I would probably hit that with a B8 and finish with a pencil tip (B2 or B1 tip).

I didn't think that blade tip would take it out. I thought you'd finish it with a sharp tip.

You posted a pizza. Should have used a rubber tip to avoid all the poke marks for a smother repair

Говнодел.

nice work, that was a nasty dent, would be nice to see your access points and rods / tips you are using.

Great job your very good , i don't have anyone decent or reliable where i am to do this for me, I try to PDR dents some times, im not very good, if there's dents on blend panels im painting i give them a go or if im painting the panel i have a little practice, ive got a basic bar set and glue set, im never sure what bar to use or glue pad but its not to bad cos im quite good with filler 🤣 Where do you get that knock down tool from and what it called Good Video 👍

What is the name of the tip with which you touch the pluses?

Hi Andy, I use a short elimident light. I think it is the 2nd generation? Cheers.

Hi Mate What is your go to LED Light please

Show us the finished work. Show us video panning. That dent has great crown yet thats gonna be released.

Not finished yet.

Ninguno de sus videos presenta el trabajo 100% terminado. Como mucho un 75%.

Requires a little more fine detail.

That dent is too far to say finished.

Great result mate that was a nasty dent 👍👍

Good Job !

kovax 3000 make its looks shiny and you can hide those small marks left, use it next time in repair's like this :)

As Usual 👌

Пластиковые крылья дятлы ровняют😂😂😂

Great job mate!

Excellent repair.... what nibbing block ru using?

Again, this is just down to the lack of video editing. I will eventually learn to use some software for this but for the time being I can only do this kind of video in a single take and I don’t want to move the camera around a lot while recording. I will try to remember to take before and after photos to post on X and Instagram for the future. Thanks again Andershrom.👍

Basit gibi görünebilir ama aslında çok önemli. Mükemmel oldu

Здравствуйте! А что было дальше?

Очень интересно. Почему, не до полной зачистки видео?

Hi Victor, I went in through the window with a short fixed hook tool.

Hi Chris, the point of these videos isn’t to show the complete process from start to finish. There are plenty of videos of that you can find on KZfaq. These are meant to be single take videos for the satisfaction of seeing a dent disappear. 17 years in the game eh? The first lesson I learned in this job was never to criticise someone else’s work. You must have forgotten that it was so long ago. Take care mate.👍

Hi victor, for this one I stripped the boot trim for access and used a short Johnson (straight bar with a 20° angle kicker. I had a rubber tip to start with and finished metal to metal.👍

Access point and Rod used???

Where was your access and what rod are you using??

Nice job, I use lines, could see so much more.

Still has lows. That dent is far from complete. I've been a PDR tech almost 17 years now I would never leave a dent like that.

👍💕🖤🖤great video 🖤👍

That needs to be cleaned up. Still have highs, panel does not look smooth.

"Promo SM"

camera angle on point 👍