Great video thank you. I just wanted to add that my heater core needed to be replaced on my 1998 Nissan Maxima. By taking out both heater core tubes and snap that plastic piece between them because I could not reach the screw. I was able to slide the heater core out and replace it with out pulling the dashboard.

Thanks for the help man, I was just about to pull the fuc*ing dash out this week on my 99 max and weld some alum pipes on the core.

Thanks, Broseph!

oh man this looks rarely easy compared to the fucking heater core job on a Z32 man if you don't want to remove dash you gotta just cut the pipes then join them with hoses and clamps unlike the maxima that once you remove the little screws you can twist it like in this video then the tube comes out, shit on the Z its copper pipes with a couple of degree bend so no L shaped like the Maxima damn you Nissan I bet they do it on purpose to get cars in their bays, I saw a video on a Toyota's heater core replacement and they got their shit together you can detach the pipes at midway they are joined with couplers and grommets, anyways sir thanks for the video it always helps out the community.

another great video, when i was changing the value cover gasket from one of your other videos my plastic broke like yours, only about 1/2" left in firewall i was able to use a c-clamp and put the hose back on. will that cause the car to seem like there is a vaccum leak? pressure? different subject: forgot to put gasket back in erg tube will that cause something like a vaccum leak idle funny....also snapped small piece off pvc value...same question?

Hey where did you get the pipe from also what is the direct name i have same problem it shaped off need help with locating the part ?

It looks as if you can take both of those tubes off and remove the heater core without removing the dash but that's just wishful thinking lol!! Great vid though

$28 for a piece of plastic. wtf?

Good job, man ! I have changed heater core in my Lincoln Continental, had to take the dash out, what a job! I bet Ford Taurus is same way=(( Now, how tight did you put those 4 little screws??? You need to have that special tool/ screwdriver to do this, I am sure! youtheman =)