ki lk

Пікірлер

@randomletterandnumber 15 күн бұрын

How did you mount your monitor? Mine just arrived and it's a bit confusing

@shavaunajolly7805 26 күн бұрын

DO NOT BUY waste of time, you can't really understand the instructions which make putting it together even harder.

@compa8806 3 ай бұрын

Interesting

@TangentalCaterpillar 3 ай бұрын

I appreciate this was trying to be helpful, but I really need a link to the construction manual

@pinoydiy8384 5 ай бұрын

Nice cool set up❤❤❤❤ i love it 🎉

@cristianpuli3598 5 ай бұрын

Cool I like your race set up

@AlienufoNEWSS 5 ай бұрын

Can we see what yu do for floor

@beowulf555 6 ай бұрын

Where did you use the tiny washer like white circular pieces?

@Tiger-un3gr 7 ай бұрын

It was not more easy just to flip the camera to the front instead of flipping the shed? Was trying to see how far or flat the roof panels aling with the front panels😢

@michiganmikeupnorth 8 ай бұрын

Do you put plywood on the inside floor?....what size is best?

@apexpredator7280 9 ай бұрын

Damn paper instruction manual made me do it all wrong

@silverfishimperitrix 11 ай бұрын

This is the worst installation video I've ever seen. Useless.

@YungBMO1481 Жыл бұрын

Your not helpful

@XxWaNt5oM3xX Жыл бұрын

Would a generator fit in this? Looking for an enclosure to run my backup generator in.

@FuelFarmandFescue Жыл бұрын

What type of screws did you use for this?

@paultew7087 Жыл бұрын

Thank You for this illustration. It would help greatly if you could slow it down a little bit! 😊

@oldcatmech Жыл бұрын

Getting the plastic off took too long, best when colder plastic did not tear as easy!! Then the anchors (s6) when you put the plastic insert flush with ground, screws too short to tighten with any grip, one or two threads on mine! Need to be 3 1/2 inches long not 3 inches!

@anisotropik 10 ай бұрын

Thanks for the plastic advice, I'll try that tomorrow morning. It laborious to get the plastic off, but I'm glad they use it for scratch protection. The screws are hard for me to get in my screwdriver strip. It takes a lot of pressure against the screw to get it to drive into the tiny holes they created.

@tellitlikeitis-rg4ny 3 ай бұрын

Leaving mine on for more protection

@dkk8967 2 жыл бұрын

Where's ya sound

@lolilachiquitalinda 2 жыл бұрын

How do you build the door? It jumped, didn't show how to do it.

@katrinajones7066 2 жыл бұрын

Can this fit a Honda 21in lawnmower

Ең жақсы KZfaq

Пікірлер