using, 2k etc
@barkspeed71354 ай бұрын
Hi yes 2k first time and its very easy to apply with a 1.4 paint nozzle in the gun
@clivemillington84524 ай бұрын
Whoops 😂😂😂😂
@clivemillington84525 ай бұрын
Yet another good vid . Well done , I love watching your install sir 👍👍👍
@barkspeed71355 ай бұрын
Thanks 👍
@alantrott82665 ай бұрын
Should have mentioned what paint you're using, may get freebies.👍
@TheAlphamoonbase6 ай бұрын
Dear friend ! Thanks for the video, but unfortunately the filter is installed upside down... Just turn it over... Greetings from Hungary! :)
@barkspeed71356 ай бұрын
Ok, thank you
@troy71246 ай бұрын
The pump angle is completely wrong and you're exhaust is absolutely horrible
@bellofiore8946 ай бұрын
Put the filter just down the pump
@bellofiore8947 ай бұрын
👍👍
@The-Mandolorian7 ай бұрын
Hi, thanks for the video. You mentioned that you burn about 5 litres of fuel in 14hrs. What setting is that on? 1-6? Low-high? Thanks
@barkspeed71357 ай бұрын
Hi that quote was from another guy who did very accurate testing. I found that if you use 3 this is the most affective.today i used just over 10mm on my side gauge and was testing the different settings Also my 2 m exhaust pipe came and i have installed it along with a stand aloan temperature sensor and a carbon monoxide monitor (this is a must so please if you haven’t got one buy one £18.99 from screwfix) With the outside temperature at 9 degrees i managed 21 degrees in the workshop
@andyalisonmusic53712 жыл бұрын
Keith I’m onboard looking forward to it.
@andyalisonmusic53712 жыл бұрын
Hey Keith I’m signed up and looking forward to enjoying your work. Thanks for the great Blink job. Andy Rochester.
@peternewport95603 жыл бұрын
Cleco pins will hold the panel in place. A piece of copper bar behind the hole will allow you to weld the hole up. The weld will not stick to the copper, leaving an almost flat weld.