Call me at 8038898422 I'm Daniel shaw from Norway sc . And I'm a custom painter.
@xelxskilsx22 күн бұрын
Ty for the info
@fusemalaysia84023 күн бұрын
3 weeks ago with new air compressor motor you only need 96 volt battery.... they using a normal dry cars battery....4 battery actually already enough if you just lift up and down your cars slowly with your air suspension...but for me I recommend you to install 8 battery cause to respect the wali even it gonna add cost while you refill the gas...one more things to make sure survivor for thier business....jump 4 way setup will be recommend for new lowrider member, especially if you have bunch of friends, and it will help them business to since so many things need to be purchases.
@adammoseley51923 күн бұрын
Hey man I appreciate all the help I'm new the the lowrider seen and was seeing if you could possibly help me out. I got a problem my front is on one pump and now it's going up slow I messed with the little valves that are on the pump but didn't seem to do anything I checked the pump and it was about half full could that be why?
@LOWRIDERHYDRAULICS23 күн бұрын
Yes, fill it up with the car all the way down and see how it does after.
@adammoseley51923 күн бұрын
@@LOWRIDERHYDRAULICS the pump motor started to smoke a little bit yesterday but still works. Is that because it's low or is it going out
@russellharris262123 күн бұрын
@@adammoseley519 the smoking is probably coming from the motor. My guess is you are leaking a little bit of fluid into the motor from the shaft seal. I’d remove the motor, clean it with brake or carb cleaner really good. Reinstall it after it’s had time to dry and see if it still smokes. If fluid is getting into the motor the inside will be black and kind of gummed up.
@adammoseley51923 күн бұрын
@@russellharris2621 thank you so much I will do that. And see how it goes thanks for the tip
@adammoseley51922 күн бұрын
@@LOWRIDERHYDRAULICS I also got another question, when I lower it all the way it looks like right rear side sits up higher. Anyway to adjust that?
@chatobalencian1504Ай бұрын
Russel you should have put a blow proof seal they work very bad ass and for the rear try some #7s if u use 3 or less batts and #9 for 6 or less on dbl rear pumps as well and #11 marz if u can find the 99/00 with the heart shape seals I haven't tried the newer bmh gears I bet they work good tho the pantheon ones take a look at them and them blow proofs are bad ass
@LOWRIDERHYDRAULICSАй бұрын
I use blow proof seals on every application, this is an old video and the focus was on the pumphead seals. I don’t use #7 unless it’s on a dancing bed. The BM pumpheads are nice, good design.
@chatobalencian1504Ай бұрын
@@LOWRIDERHYDRAULICS Kool deal I need to order a few and stock some up which have u used and did u like it more than the other or have u only sweet
@PuffinonzootiesАй бұрын
I though the angle of the front wholes was called tuck? Like some front wheels are angled inwards
@ashleejohnson543Ай бұрын
I dont s33 th3 diagram
@fineartonfire_5327Ай бұрын
Very informative videos. But only homosexuals wear flops out n about. I just can’t respect a male in flip flops.
@nrolled2888Ай бұрын
What happens if I hold it in the up position?
@WaterstsanjoАй бұрын
I have a corner that locks up every time. Can it be something else?
@user-tm6pn2bj5rАй бұрын
Thank you for showing the way it should go on
@CacowninjaАй бұрын
Do they make wireless low rider hop controllers? I mean it seems dangerous having them be wired based on the fact the wire could snag on you when the car is hopping. Also being that close to the car seems a bit dangerous seeing it could fall on you.
@kilochris83Ай бұрын
does the flat side sit on the cup or in the pocket of the arm?
@LOWRIDERHYDRAULICSАй бұрын
Cup side.
@kilochris83Ай бұрын
@@LOWRIDERHYDRAULICS Thanks man!
@JimMate-fc3rwАй бұрын
Thanks for your information about solar wiring. Could you please show me how to connect 12 batteries 200amp .
@jaimecontreras3046Ай бұрын
Can I open the fill plug while the car is lifted up? just to check how much fluid it is without filling up? I just want to make sure the pump has fluid
@LOWRIDERHYDRAULICSАй бұрын
On a regular pump you can open it while it’s lifted but don’t add fluid until the car is dropped all the way. If it’s a piston pump and it’s charged, don’t open it.
@jaimecontreras3046Ай бұрын
@@LOWRIDERHYDRAULICS so this might be a dumb question, but im barely getting into the hydraulics game, how would I know if the pumps my car has are regular pumps or piston pumps? Can I possibly send you a pic? or email you a pic
@LOWRIDERHYDRAULICSАй бұрын
Quickest way is to find me on FB. Russell Harris.
@jaimecontreras3046Ай бұрын
@@LOWRIDERHYDRAULICS Appreciate it man. I Will send you a message on Facebook. thank you
@jaimecontreras3046Ай бұрын
@@LOWRIDERHYDRAULICS Thank you so much man. I sent the Message on Facebook. I really appreciate your help!
