Wow great job! Never ever seen anyone give a tool break down. Big help for someone who has to buy the tools for the job

Always helpful when the tools are identified. It saves lots of time. Good camera shots. The original tensioner bolt did look like an allen head, but it might be confusing because you showed a torx tool. It would be also helpful as in another comment to give the torque requirements if you had them. Good job - thanks.

Awesome job bud!! Very informative!! Great job at explaining everything and why and how you did everything!! I feel like I could most definitely do this job on my own just by watching this video!!

Thank you much appreciation

I had nv200. Very tight spot, there is a hole on the right fender across the bolt pulley. I had to make it little bigger with a drill and stick the long t50 😂. Didn’t have time to take off all that stuff 😂😂

What are the part numbers you used?

شكرا جزيلا ممتاز

Hero

Great video How tight do you set the bolts.?

What are the torque specs, or where can I find them?