Well played...👍

Uhm quick question: How did you remove the radio? Do you have a video on that? Would help me a ton!

I have to admit, I though that looked janky as shit but you can't knock it till you try it so I tried watching instead of trying a new food and low and behold I found a gem. Kudos man, you earned it.

Thank YOU

Wow well done man. Where do you learn this electronic work? I want to learn fast

Thank u for this video 👏🏻

HEADS UP! Do not use this oil as he said it has friction editors which should not be used in any of the CD VQ trannys due to the synchros having a copper coating that will be eaten by these extra friction modifiers and cause synchros to rust over time. U can use this for the diff not the tranny!

Hey bro, you should be ripping the new zealanders with adrenaline r resonators ! I'm ordering the resonated y-pipe from TMR performance over in NZ

Can I get the link to order that exact one been looking for a spoiler for my g35 for the longest and I don’t want to get a duck lip one like all the other g’s have em 😭

I use my AC alot in my 350z in the summer time it can get up in mid 80s 90s in NY state

Would it fit on fuga

My hose near intake is just disconnected would it cause any problems ?

Mobile 1 oil is the best !!

just tried this on my 2008 350z after trying many other tips but the light continues to flash. 2.2 ohm @ 0.25 watts

The valve seals are gone, happened to my old motor. Not a massive deal really if it's just a track car, just need to keep up on oil changes after track days.

In the thumbnail ai??

Hello, I was analyzed your YT channel and I saw that in your channel have some problems, that's why your channel is not growing. Your videos is not reaching to targeted people, not getting engagement. Do you want to know these problems? If you can give me permission I can tell here, . Where Can I tell? here or email? Anywhere I can tell if you give me permission. If you want to know, if you want to go so far with your channel. where? twitter, fb, ig etc.. where can I tell? If you want to know. As your wish, if you want, not my profit, sO,??

Hello, I was analyzed your YT channel and I saw that in your channel have some problems, that's why your channel is not growing. Your videos is not reaching to targeted people, not getting engagement. Do you want to know these problems? If you can give me permission I can tell here, . Where Can I tell? here or email? Anywhere I can tell if you give me permission. If you want to know, if you want to go so far with your channel. where? twitter, fb, ig etc.. where can I tell? If you want to know. As your wish, if you want, not my profit. Want???

Hello, I was analyzed your YT channel and I saw that in your channel have some problems, that's why your channel is not growing. Your videos is not reaching to targeted people, not getting engagement. Do you want to know these problems? If you can give me permission I can tell here, . Where Can I tell? here or email? Anywhere I can tell if you give me permission. If you want to know, if you want to go so far with your channel. where? twitter, fb, ig etc.. where can I tell? If you want to know. As your wish, if you want, not my profit, So, want?

what size hardware did you use to get it out?

Thanks for posting this. After 21 years I think I was a bit overdue to change my power steering fluid for the first time on my 2003 g35. I used a similar method, but I’d like to share a few additional tips to save time and make the job a bit less messy. I used the same method to disconnect the return line from the reservoir after first emptying the old fluid using an oil pump assembly that normally screws into the top of an oil can. Using a hand pump really let me get the vast majority of the old fluid out also by tilting the reservoir to one side after sliding it off its bracket assembly. To make a little more space to work, it is very easy to remove one screw holding the coolant reservoir and then slide the whole reservoir up and move it toward the radiator temporarily (without disconnecting any of the coolant lines). Next, instead of running a makeshift funnel down through the engine compartment, and below the splash guard, it was really easy to just take a one quart empty plastic oil bottle and pop it onto the disconnected return line for the power steering fluid, bending the hose down slightly, and place the quart/liter bottle as the receptacle for the power steering fluid coming up through the return line. The receptacle for the fluid could basically sit in the same space as the coolant reservoir normally sits. Using this method, it was really not even necessary to jack up the car at all as everything could be done from the top side looking into the engine bay. All the other steps were the same. No messy dripping, and no jacking the car, no removal of splash guard.

I hope this works my g35 got the same damage but a little worse and behind the tail light as well

t6hanks bro u helped me alot

Yessir looks great 👍

Clean 🧼

Your steering wheel is absolutely marvelous

This just worked for me !! Thank you !!!

hey man where did you get the fitting for the oil filter did it come with the guages or did you have to buy it separately

Congrats bro!!! I love these G35’s. Great videos by the way. Thank you for that video about adding the aux cable to the stock stereo system.👍

Noice. Thanks for the vid. My sons will put these in asap

I bought a 03 with injen intake for 1800 200k dash still strong

how do i get a 350gt in Massachussetts

You need a new hood and headlight

if you sell parts lmk, is the front bumper nismo ?

Wheels looks like other Infiniti wheels newer car, I think it looks clean spacers perhaps

I’m pretty sure the wheels are from the Nissan Fuga, I could be wrong tho

2017 Ford F150 XLT Supercrew. Which resistor would I use.

Great steering wheel! 🫡

I got this customized and put into my skyline 32

Very interesting accent. I’m picking up Vietnamese/ Australian.

Hey are you still answering comments? I was wondering if this would work on an 04 350z with nav

Delete the water pump for +35whp and better exhaust sound

How about the other airbag.. I mean in a car have two airbag. The left side airbag is the busted.. The steering is OK . Do I need to disconnect all sensor wire or 1 side only to put on the 2.2 ohms resistor Thanks

Ordered a kit because of this video lol

I replace the fuel pump and sending unit. Now it reads full and wont go down. What else could it be if i replace both units???

Guys... 0w-XX exists. Use that version, it'll circulate faster.

Also i dont have the tv button i have voice 😢

Will this work on My 07 g35 coupe? And the plug that you remove from the tv tuner what dose it control. And do you plug it back in. Also if I don't have a tv tuner what would I plug into

This is a must thank you bro earned a sub

Too much work tbh for me but I like fighting my door and having a bad day