A trick when removing push pins to avoid breaking or cracking them, use to go between the panel and vehicle, instead of under push pin. Then it pops free and also stays in place for easy replacement.

I think the flicker is from pulse width modulation power from the body control module. If you get a program like alfaobd you can change the headlight setting to Led

I was sold until seeing that the cover over the lamp would not fit. It sure seems like they would design something that actually was a direct fit without issues like covers not fitting.

Buddy removes the grill for “easy access” to the lower bolt then proceeds to use enough extensions that he wouldn’t have had to remove the grill. And yes the grill does not need to be taken off, it very easy to get the lower bolt with the 4 miles of extensions like buddy in the video. Also, the high beam bulbs aren’t clocked properly. The diodes are at 12 and 6 not the correct position of 9 and 3

I am really hoping you can tell me where to find a bigger size dust cap for the headlight I have been looking and looking please 🙏

You dont buy hemi for gas mileage. Great video bro. Thank you

I would have used GTR lighting ultra 2

Finally somone properly describing the h11 being low beam(running lights) and 9006 being high beams. Was getting alot of mixed information on that. Also any check light bulb notifications or flickering ?

I just purchased lows and hi's and led fogs plug and play was Ganna do h I d but there just not the same and use twice the volts and burn hotter save a lot of money and now I'm over convenience that I'm going to like them in my o1 Duramax lb7 then all lights on mother board later

Did the led board line up at 3 and 9?i have auxito adjustable h11's,but they are too bright for street use and i want to replace them

@TheWiscoGuyz Holy shit ur 9005 halogen bulb connector is aiming 9 o’clock. Putting on led will give u bad beam pattern and especially on high beams. Could u inspect again for ur 9005 high beams bulbs and see if u can mess around with that Philips screw, that’s blocked by the yellow O-ring. Loose that screw and see if u can rotate the orientation of the led bulbs? That one needs to face 3-9 o’clock as well for the best beam pattern as possible.

You don’t have to remove the grill to remove the headlights. And people please don’t install them headlights without dust caps.

How did you aim them down a little so you're not blinding drivers in front of you

Did you end up having to use resisters for your dad's truck, i have the same model.

You didn’t have to install the anti flickering harness?

Excelente

Does it make a difference if you order some leds with out the fans

Will they work on my 2010 ram big horn 1500

Looks like teeth that just got bleached