I'll add that these marks are for when the engine is cold. The fill level may go above the upper line and may go down to the lower line with heat expansion of the fluid and hoses when hot and be to spec.

That is well said!! They are the cold values for sure....... when I bought my Honda new in 2010 from the dealer, the coolant level was just barely above the "min" fill level line...... So when I change it, I just fill it back to that mark since that is how it was when I got it from the factory (for the most part).

What will happen if you over fill it?

@@kingOpooPee when you drive it there is a greater chance you will leak coolant out of the top of the reservoir, or have the lid start leaking of the bottle.

So what level should it be at should it be at the lower line or in between the full and lower line? Or somewhere else

Vent line , it’s fine

It’s supposed to get hot guy

They do run very hot. The good old days of the air cooled 200, 250 Big Red's etc. They would get so hot going into our huntin camp that they would burn rubber boots. And that is from the crankcase not exhaust. All Honda atc's, atv's air cooled and liquid run hotter then other manufacturers.

Good question. Honestly I'm not sure.... Try asking a local Honda dealer's service department.... just don't let them talk you into letting them service it!

When you unbolt the reservoir and dump the coolant, just make sure you swish around the distilled water a couple of time and then dump it out.... This should get rid of the dirt in the reservoir... I would think any dirt in the system isn't good for it.... try and get it as clean as possible....

Not sure.... I would imagine it is ok... but it doesn't hurt to ask around at local dealerships or repair shops

@@N224DW ok. I greatly appreciate you replying. You put me a little bit more at ease

I see that too... Engine Ice says once a year, up to 2 if used for racing, but that is too often in my opinion..... the maintenance schedule in the Honda Rancher manual says every 100 hrs or 600 miles, change the coolant. I dont use my Rancher all year long. It gets about 50 to 100 miles of use during the Fall hunting season (if even that)... Then I winterize the engine and it sits in the garage for 8 months of the year (unfortunately).... I likely will let this go for another year then see where I am with the mileage and engine time before I change it again. ...... If you use your Rancher more often, it never hurts to change any fluid early, but too early too often isn't necessary in my opinion. Engine Ice doesn't know all engine manufacturer's maintenance interval recommendations, so they probably take the "shortest time" recommendation to cover themselves ......

If you use regular tap water, its not good because most tap water has calcium in it. If you use tap water to flush, calcium deposits can form and clog and prevent the coolant from circulating through the engine... best to use distilled for a flush

Tap water or other water has calcium and other impurities that could build up and clog or affect the coolant system if used. Its best to use distilled water which doesn't have the impurities...... hopefully that helps...

I do it once every two years which if I remember right is what the maintenance schedule says

On tye other side of the engine

Yeah I ran the engine for about 10 minutes.... long enough to get the engine warm....if the fan comes on then is definitely long enough....

@@N224DW thanks. Is that a year round coolant? Or would using an "equivalent" green coolant be better for hot & cold temps? It get 100+ here in summer & as low as single digit temps in winter. I recently purchased a used 2013 Rancher & it has green coolant in it so im contemplating draining it & putting in the honda coolant. I have no idea what "green" coolant the previous owners put in there. Straight green or 50/50 green

@@shooter3288 I'm sure its good for year round use.... im in Texas where the climate is on the warmer side of the spectrum, even in the winter..... for a cold cold climate I'm sure it would work too......

Gotcha. Thanks

The "Engine Ice Hi - Performance Coolant" i used comes in a 1/2 gallon container and is premixed. I used it as is. I didn't add water or anything..... After filling the radiator then filling the reservoir to the min. level, I had maybe 4 oz. of coolant remaining....Hope this helps....

Doug W. Where did you get it from?

@@chrisj5.0 I bought the coolant at the local Honda Dealership, but i honestly can't remember what i paid. Dealership costs are usually higher.... After a quick search on the interweb I do see it is for sale on Amazon for about $20. Another good place to look is www.rockymountainatvmc.com... they have everything parts and fluids related for a Honda Rancher.......Hope that helps....

Just under 2 quarts.

Yeah, I added the remainder to the overflow reservoir after I made the video...right below the max line...

@@N224DW So you do fill it to the max line if the engine is warm?

@@damon323 if the engine is warm, I wouldn't go above the max line. The right way to add fluid is wait till the engine is cold and fill the resevoir until it is above the minimum, but not to exceed the max line.....

@@N224DW Thanks Doug, really appreciate the info and you posting the video man.