How can I test the wiring harness on Purge Valve or if multimetet can be used?

Bro thank you sooooooo much man I was tripping so freakin hard thank you brother shout out from Canada !!!

So I had a older Van one time. One day I was driving it I noticed it was hard to stop give it 24 hours I woke up to go to work in the morning headed out my drive way down a hill and completely loss brakes never before have I ever had problems with my brakes but that one day in advance. We'll in the process's I press my e brake in the floor and it by no means slowed me down it more of slingshotted me. My question is this a brakes malfunction or could it be possible someone tampered with my brakes.

If replacing it by yourself can be tricky... So like you said in your video take it to a mechanic...

Yep my Mom's truck is acting up until we were looking around for the problem... We thought it was the spark plugs but no it wasn't... So we checked around and it was the u- joint...

Hi, I have this light coming on keyless start system problem on my 2017 Honda civic. . I was rinsing off my car this morning. My window was slightly open. The inside driver door ,my seat, steering wheel was really wet. My inside of my car. Now this light is coming on. I try drying everything. What can I do to fix this? Please help

Thanks bro appreciate it

Oh yay for the internet. I found the entire solenoid for 25 bucks on Ebay and I'm sending this link to my mechanic the ol Honder is getting inspected dammit hahahahahah

What if given me these codes but my car is not turning on?

What if its abs vsa and tpms lights always solid. And the speed sensors are all good fuses are good

i had a question. my check engine light turned on and it came up as “fuel to rich”. any ideas what can cause that??

Thank you! For fellow non-Americans: when he says "half a quarter [of liquid]", he means 1/8th of a Gallon, which is a half a liter

I’ve been getting P0011 and P0340 cylinder 1 over advance. Replaced the camshaft position sensor and ordered a VVT valve. 2010 Soul 2.0 with 142k. Mobil one synthetic every 5k. I replaced the timing belt when it had 108k with Aikin kit…could it have stretched already, after 34k miles?

I drove for days with it like this tho like 3 4 days

Hello, do you have an email for contact, I would like to ask you a question internally, thank you

My 2014 Santa Fe Sport went into "Limp Home" mode, now called “Engine Protection Mode”, and produced this code at the dealer who replaced the engine. Wife and daughter were driving the car in Nowhere, Nevada and suddenly slowed to 25MPH in front of a semi on the freeway. Lucky they survived to get a 2hr $600 tow to the nearest Hyundai dealer. So.. Hyundai KNOWS there's a problem and decides to wait until it fails in an inconvenient/dangerous location to fix it - AFTER it breaks! Not happy

2018 kia forte with 89000 miles. yes crank but no start and have 2 codes p0011 and p0017 replaced - vvt solenoid both intake & exhaust - new spark plugs - camshaft position sensor - crankshaft position sensor What do you think my next step would be take it to a shop??

Can’t find it on a 2013 ram Longhorn edition

I just cleaned the sensor connection with contact spray and plugged it back up. I pulled the batt cable to reset the code and it has so far worked for me.

I get this code mainly when its cold out or the car has been sitting for awhile and i do not let it get warm before driving off. The car will go in limp mode and code will come on. Once the engine has warmed up I can shut it off and restart the car and it will drive normally. Any ideas?

Great video

BUT WHAT if expansion tank is way above maximum line, and radiator starts at full immediately after replacement radiator and fill, but the next day overflow reservoir tank is way above maximum level adn coolant in radiator lowers so cant be seen. So i siphoned off coolant out of overflow tank, then filled radiator to top level again. Went a couple cycles like that. Confuisng. 2008 nissan xterrra, which has a pressurized coolant reservoir overflow cap, non pressurized radiator cap.

Could driving through a deep puddle make it go bad

The only part you didn't show, is the only part I actually needed help with... It's the "just pull that one out" part that's not working for me and caused me to turn to the internet... the bulb won't come out of the socket I'm holding the socket tight so that I don't pull wires and I still can't get it out...

I have replaced everything you can think of what can be the problem 😊

I tried to remove the sensor in my 08 Fit and, man, the screw's torqued down like Hulk had a bad day!! Ended up stripping the screw head, then tried to use an extractor but it didn't work either. What the heck is it with people who torque things down beyond spec? If anyone has any ideas of how I can remedy this without taking it to a mechanic, I'd sure appreciate it.

I have this code. You can hear a knock when you press the pedal too much. If you put the pedal down slowly it won’t knock

I replaced the O2 sensor botch bank one light came back on any tips

NO dtc coming up ?

Super helpful! We just had a repair on our front car right hand wheel 🛞… could this light have something to do with that? 🤨

If it was the air flow meter would it not make it flag both sides of the engine being a v6

What does code P0300 mean I have a 2016 Chevy Impala

Where is it on a 2013 Kia soul

Thank you very much.

Is it a fuse issue?

What are the chances my ignition coils spark plugs and wires/plugs need changing a week after I buy my used car

Thank you sir!

Good information 👍

Thank you sooooo much :))

Could it break the raditor or crack the radatior?

Greetings, I have the same problem with the sensor. The connector signals are fine and I changed the sensor but the code follows because it would be

old lady here

Question I went to autozone and they pulled up a P0011 code but on the paper they gave me there is P0014, P000A, P0017 as well. The paper says exhaust camshaft position timing bank 1 But also says crankshaft position correlation bank 1 sensor B. I just need to know what part to order as I’m ordering online where it’s way cheaper.

All the transmission letters flash at the same time.... Didn't see you cover that

Good explanation.You have a new subscriber in me.Thanks.

So how can we manually open and close the valves. I’m a retired mechanic and I have an old Snap On computer but it’s not updated to a 2017 and that’s what I’m working with. I have a smoke machine and I’ll be using that next. Is this a 5V system?

What about a single click sound. Happens right as I accelerate (slow or fast) and once when I decelerate

Direct and to the point. The absolute best source of information on this issue I have seen. Keep this up. You've got a subscriber.

Vapor canister vent solenoid is before the purge valve near the tank. Often times is that..

Great information. Thank you.