Thank you very much for your outstanding instruction this is the first time ever I change the headlight of mi kia car. I recently separated I did not wanted to call my husband to help with your video that's all I needed. Thank you.. keep up with your good jjob..👍

FYI, I was able to change both low beam bulbs without removing the housing at all. Nevertheless, your video was extremely helpful in that it gave me the specific steps to do.....saved me a lot of time. Thanks.

Worked like a champ I installed 2 on my 2010 Kia Forte took about 5 minutes no one issue 4 bolts slid out slid in Thanks for the video

Thanks for the video. I wish I had watched this first instead of reading the KIA Owners Manual which incorrectly stated on page# 7-57 on Step#5 to "Disconnect the headlight bulb socket connector" prior to removing the bulb. When I tried to do that, I wound up breaking off part of the post that the wiring connector is mounted onto. Had to reattach with hot glue.

Straight to the point, informative and less than 5 mins. Subscribed ✅

Thank you! I was afraid to move the battery, so this was very appreciated. Took just a few minutes...and done! : )

SUPER helpful! This is way better than accessing through the back. Thanks!

I have found that the fastest and easiest way is to disconnect the wiring loom, remove the two bolts holding the lamp unit and gently pull out the lamp unit. It is much faster than removing the battery, fumbling around trying to correctly seat the bulb and you don't have to reset your radio etc

Thank you so much! Just what I needed! You explained it so well!

Very good edits. No boring monologue. Informative. Well done dude!

Thanks for the video, this was much simpler than the "remove the battery" method I saw suggested other places. Took 5 minutes

Thanks. This was easier than the manual would have put it and also I’m glad you called it a stupid design, because it is

yes.. you are a genius.. will be changing mine tomorrow..

This was very helpful! Thanks!

Thanks so much. Took all of 10 minutes.

This was awesome! Thank you so much 🙏🏽

Thanks, this was so helpful

Thank you so much for this video!!!!!

Thank you for the help!

Thanks brother!!!

Thank you. I have to change the right signal light.

Coming from a single mother, god bless you sir. Thank you

Hello i have a 2011 kia forte sx and planning to install a LED front turn signal but I don’t know which wire (color) should i connect the load resistor.

was able to remove bulb from the back with the help of some old pliers, without having to undo the assembly. Mine is a 2013 but appears exactly the same. Thanx for the vid

Thank you kind sir 🙌

Hey, thanx for the video. You mentioned that the new ones are brighter. What's the original temp?

Great job

Thank you!

Thanks!

So on mine, I put in some new LED bulbs and they fit correctly but for some reason the lights seem like their pointing down directly at the road I had LEDs in before this new set that DID NOT do that

HI, My friend. Can you help and show me how can replace whole headlight passenger side for Kia forte 2015. Thanks

bravo!!!!!!

Why are all fortes so loud ? Like the ticking noise mine sounds the same exact way

Good vid. Recommend not storing the bolts on the battery, I'd for sure knock them off and down into the engine.

Hi! Good video! What is the number of fog lights?

Wish someone would do this to a 2014 to 2018

Why can't I get the light out. It's too hard to turn :(

I used a pair of pliers to gently get the bulb to turn. It is righty tighty lefty loosy.

thanks for all your help made it easier to take the light off..thanks again

Thanks, saved me some struggle. I like that you made sure to edit in "stupid ass design" lol

You skipped the step on how to remove the wiring to the light blub directly, which is the part I'm stuck at.

is it me or am i having a hard time trying to find h11b i looked on Amazon cant find it to save my life

Can’t locate the inside clips…

Good video but and but again why aren't these videos showing the fact that u have to giggle the unit out..u should make a video to show the Tiny heachache involved..they just go fast and are like see its done. no its not u had to put your hand in the front and back to pull it out

Okay, so that video was pretty good. Okay, but I have one complaint. Okay, you really say 'okay' a lot. Okay, but thank you for the tips! Okay.

awesome video. the design is so stupid. i agree

I check out your video... dude, you do not have to unscrew any thing... when you take the cap off, if you turn the back part of the light hard enough, it will pop right out... it is a bit hard to turn but it can be done... and the clips that hold everything in place is hard as hell to get to let alone get loose... I found video to be not at all helpful

Why not just take the battery out?

KIA!!! 🤬 You intentionally placed a reservoir directly infront of the access to the headlight. Frankly, KIA's eye for detail is horrible.