Ryan

Пікірлер

@chrishallinan5176 2 ай бұрын

2024 this is still useful thank you my guy! 🙏

@Cheesevirus 5 ай бұрын

Lel

@Luke-kr7cv 5 ай бұрын

new link? please

@jayz02 7 ай бұрын

what is your keyboard model, thanks you sir for video

@Thumos99 7 ай бұрын

Thank you

@ratchetclan3 7 ай бұрын

You’re welcome ❤️

@j-man6001 7 ай бұрын

Ronnie Cox will always be the most badass bad guy in my twisted heart!

@HannahLees92 8 ай бұрын

Mine are working. I however cannot get warm/hot air!! I’ve done everything. It’s driving me absolutely bananas!!

@johnhayes420 4 ай бұрын

That can be a faulty thermostat.

@Enigmonkey 9 ай бұрын

Not sure if you still monitor this, how come you spliced into the fuses rather than just using whatever power source the previous radio used? Surely there's already a cable in the radio compartment which can provide the power

@user-og8eb8rb2x 10 ай бұрын

thank you

@DocTime56 10 ай бұрын

Thank you, I needed this today,

@TheOrangeMan13 10 ай бұрын

I’m dying from laughter

@catello4390 11 ай бұрын

Anche la mia Opel Corsa diesel, ha queste aperture che fanno pena come materiale, sono andato alla concessionaria, x comprane una nuova, ha detto che ci vogliono circa ( 80. Euro) che vergogna!!!!😮

@hooperb63 Жыл бұрын

Hi Ryan what did you do with the orange illumination wire please

@DanDavie Жыл бұрын

Thanks!

@tcm2911 Жыл бұрын

Yep sure enough tried this and the switch broke. Oh well!

@kevinclarke8900 Жыл бұрын

Quaid to Cohaagen: "Give deez peeple ayrrr!"

@livewireOrourke Жыл бұрын

For some reason I misremembered this being in Robocop...

@Meinkampfmusicgroup Жыл бұрын

hello , do you know the maximun tyre size that can fit in this frame ?? 700x32 maybe ?

@bigeasyanderson1810 Жыл бұрын

He must jerk off a lot to half the forearm stamina to do this Forever

@KaoutarErrahmani Жыл бұрын

when i took my Z key off the scissor switch was in the Z key and not in the keyboard itself

@TheBoneHeadClan Жыл бұрын

I think that sounds good, but could maybe be mixed a little better. It doesn't feel like it has the same punchiness as the original. I also wanted to ask if I could use this in a video? I can use the uploaded file, but would you be willing to share the FL Project file, so it can be edited too?

@domtinsley8791 Жыл бұрын

How do you remove that black clip

@paradise89 Жыл бұрын

I know this is 11 yrs past right now but the computer aesthetics are so nostalgic

@tomoprime217 Жыл бұрын

How do you get the key off? I have an alphasmart neo2 and I learned it uses scissor switches. My issue is my spacebar uses 2 switches and the right side stays depressed or stuck. It still presses down but the full travel is gone and doesn’t reset to match the left side. No spring to it.

@joeyblack5402 Жыл бұрын

I’m struggling to connect my swc to my key1 and key 2 wires from my radio. Any ideas on where they would be situated?

@myself3115 Жыл бұрын

Thx Ryan replacement unit in place!

@stevemurray710 2 жыл бұрын

Living in USA I need new brake lever hoods. Generic at all? Son is going to UK if he needs to find them in UK.

@ratchetclan3 2 жыл бұрын

I believe these are them 365cycles.com/products/microshift-external-routing-drop-bar-lever-hoods-black-pair They are not generic, the shifters are Microshift

@edwardnable 2 жыл бұрын

Hello my aircon front is nothing out of air? But the air is diverting only in dashboard.. how to fix it..need your help..thanks

@oscarr7364 6 күн бұрын

Yeah I’ve got the same issue, the right spindle is probably broken so you’ll need another climate control unit like this guy got and replace it.

@sonnyday6210 2 жыл бұрын

Only problem with this is it goes off when you turn the ignition off, there should be a wire that is live with the key in

@GipfelKuh1905 2 жыл бұрын

I got an aftermarket Sony Radio and I can‘t get it started for shit - Any chance you could make a tutorial on how you connected this red wire?

Жыл бұрын

Hopefully you never gave up on this. Red wire needs a +12V source. Preferably you'd want to tap into somewhere that gets turned on when you turn the key to the ACC position (e.g. car lighter). More details here preciouschicken.com/sonyincorsad/

@GipfelKuh1905 Жыл бұрын

@ I did not, but it probably took significantly longer than necessary. I got it working the same day, it just won‘t start/stop using the ignition. I didn‘t not forget to manually turn it off yet at least 😅

@GipfelKuh1905 Жыл бұрын

@ I‘ll check out this guide, I literally spent hours looking for something like this

@wildviper883 2 жыл бұрын

Epic 🖤

@sashayy19 2 жыл бұрын

can i ask where you got these new ones from? i need to replace mine too

@rreuno 2 жыл бұрын

needed this. thank you.

