My tip for you is next time toss the bearing in the frezer for a few hours make it cold and they go in like you wouldnt belive! Little grease and you can push it in by hand or very very little force at all! And a hub tamer is the best bearing tool out!

Great video. It would have been nice to show what happened at the end when you corrected the bearing. Thanks for sharing.

So i'm currently doing the same thing with the Mazda 3. I think I will have to buy a set of those cups. I have a 6 ton press and the bearing didn't seem to care. Sat down with a 3lb hammer and a punch, again, nothing.

You chose right because if you put the bearing in the other way it would have caused a abs fault. Good work

Awesome work man👌

What type of tool was used to press bearing out

Fanny video these scissors like a surgeon

When you turned the spindle to let us hear the bad beating, I heard music...

What size socket you use to hit out the hub with?

He went be touching my vehicle

Can't you just leave the knuckles on the car and use a rented bearing press kit to take them out?

Link to parts?

You're not workin' on any of my cars buddy.