@gcobraАй бұрын
My back switch dumps but does not lift. side to side, rear left, and rear right all work. Is it my switch?
@LOWRIDERHYDRAULICSАй бұрын
Sounds like a bad switch.
@ashleejohnson543Ай бұрын
Very informative
@antonio707galvan2 ай бұрын
On average, how much cable is needed. I am working on a 79 cadillac deville and want to run a 3 pump and 6 battery set up.
@tonym19202 ай бұрын
Hydro-aire dumps Solenoid how the work fix them
@flyroythatrendsetta2 ай бұрын
Nice video bro
@anthonymaestas48632 ай бұрын
Awesome video, I think I said this in the past but they don't act as shocks. The act as springs. This is a common misunderstanding.
@jflo68302 ай бұрын
Hello. I'm trying to put some 15.7 spokes on my 13 Hyundai Accent. Gs It has a 4/100 bolt pattern. The hub of the rim won't fit. Not sure what kind of adapters I need or should I change the bolt pattern to 5/100. ?? Any suggestions
@kpvideos41622 ай бұрын
The pistion plunger inside which way faces what? I see there is to sides one with a big indention and the other side with the very small intention which side faces the fill plug
@juliogarcia37022 ай бұрын
Good video thanks for the knowledge 👌
@BigScrappy4052 ай бұрын
Thanks for the Video Bro, much love and respect from Oklahoma City and OKC CERTIFIED CC. 🫡
@stravis32693 ай бұрын
Nice monte, i never liked the short montes, I own a 84. Custom show car. Since a long time i like the late 70s montes looks
@jiminutez3 ай бұрын
So this is a check valve for cars, not irrigation
@winnieman-fx1hu3 ай бұрын
I think the old man still has it, but the young guy aint bad. bet hes proud
@1904.Lowridaz3 ай бұрын
Do you think if a lowrider roses w the car nose down back up while cruising for a bit is that bad for the hydraulic motor ? I think I got a bad battery or something as my front doesn’t want to go up even though they say charged maybe a bad solenoid ? I will be taking my Lincoln to the “doctor” soon lol and will get back with what the issue was
@cesarchavez13033 ай бұрын
Have you ever used set screw battery terminals?
@TCB4053 ай бұрын
Why am I watching this I don't have 2 cars to do this
@everardomartinez973 ай бұрын
Life saver!
@Leocast1173 ай бұрын
I use a street charger it works great.
@peekhub74463 ай бұрын
Great videos bro! Question for you are there shocks i can use instead of accumulators? or any alternatives?
@abcardenas353 ай бұрын
8 battery set up I need diagram
@abcardenas353 ай бұрын
Where could I message you Bro
@abcardenas353 ай бұрын
Which one are these connected to the battery
@MrF-ly2bb3 ай бұрын
Why didn't you mention 5:20 × 13 inch tires ?
@ragenastyboy87883 ай бұрын
Do you hav too switch the a arm if you change coils
@LOWRIDERHYDRAULICS3 ай бұрын
No
@ragenastyboy87883 ай бұрын
Ok coo thank for responding
@user-qk1br6ik2m3 ай бұрын
Where can I get the motor you use
@LOWRIDERHYDRAULICS3 ай бұрын
Pretty much any hydraulic shop, CCE, Hi-lo, Black Magic
@user-qk1br6ik2m3 ай бұрын
Thank you
@user-qk1br6ik2m4 ай бұрын
What size wire you use for the solenoid
@LOWRIDERHYDRAULICS3 ай бұрын
I’m assuming you are asking for the size that the switchbox wire connects to, that is 16 gauge.
@gerardogonzalez17724 ай бұрын
What’s a good website to get parts mine is goin same thing I probably had same issue remplace the pump head 😢
@LOWRIDERHYDRAULICS3 ай бұрын
First open the pumphead and find out if the seals are bad. If they are, just about any hydraulic shop has seals.
@DJBUTTERPHINGERZ4 ай бұрын
Thanks for the info
@Lwmusic10004 ай бұрын
Can anyone send link to where i can get tubes for 14x7 wire wheels
@lowrider4life9274 ай бұрын
👍🏾
@Lowridersdoggs4 ай бұрын
What do you charge to do a full frame wrap?
@jaybee11585 ай бұрын
What about just a simple lay and play how many batteries and pumps should be needed. ? And is it literally the same set up? I have a 90 Lincoln I’ve seen videos that look as though they wire things differently especially with the lines I didn’t see no lines in this video. I could pay someone but I feel I can do it myself especially since I’m familiar with some things I just want A-Z perfect guidelines. Any advice I’ve been looking throughout all your vids and just writing things down and drawing stuff to make sense. So anything that can help from your or anyone I’d greatly appreciate it thank you
@straightgangstarizm5 ай бұрын
2 pump set up rear doesn't drop. Any idea on what it could be or what I could trouble shoot.?