Hey guys welcome back! In Todays video we replace the clutch on my 1990 Honda CRX SI
Пікірлер: 54
@vincentstevenson2200 Жыл бұрын
Thank you for making this video. Your instructions are very clear and thorough and I really appreciate it!
@Tycrx89 Жыл бұрын
Happy to help!
@TheronFrenzy Жыл бұрын
Dude this video is fantastic... Thank you so much! It will help make my transmission replacement a breeze next week
@Tycrx89 Жыл бұрын
Thank you so much for the kind words, I’m so glad I was able to help 👍🤙
@nnandicason92162 жыл бұрын
Great video. Love how detailed it is
@Tycrx892 жыл бұрын
Thank you!
@robertgarcia3695 Жыл бұрын
Thanks for the video!! It was my first time removing a clutch and this video gave me the confidence to do it 💯
@Tycrx89 Жыл бұрын
A comment like this is why I do it, thank you for the kind words 👍
@michaelgorey21862 жыл бұрын
very well done. Very smart to share your thought process. I will be doing this in the near future. Thanks again
@Tycrx892 жыл бұрын
Good luck to you! I appreciate your kind words thank you👍
@ClipsForGames2 жыл бұрын
So you can change the clutch without taking out the engine, nice. :)
@Tycrx892 жыл бұрын
Most people consider taking the engine out with the trans attached much easier. I prefer leaving the engine installed but that’s just my preference 🚙
@donchan1622 Жыл бұрын
Thank for awesome video….!
@Tycrx89 Жыл бұрын
You’re very welcome!
@SabreRedhead5 ай бұрын
real men undo that 10mm and pull out the whole speedometer gear 😈
@Tycrx895 ай бұрын
Interesting, to each his own. I prefer to work smarter than😊 harder, but hey man go for it.
@ballenwallen Жыл бұрын
you aren't lying on that starter bolt, jesus I had a time with that lmao
@Tycrx89 Жыл бұрын
💪⚙️
@CrxBreizh11 ай бұрын
That's a very good video 👍
@Tycrx8910 ай бұрын
Thank you! 👍
@jeffersonherreraflores4 ай бұрын
Hey great video I had a question so when we were removing the flywheel it spun and we wanted to know if the engine would be off timing.
@Tycrx893 ай бұрын
If the belt was still tight and not messed with you should be fine!
@Zone-mc2tp2 жыл бұрын
Damn i miss my 88 CRX-Si was red missing it right now 😢
@Tycrx892 жыл бұрын
88 in my opinion was the best year!
@deanevangelista6359 Жыл бұрын
Holy crap! Replacing a clutch on a rear wheel drive car is a walk in the park compared with this.
@Tycrx89 Жыл бұрын
I agree!
@TWINTURBO1327 Жыл бұрын
Perfect video.. Please I need to know.. What the correct number. To set the valves. My car is honda civic 1990 . Manual transmission.with carburettor. Thanks 🙂🙂
@Tycrx89 Жыл бұрын
Sorry to get back to you so late but .007 for the intake and .009 for the exhaust side 🤔
@takumisato71262 жыл бұрын
Do you recommend changing the engine mounts to new one while replacing the clutch since theyre apart already?
@Tycrx892 жыл бұрын
Wouldn’t hurt to do that 👍
@Atr42Greasemonkey Жыл бұрын
Change any possible thing that could be worn... parts for this car are very cheap on rockauto
@The_Redkween11 ай бұрын
You did such a great job on this install. I’m sending you a seal puller, btw.
@Tycrx8911 ай бұрын
Thank you😁
@young-vintage64 Жыл бұрын
How do I put the transmission back on
@Tycrx89 Жыл бұрын
Same way you took it off, use a floor jack to lift it into place that usually helps. It will pop into place then slowly tighten the bolts down in a criss cross pattern
@hardworkingrick231811 ай бұрын
I just did this two weeks ago on my y49 dam near 400k on it the trans was a bitch to.line back up lol
@Tycrx8911 ай бұрын
Yes it can deff be a pain but worth the satisfaction when its complete!
@galileo_omega145510 ай бұрын
What is the diameter of the clutch you used ? 200mm, 212mm ?
@Tycrx8910 ай бұрын
212! I hope that helps!
@galileo_omega145510 ай бұрын
@Tycrx89 Thank you! Your video really helped me! I must have missed something because the rest of the motor is leaning so much
@jscottfischer Жыл бұрын
Is there any different from a 86? Looks about the same
@Tycrx89 Жыл бұрын
It’s not going to be 100% identical but im sure you can apply a lot of the same procedures on those years as well.
@jscottfischer Жыл бұрын
Is the game plan to just have enough room to remove the bell housing to take the clutch off? If I can do it without removing as much peripherals?
@curli3boy444 Жыл бұрын
Do you not need to shim?
@Tycrx89 Жыл бұрын
O.o
@slimjim87362 жыл бұрын
is the car cursed its painted yellow
@Tycrx892 жыл бұрын
I sure hope not
@oldskool19792 жыл бұрын
Use conventioanl 5w30 motor oil in the tranny....thats what I use
@Tycrx892 жыл бұрын
You’re taking a chance I’ve blown a manual Honda transmission when I used regular conventional motor oil. Trust me from experience. Those trannys are very picky when it comes to fluid, just passing info on from my experience.
@oldskool19792 жыл бұрын
@@Tycrx89 Read the owners manual !
@Tycrx892 жыл бұрын
Owners manual didn’t save me from blowing a trans Unfort
@oldskool19792 жыл бұрын
@@Tycrx89 Th etrans didnt blow because of the oil... many other reasons !
@Tycrx892 жыл бұрын
Possibly I’ve never had an issue when I’ve used manual Honda transmission fluid the one time I did use gear oil the transmission was affected so I wasn’t sure exactly what happened it didn’t blow from abuse. Just passing on my experience I’m sure 5-30 gear oil is fine, I just won’t be using it.