In this video I'll be removing the front bumper of a 2012 Toyota Prius.
Пікірлер: 20
@west_park79937 ай бұрын
thanks a lot. these plastic clip-ons are terrible. i replaced most of them with 10 mm bolts
@abuabdulrahman31627 ай бұрын
Awesome 👍
@fehmiurrahman6827 Жыл бұрын
Can you make one video how I replace front fender Toyota Prius 2012
@j-flow617 Жыл бұрын
Once I get another Prius I’ll do one
@gwfowler Жыл бұрын
Thanks for the video. I seem to have also removed the radiator air shield. I can’t figure out how to put it back on. Any ideas? Thanks.
@krisyoung3656 Жыл бұрын
Nice video!
@j-flow617 Жыл бұрын
Thank you!
@dorito74802 жыл бұрын
Good Video 👍🏻 Thanks!
@j-flow6172 жыл бұрын
No problem, glad to help!
@muhammadadeel274511 ай бұрын
How can we change the front fog lights without removing the bumper?
@j-flow61711 ай бұрын
If you’re changing the bulb, try going through the bottom by removing the covers or unscrew the side of the bumper and go from there. If I remember the fog lights on this Prius had screws attaching it to the bumper. Just double check first
@dannyshi7136 Жыл бұрын
My grille in my Prius 2012 needs to be replaced. Is it possible to replace it without removing the bumper?
@j-flow617 Жыл бұрын
Give it a try. I won’t even waste my time without removing it. It’s possible but takes 5 times longer to do it and it’s a tight squeeze to get your hands in there.
@mandomoreno713411 ай бұрын
How much does the bumper weigh.
@j-flow61711 ай бұрын
It’s plastic, it doesn’t weight much at all
@mosaicchurchhalifax Жыл бұрын
What was the tool you used to remove the plastic clips?
@j-flow617 Жыл бұрын
Clip remover, they have a bunch of different ones but I like using this one here www.harborfreight.com/push-pin-pliers-63700.html?campaignid=12169518939&adsetid=114845748217&product=63700&store=3326&gclid=EAIaIQobChMI3qqvjt3g-gIV0xF9Ch36ugNIEAQYBiABEgL5vvD_BwE
@rohitbhatnagar7599 Жыл бұрын
My jack fell and broke my front. I think it is engine radiator is broken? Can you let me know what is broken, if you can tell by the video (it is upside down) - kzfaq.info/get/bejne/adeiqLqGs9bQcmQ.html
@j-flow617 Жыл бұрын
Looks like you put the jack on the radiator support and lifted the car 🫢 but the condenser looks crushed for sure but I’m not sure how far back you had the jack on the radiator support and the radiator could be crushed too. That’s the best I can see from the video my friend.
@rohitbhatnagar7599 Жыл бұрын
@@j-flow617 The condenser is in the front and radiator is right behind it - correct?