2010 Nissan QASHQAI front wheel bearing Replacement. #nissan #wheelbearing #howto
Пікірлер: 21
@anthonywilkins9201 Жыл бұрын
Best video yet on this going to do both fronts this weekend
@anthonywilkins9201 Жыл бұрын
Finally got round to doing mine this morning both fronts this video made it so easy for me to do mine. Thanks
@TEAMR4ULTV Жыл бұрын
Your welcome. Thanks for watching really appreciate it.
@giannisolla9049 Жыл бұрын
Thanks you much for explaining.. I did just like you did works fine ... abs problem solved 👍👍👍
@evieemaya886 ай бұрын
Great video as always, can I ask , what was the car doing to make you know it needed a wheel bearing?
@TEAMR4ULTV6 ай бұрын
Thanks for watching really appreciate it. When driving it was noisy like an airplane, like a grinding noise
@richardhunt304 Жыл бұрын
Entertaining video, but I would have put a new backplate and replaced the split pin with a new one-good engineering sense to me !!
@TEAMR4ULTV Жыл бұрын
Thanks for watching really appreciate it
@simonbone2 жыл бұрын
3:20 Aargh! That bolt just will not come off! Everything else until then was fine - and everything after is definitely doable. But the head of that 18-mm bolt will not budge. There's not enough room to get the needed leverage with the Qashqai jacked up on the drive.
@TEAMR4ULTV2 жыл бұрын
To do it on the floor is hard. Keep at it hopefully you'll do. Thanks for watching.
@simonbone2 жыл бұрын
@@TEAMR4ULTV I did it! But I left that bottom bolt on the wishbone in place (it wouldn't even shift with a strong arm) and took the two upper bolts off instead. And then everything went just as you had it here. Thanks!
@mzzj22 жыл бұрын
Even if you manage to turn the bolt it can still lock up with rust and refuse to come out. Penetrating oil and pneumatic hammer was my solution.
@kevinholland24702 жыл бұрын
no need to refit the back plate then ???
@TEAMR4ULTV2 жыл бұрын
Thanks for watching really appreciate it. The back plate was in such a bad state best just leave it off. Or get a new one but to be honest these back plate corrode and I end up ripping them off anyway.
@chriswoodgate55302 жыл бұрын
Where are you based and at what cost to replace the front pair of wheel bearings
@chriswoodgate55302 жыл бұрын
I have mobility problems and can’t get down to do it I need a hip replacement surgery but a surgeon will do that for me 😂
@TEAMR4ULTV2 жыл бұрын
Am based In Hyde Cheshire
@TEAMR4ULTV2 жыл бұрын
Price wise labour will be at least £80 a side
@chriswoodgate55302 жыл бұрын
Ok thanks for getting back to me I’m in Leicester so I’ll look more local thanks
@armbogota Жыл бұрын
You're real. It's a replacement for dummies. Go ahead