09-14 Acura TSX EPS control module | 32-09 | DIY | EPS | Please check power steering system

No video

09-14 Acura TSX EPS control module | 32-09 | DIY | EPS | Please check power steering system

Рет қаралды 15,303

Күн бұрын

In this video, we show how to replace an EPS unit, on a 2012 Acura TSX SE ( special edition )
A regular cheap code scanner will not work, it needs to be a scanner that has SAS built in.
Part can be order for a hefty price of over $1k
Or go to a local junk yard and pull one out for under $30.
Warning:
“Please check power steering system”
Part # 39980-TL2-A0
Showa HTL2X-50-11M
_________________________________
Calibration Procedure:
Steering wheel calibration is a must, and easy to do,
First jack the front up on jack stand evenly
Then turn the key to on position
Turn the steering wheel left and position it at 10 degree
Turn the steering wheel right and position it at 10 degree
Put steering wheel back in the center, straight
the wheel.
Turn key off
Start the car, and it should be done.
__________________________________
Disclaimer:
“Sokhom Garage” Will take no responsibility for any damages, injuries, losses or liabilities associated with performance on your vehicles or others property, you do this at your own risk, my video is for guidance, and educational/informational purposes. As always be safe and wear ppe (personal protection equipment)
#DIY #acura #tsx #electric #replacement #specialedition #2ndgeneration #eps #module #unit #honda #TL

Пікірлер: 41

@alstirling69 3 ай бұрын

Hi Guys..! Just spent an hour or so stripping this apart to take my EPS module out. Had the dreaded EPS warning light and bing and no power steering.. ordered a replacement off ebay. Just keepin my fingers x'd it fixes my EPS problem. Thanks guys your how to video helped alot.. 😊

@koloradokiller 3 ай бұрын

Did it work?

@stevenlewis8986 2 ай бұрын

There appears to be a *silent* recall going on? I had all these symptoms and found out that there's a warranty extension for this unit and free replacement, for specific VINs. Mine is one. Although my car was purchased from a dealer, neither Acura or the dealer notified me.

@MrJoefoefrombuffalo 4 күн бұрын

@@stevenlewis8986Please consider posting details about this recall a link or picture would be great

@masahikokimura5817 4 ай бұрын

Hello bruvva I just repaired my EPS today thanks to this video. I cannot thank you enough for making this available to everyone. I have saved alot of money going to a mechanic who would have probs ripped me off.

@mikeseal5515 8 ай бұрын

My 2013 TSX EPS unit is being replaced under warranty. They extended the warranty on EPS units to 15 years, unlimited mileage on some cars/years. Check on line, or at the Acura Dealership. If you already did the repairs, you might can get your money back (I read that on line).

@DanielSmith-yk4ds Жыл бұрын

Cut the bottom glove box trim that's perforated and made to be cut. Pull blower box. Makes job twice as easy. Thanks for video though.

@masahikokimura5817 4 ай бұрын

if i do it this way i wont need to take the fuse box out????

@brandonr5188 4 ай бұрын

Thankful for this video .

@PhiloHits 9 ай бұрын

Thank you!!

@insulatoru8817 8 ай бұрын

Anyone know if TL model is similar install process to this one? Can’t find much info on it

@SokhomGarage 8 ай бұрын

As far as I know, it’s in the exact same location, on the passenger side under the glove compartment.

@PhiloHits 9 ай бұрын

I installed the used module; got exact same code. It’s definitely the wiring but I don’t know where to look for connections Beyond inside directly connected to module and those all look fine. Where would the next connector Be located so I can check? My fault code is 33-1 low fet stuck on.

@SokhomGarage 9 ай бұрын

Sounds like a loose connection or a short in the wire.

@SokhomGarage 9 ай бұрын

DTC 33-01: Lower FET Stuck ON (Initial Diagnosis) Turn the ignition switch to ON (II). Clear the DTC with the HDS. Turn the ignition switch to LOCK (0). Start the engine. Turn the steering wheel from lock to lock several times, and hold the steering wheel for 10 seconds or more. Check for DTCs with the HDS. Is DTC 33-01 indicated? YES - Go to Step 7 . NO - Intermittent failure, the system is OK at this time.■ Turn the ignition switch to LOCK (0). Disconnect the EPS control unit connector B (2P). Check for continuity between body ground and EPS control unit connector B (2P) No. 1 terminal, and No. 2 terminal. Is there continuity? YES - Go to Step 10 . NO - Check for loose terminal in the EPS control unit connectors, and repair if necessary. If no poor connections are found, replace the EPS control unit. ■ Disconnect the EPS motor 2P connector. On the EPS motor side, check for continuity between body ground and EPS motor 2P connector No. 1 terminal, and No. 2 terminal. Is there continuity? YES - Replace the EPS motor. ■ NO - Repair short to body ground in the wire between the EPS control unit and EPS motor.■

@wscottparks Жыл бұрын

Do you know if this part can only go bad when it rains? I know that sounds funny, but I have a 2010 Acura TL, when it rains the power steering goes out, after it stops raining, everything is fine..Thoughts?

@SokhomGarage Жыл бұрын

Since replacing it, it hasn’t gone bad yet, and it should work regardless of the weather conditions. Going out during rainy days is something new to me, probably just have to replicate that with a water hose while someone attempts to turn the wheel to see if it does it again or just have a tech look at it.

@SokhomGarage Жыл бұрын

Sorry, accidentally deleted your comment

@SokhomGarage Жыл бұрын

But, yes, while trying to replicate the EPS, see if you get any warnings lights on the dash board.

@pekemo Жыл бұрын

2012 TSX Wagon here - was having electrical problems when it rained. Diagnosed as parasitic draw on the battery from EPS control module. The unit would stay on when the car was off. Went through a couple batteries and did other things like disabled alarm system and replaced a door sensor before replacing steering module. There may be a drain tube that's close by - should check to ensure it's not clogged.

@PhiloHits 9 ай бұрын

Mine went out after driving thru deep rain water one night

@334rolltidegaming6 8 ай бұрын

Did you get it fixed ?

@334rolltidegaming6 8 ай бұрын

I’m getting same code

@PhiloHits 4 ай бұрын

Still not fixed. I have been driving with no power steering. It sucks. Just haven’t had the time to take it in

@emiliyansimeonov6780 3 ай бұрын

👍👍👍👌👌👌👌💯💯

@umarrauf9331 8 ай бұрын

hey man, at 2:27 on top of the fuse box, there is slider type clip, I have 2.connectors on that blocking the screw. did you had those. If yes, how did you remove them

@SokhomGarage 8 ай бұрын

I’m pretty sure I did, i don’t remember how I did it.

@umarrauf9331 8 ай бұрын

@@SokhomGarage allg man, thanks

@masahikokimura5817 4 ай бұрын

@@umarrauf9331 bro it slides out just pull the cunt or use a flat head and it will pop off