2007 Sentra Blower Motor Replacement

Рет қаралды 7,193

Күн бұрын

The Hanes Manual describes removing the dash to get at the Blower Motor. I think if you can charge $125 per hour this would be the best and safest way to go.
Replacing the unit by taking it out from under the dash was awkward but wasn't any more difficulty than I was prepared for and I am sure it was way faster than taking the dash out first.

Пікірлер: 12

@xsaviorfreeman5610 Жыл бұрын

You just saved me so much time

@franciscorivera8389 Жыл бұрын

GRACIAS....AMIGO SALUDOS DESDE CHILE

@dullahan8191 Жыл бұрын

Just finished mine the other day. I watched your and few others videos and after about 4 to 5 hours job completed. I had the same issue getting my new blower rotated. I actually put a long screwdriver between the heater core pipes and used a rubber mallet to tap it into place. Now to get it out again will be difficult so I'm going to 3D print a special tool to fit the blower so I can rotate it out. Other than lying on my back the whole time it wasnt to bad.

@upstageinstallations180 Жыл бұрын

It's so rewarding being able to fix things ourselves spirit I also watched lots of videos before I attempted mine And I think the most important thing is seeing where other people ran into problems. I like your clever solution to rotating the fan motor.

@josefranciscoesquertalaman3827 2 жыл бұрын

Presente cordial saludo desde Navoyork Sonora México

@HankGoodness Жыл бұрын

How did you remove the electrical connectors from the bcm? Been trying for hours over 2 days. Thx for the vid!

@upstageinstallations180 Жыл бұрын

I don't really remember. although watching the video again I think it might be possible that I just unscrewed the module and shoved it out of the way without unplugging it. I didn't comment on it so I mustn't have really had to give it much thought. sorry I can't be of more help.

@HankGoodness Жыл бұрын

@@upstageinstallations180 thanks, I'll keep trying.

@originalangel3448 Жыл бұрын

What would u do different, my husband is doing mine today, any tips?

@upstageinstallations180 Жыл бұрын

Nothing. It all worked out. Patience is the main thing.

@upstageinstallations180 Жыл бұрын

On second thought I would pay more attention to the way the brakes were set. I had to take things apart to adjust them after I had already finished the installation. Thanks for the comment.

@NicoletteLuna-lo6om 11 ай бұрын

Dang what a pain. I wish someone I know would have watched this before taking the dash almost completely off and now going this way instead. Module is what is stopping everything now