If you fill the reservoir to about 1cm from the top, when you put the lid on the rubber diaphragm will spill some out. That way you know it's full with no air gap.
@TheR100RT3 ай бұрын
Smart Hack ! Simple, well thought out.
@kemourdrummond79144 ай бұрын
How to adjusted if hard going to gear
@austendallaston35374 ай бұрын
There is no adjustment, try bleeding it making sure you don't empty the master (it is very small). If that doesn't work then replace it
@kemourdrummond79144 ай бұрын
I already change it to day just like how you do it but hard going to gear
@austendallaston35374 ай бұрын
@@kemourdrummond7914 if the biting point is near the top of the pedals travel where it should be, then it sounds like you have a problem with the clutch it's self
@kemourdrummond79144 ай бұрын
This morning I have get the car into gear I top the master cylinder with clutch fuel it drive ok thanks again
@austendallaston35374 ай бұрын
@@kemourdrummond7914 your welcome, I'm glad you got it sorted
@howwwwwyyyyy10 ай бұрын
Slave cylinder is in the bell housing, nightmare, clutch slipping badly, probably contaminated plate from leaking slave
@austendallaston353710 ай бұрын
Gearbox out, new plate, new cover and that's the time to change the slave as it is the release bearing.even if its ok
@austendallaston3537 Жыл бұрын
Mine was low and then it just gave up, have you tried bleeding it?
@martincrane5258 Жыл бұрын
Hey buddy why did you change it ? I’ve got a very low bitting point on my td4 thinking I need to replace this ????? Thanks
@davidgillett5066 Жыл бұрын
Looks like I bought the same cylinder and was thinking of doing just what you did. At least it saves time gaining access to the connector. Did the same thing on my Rover 75... Are you sure that the sliding collar isn't on the slave side of the connector?
@austendallaston3537 Жыл бұрын
Defo no collar anywhere, actually I've just changed that cylinder again as it failed internally, (cheep eBay part lol)
@davidgillett5066 Жыл бұрын
@@austendallaston3537Oh crap.. I don't need the hassle of having to do it a second time..lol..
@austendallaston3537 Жыл бұрын
My own fault, cheap part, I'll cross my fingers lol
@austendallaston3537 Жыл бұрын
Yes it does, Dot3 or Dot4
@naldocaro Жыл бұрын
Nice hack! Do you know if the cylinder use brake liquid? Cheers