@edwardcooper1831 2 жыл бұрын

Poor Ronny Cox looking like a gigantic weirdo when he's only reading the lines given to him

@yeeetchunguse461 2 жыл бұрын

Now this is Minecraft

@chazwalker7156 2 жыл бұрын

Hi pal, just wondering if that 5 pin conecting socket there (at 0:19) has corresponding numbers embossed next to each pin, as that socket there (at 0:19) looks the same as the connection socket on the heater blower resister < this resister socket has the said 'embossed numbers' (1 to 5) at the side of each pins... If so, do you think these numbers correspond for each coloured wire please? Reason: I'm replacing a melted plug and resistor on Corsa D that has been previously done - the wire colours are different on the new plug and I think the previous attempt may have cross wired on at least 1 pin causing the melt/scary burn??

@ratchetclan3 2 жыл бұрын

Looking down at the unit so the way I'm holding it on the video the wires running to that connector are coloured left to right as Black, yellow, green blue+red, orange The Blower resistor connector is yellow, green, blue+red, orange, brown Black ground wire for heater resistor should be in the loom to connect and same for the brown for the AC Controls which yellow green bluered and orange are connected but shifted 1 pin along to right as remember black is now in the left slot

@ChihuahuaKawaii 2 жыл бұрын

3:26 sounds like an elf grumbling about something lol

@SonicGamingTV2019 2 жыл бұрын

your tried

@johndixon4851 2 жыл бұрын

very helpful but can you point out front suspension arm /rear most bush my car failed mot for it would be very greatful

@fahimkamali5341 2 жыл бұрын

Hi which fuse did u tap into? Is it the 2nd last one on the right hand side? The 3amp ?

@justjo190 2 жыл бұрын

Which fuse did you piggy back this to in the fuse box?

@zaferbayaram3956 2 жыл бұрын

Meeeoooowww

@jxckbrxwn03 3 жыл бұрын

I never got the 12v thing for the red ignition cable where do I go to get one mate?

@deankakolewski 3 жыл бұрын

This song is a masterpiece, even if it was only made for the game

@djmillzy7486 2 жыл бұрын

The production is that good you can’t even tell. More than half the tracks they made were absolute bangers. Whatever - Good thing is probably the best one!

@gianfarma2546 3 жыл бұрын

Are you able to turn the volume up/down from the steering wheel on the new radio?

@vexacore8647 3 жыл бұрын

I need the flp

@truthguard9286 3 жыл бұрын

The original and best menu music

@kdee1428 3 жыл бұрын

Really cool

@so479 3 жыл бұрын

Come back pls

@ratchetclan3 3 жыл бұрын

What 😂

@so479 3 жыл бұрын

@@ratchetclan3 i dont like when ppl stop uploading

@Bluewave42 3 жыл бұрын

Two years ago I took my 2010 Corsa's centre console apart to replace two tiny bulbs behind the controls. I unbent the bowden cable, put grease on the heater matrix gears under the dash, and it worked... for a month, until it snapped! I bought a new bowden cable set (OEM part 93189466), cut my hands up again fitting it only for the vent dial to shortly stop rotating again. I suspect it's got bent due to the heater matrix vents being "sticky" with old seals and thus hard to open. It's a pig of a job and I can't be bothered doing it agan. I've now left the vent dial on the windscreen/feet setting and fortunately the heat dial still rotates perfectly. In my opinion it's poor Vauxhall design to use a long, stiff cable to move plastic gears, especially as the vents under the dash get harder to move as they age. More modern vehicles use electric motors and buttons to change vent settings.

@ratchetclan3 3 жыл бұрын

Vauxhall have a bunch of weird stuff like this, the way their gear linkage rotates on an axis attached to the gearbox housing with a single split pin is also bad as it sheared on me and rendered the entire gearbox scrap. They also red locktite this bolt in so you can't tap it out... All over the car I can't find an example of a quality part, nearly everything is made as cheap as possible, even down to the door handle hinges being cast out of super cheap alloy that has a tendency to sheer. I'd say it's actually less to do with the dials as these were fine in my car and rotated freely and more to do with just how hard the actual cable is to move in by hand that causes it to snap off. Makes you wonder how these parts even pass QC do they not have a robot that turns the dials thousands of times to failure :/ With a profit of 5% per car which when these were new would have been about £1,000 - £2,000 making the door handles and the heater stronger probably would of cost them £2 extra lol

Ең жақсы KZfaq

Пікірлер