The correct Actuator was Murray DA1046. it had the correct pins. You will need to do a hvac recalibrate procedure. Check with sparkys for the details.
Пікірлер: 11
@NM-eb5ejАй бұрын
I want to thank you for the video, I did it, the time consuming part was cutting the tube after that it was a piece of cake, also replaced the heater door actuator which is above the fan motor, since I was there and everything was out of the way. There was no way I could of had a shop door it google it and an estimate was between 975 and 1375, my cost was 130 and the time. Thanks again Nm
@ReachtransformАй бұрын
Thank you so much for this video. It helped me a lot!!!
@ejchavez67994 ай бұрын
Thank you Mr Kolar . I was looking for a video that explains the problem I have with my truck and yours explains very well the issue I have. Thank you so much. Muchas gracias.
@carlball85906 ай бұрын
Thanks for the video. Just got finished fixing my truck
@adamshamsuddin5 ай бұрын
Fastest way to get this done without cutting the vent with a saws-all is to go ahead and remove the dash, and then loosen the bolts holding the air vent in place. Take a long pry bar through the air bag hole and use the metal bracket for leverage to lift up the vent and you'll have plenty of clearance to do the work.
@craiganem1531Ай бұрын
Thank you Sir for this diy Video
@tonyfisher201425 күн бұрын
Thank You Kindly Sir
@scottboyd87327 күн бұрын
Thanks!
@chriskolar27 күн бұрын
Thank you
@javiercarrillo5015Ай бұрын
You're a chingon man..thanks got it..bad design in my opinion!