Рет қаралды 5,707
Making some cedar coasters that are 10mm thick with my 10 watt XTool D1. Will it work? No air assist installed.
My settings for this burn in lightburn were:
Fill- 70mm/s at 100% power using the fill preset, 1 pass
Cut- 7mm/s at 100% power- constant power engaged for 7 passes
The links below are affiliate links that will direct you to the product in this video. If you use this link for a purchase, I will receive a commission from the purchase. I remain unbiased and honest in my assessment as always.
D1 bundle that I have on Amazon: amzn.to/3sJRPMC
XTool Website
www.xtool.com/...