2011 Kawasaki Concours 14: Air Filter Removal

No video

2011 Kawasaki Concours 14: Air Filter Removal

Рет қаралды 15,285

Күн бұрын

Let's get to that air filter.
Ignore my excess wires - I installed dashcams
Tools I used:
Ryobi Impact Driver
Impact Adapter (3/8" Drive)
6" Extension (3/8" Drive)
10mm Socket (3/8" Drive)
5mm Hex (3/8" Drive)
4mm Hex (3/8" Drive)
Impact Adapter (1/4" Drive)
10" Extension (1/4" Drive)
8mm Socket (1/4" Drive)
3mm Allen
Fastener Removal Tool
Angled Scribe
**Disclaimer .aka Boring Legal Stuff**
The information provided in this video is for general informational purposes only. All information is provided in good faith, however I make no representation or warranty of any kind, express or implied, regarding the accuracy, adequacy, validity, reliability, availability or completeness of this information. It is your responsibility to review and adhere to the official documentation provided by the manufacturer prior to performing any maintenance. I assume no liability for property damage or injury incurred as a result of any of the information contained in this video. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user.

Пікірлер: 21

@PS-ef4yg 2 жыл бұрын

thanks for sharing... just did my 1st coolant flush, wow, all the fairings and plastic trim pieces on this ballistic missile... that said all the wind protection on the freeway especially on colder days is awesome...

@seatime674 Жыл бұрын

I have the '11 also and just did my first coolant flush.. Do you know if this particular bike pulls coolant from the recovery bottle if the radiators low to make sure it's always filled.?. Only because to take the radiator cap off to add coolant you have to take off the whole right side fairing to make sure it's full and that's a total pain in itself😢

@duckieduck3287 8 күн бұрын

I have the exact same bike, the screw for the little glove box on the left, the thing that you have to screw into keeps falling out of it. Below the adjustment for the heated grips.

@braker_ 3 ай бұрын

Спасибо дяденька

@brandynborsi4748 Жыл бұрын

It only took me 20 minutes and it was very easy. Great video thanks for the guide. I used your fuel pump video too! Great stuff🎉🎉🎉

@jimmcmaster6227 2 жыл бұрын

Look at how filthy that was. And you obviously do work on your bike. Imagine the ones that aren’t looked after?! People seem to forget that air is required for performance

@aaronis31337 2 жыл бұрын

Wow, what a pain! My next bike will be a Guzzi just to avoid all this.

@zellerized Ай бұрын

That's like buying a car because you like the dials. On most rockets you have to remove the gas tank to get to the air filter under it and the plugs are right there. You rather remove gas tanks or a piece of plastic???

@zellerized Ай бұрын

You can do the filter without removing the side fairing. I had the dealership/shop work on my bike after hitting a pothole at 80 on the highway and they had to replace the fairing and didnt do it correctly(not mating parts up and even leaving off connectors and pushpins), then they also tucked my idle adjuster inside instead of leaving out for use. Don't think that taking it to the dealer is better. The filter is not hard to do. If you ride this beast then you should be able to do it otherwise you might not have the mind you need to be on it.