1971 Chevy Nova: Fabricating a aluminium trunk skin
Рет қаралды 2,168
Жыл бұрынHere we have a '71 Chevy Nova street / strip car, manufacturing a aluminium trunk skin on the original frame.
@jonbarnes2503 Жыл бұрын
Great work Steve!!
@notebender5073 6 ай бұрын
This was extremely helpful. I'm about to attempt to take two damaged 64 Impala hoods and make one good one. I may fail, but it's worth try. Basically I need to remove the bracing from one and transfer it to the straighter sheetmetal. This video makes that seem possible. I'll just have to take care with the sheetmetal and separating the spot welds. it's so difficult to find nos panels, and I want to try this before going with reproduction. Enjoyed your work.
@jimwalker5412 Жыл бұрын
Humans, in general are so inventive and skillfull, well done.
@waldidee1125 Жыл бұрын
Fantastic manual work, I follow further actions. Best regards
@mekomaskin455 Жыл бұрын
Nice work! How thick and what quality is the aluminium sheetmetal?
@ClassicFabrications Жыл бұрын
1.2mm / 18 gauge and it's 1050A aluminum
@maxakarudy Жыл бұрын
@@ClassicFabrications Very brave 💪, thought it might be 1.5mm , lovely job mate👍👍
@mekomaskin455 Жыл бұрын
0,8 mm Steel tog 1,2mm aluminium will make about 50% weight saving
Classic Fabrications
Рет қаралды 16 М.
Carthage Classic Cars
Рет қаралды 8 М.
The Story of Trouble with Lawrence Todd
Рет қаралды 3,7 М.
The Resto Shed
Рет қаралды 18 М.
jamoloniy
Рет қаралды 372 М.
Truck Drive
Рет қаралды 20 МЛН