Рет қаралды 104,214
The brief list of steps for this job and tools needed:
1. Remove Engine Cover = T30
2. Remove Foam Insert. 0:27
3. Loosen Fuel Line = 14mm Wrench. 3:24
4. Remove Electrical Connection. 3:44
5. Loosen Injector Keeper Bolt = T40. 5:04
6. Remove Fuel Line On Top of Injector. 5:26
7. Remove Fuel Line. 8:58
8. Tape All Openings. 9:20
9. Clean Area Around Injector.
10. Remove Injector Bolt. 10:05
11. Remove Injector = Slide Hammer amzn.to/3519tgk. 13:19
12. Clean All Carbon/Debris From Area (Taking special care not to allow debris in holes). 17:48
13. Remove Old Injector Seal. 20:29
14. Finish Cleaning Injector Port. 21:46
15. Clean Injector and Keeper. 24:59
16. Cut New Face for Injector Seal = Injector Face Reamer amzn.to/374sCjq.
17. Install Injector Seal. 25:38
18. Install Injector. 25:58
19. Install Keeper. 26:30
20. Install Injector Bolt. 27:05 & 32:10
21. Change Fuel Line O-Ring. 33:20
22. Attach All Connections and Fuel Lines. 34:58
23. Start Car and Let Run to Check for Leaks or Anything Abnormal. 36:52
24. Install Engine Cover.
Seat Reamer: amzn.to/2PTj4Uv
Slide Hammer: amzn.to/3fZlrQp
Filmed with Sony RX100 V: amzn.to/2G46BF4