What about wiring of top green slots?

Nice way to explain

Nice experience sir

Super bro

Hlw sir very helpfull video .but i request you 3 floor lift controol wiring plz❤❤❤

Hello, can you manipulate the AR and AN, BR an BN connections? What happens if AR and AN looses connection while it is ruuning in source A?

bhut acchabhai

Nic

Hindi me batahiye sir please 🙏

Ello, My name is STEEV and I am in Kansas Sity.

bhut badiya

Nice

ಇದರ ಬೆಲೆ ಎಷ್ಟು

Please share more videos in English

Nice way to explain bro

EXPLAIN HOW TO USE BOTH ON DALAY TIMER & OFF DELAY TIMER TO THE SAME CIR CUIT. HOW TO SELECT THE SIZING OF SPARES TO ALL TYPES OF STARTING . ALSO MAIN CIRCUIT WIRES , SF UNITS. ALSO GIVE TIPS TO SELECT BOTH THE SF UNITS & MCB. BOTH THESE RATINGS ARE EQUAL OR NOT. PLEASE EXPLAIN.

Nice

I I want to some knowlage how they work

Sir how can I learn Relays contractor wiring I am HVAC technician I have controller compressor sensors

Good explain bro❤

Very helpfull video me❤❤but 3floor lift control viring❤

Hlw bro this video very intresting and helpfull but your request plz 3 floor lift penal daiyagram plz sir❤

How to buy?

So nice thanks sir

The world's best teacher thanks sir

So nice thanks sir

Lagewog Hindi video

Thanks a lot !!

Tq

how do you deal with the ground connections from all three?

Good, but where can such be applied?

How to connect 2 hot wires and neutral wire from the main source to the ATS

When using your multimeter do you set it on continuety test?

where do the ground wires go?

Solar panels generator supply invertor maaron blue yellow start stop off neutral auto teacher ji

Mabe a Timer in the green sensor connections will work by programmable Time ?

Thanks you so much..show me how to wire trip and off

Sir delta vfd, thesame function and wiring diagram

OL = open loop not over load

Thanks for the idea

Follow from egypt 🇪🇬

Thanks sir❤❤❤

Hi, If i got error from "U" only but "V" and "W" working, Can i running motor with V and W only if motor single phase or i will got error ?

Hi, I am applying the concept, but it is not working. The float switch I am using both having the same colors of wire which are: Black, Gray and blue. I need assistsnce

Thanks so much this help alot but is there a video how to replace igbt of a drive abb acs 580

Can this automatic changeover switch off generator?

Nice job

Very nice

I want to power a DC load (less than 50A) from two DC input sources. When DC source A (primary) is available, there will also be a 230V power source to compliment it. If I supply the 230V AC to the Control terminals (AR + AN), will that be enough to make this ATS function? Basically what I am asking is two fold: 1) Does the control wiring have to be linked to the power wiring, or can the power wiring switch DC loads?, and: 2) Is the secondary control wiring necessary to connect, or will the switch function normally with just the primary control wiring? Any advice will be appreciated :D

what does it mean when 1. L1 to positive lead and DC+ to negative lead = 0.800 2. L1 to negative lead and DC- to positive lead = 0.500 same thing with L2 everything else is perfectly correct as per your video